Perovskite solar cells (PSCs) have already achieved efficiencies of over 25%; however, their instability and degradation in the operational environment have prevented them from becoming commercially viable. Understanding the degradation mechanism, as well as improving the fabrication technique for achieving high-quality perovskite films, is crucial to overcoming these shortcomings. In this study, we investigated details in the changes of physical properties associated with the degradation and/or decomposition of perovskite films and solar cells using XRD, FESEM, EDX, UV-Vis, Hall-effect, and current-voltage (I-V) measurement techniques. The dissociation, as well as the intensity of perovskite peaks, have been observed as an impact of film degradation by humidity. The decomposition rate of perovskite film has been estimated from the structural and optical changes. The performance degradation of novel planner structure PSCs has been investigated in detail. The PSCs were fabricated in-room ambient using candle soot carbon and screen-printed Ag electrode. It was found that until the perovskite film decomposed by 30%, the film properties and cell efficiency remained stable.
Photovoltaics significantly contributes towards the emerging renewable energy drive. Amongst the available thin film solar cell technologies, presently CdTe is leading at commercial state. CdS is being widely used as window layer in CdTe solar cell but challenged with toxicity. Therefore, this project explores the feasibility of CdSe as alternative window layer in CdTe solar cell. The CdSe is optimized to determine the best complete CdTe based solar cell. The study also compares the device performance of proposed CdSe/CdTeSe/CdTe solar cell with other reported CdSe/CdTe and CdS/CdSe solar cells. While degerming the optimized thickness of CdTe solar cell with respect to different prospective window layer materials, the simulation results reveal that CdTe thickness can significantly reduce, at least by 500 nm, with only 1% reduction in PCE by replacing conventional CdS window layer with CdSe layer. Furthermore, while determining the appropriate Se composition on CdSexTe1-x as this layer forms between CdTe and CdSe layer during the fabrication, it has been found that 18% efficiency can be obtained in CdTe solar cell if the stoichiometry of CdSexTe1-x can be maintained as CdSe0.3Te0.7 during the device fabrication.
A successful integration of inorganic hole transporting material (HTM) for perovskite become one of the major concerns due to the instability issue with organic HTM. Inorganic NiO films as an efficient HTM for the inverted perovskite solar cell has been deposited by electron beam vapor deposition (EBPVD) technique instated of solution process. The X-Ray diffraction (XRD) peak of as-deposited substrate corresponding to (1 1 1) and (2 0 0) plane are dominating. The non-stoichiometry (1 1 1) in NiO thin film formation at influence its charge transfer characteristics. The FESEM confirms the successful non-stoichiometric deposition of NiO on FTO glass in an elemental wt% of O 2 (15.82) and Ni (23.62). The perovskite solar cells are fabricated in a device structure of Glass/TCO/NiO/Perovskite/PCBM/BCP/Ag. The deposited perovskite solar cells show higher power conversion efficiency (PCE) 10.80% with short circuit current density (Jsc) of 15.13 (mA cm −2 ), open circuit voltage (Voc) of 0.967 (V), field factor (FF) of 73.83 (%) which also allows thinking of an alternative HTL other than organic HTL for realistic commercial purpose.