This paper presents an investigation of the fuel- and energy-saving potential through the introduction of several hybrid electric propulsion (HEP) and more electric aircraft (MEA) systems on single aisle aircraft. More specifically, for an A320NEO the following main electric systems are considered: electric motors, batteries and power electronics for parallel HEP, electric components for replacement of the main pneumatic and hydraulic non-propulsive systems like environmental control system and actuators, and electric power transport and supply. The power sizing of the electric components, as well as their mass effects on overall aircraft mission performance are evaluated by system modelling of the aircraft, turbofan and the considered electric components. It is found for the considered aircraft and missions that the fuel saving potential of parallel HEP systems alone is very limited or absent. Typically the combination of HEP and MEA technologies shows potential for improved energy efficiency due to synergies of the involved systems and their operation.
Composite laminates are being increasingly used in a wide variety of industrial applications, but there are difficulties in applying these materials in ways that exploit their full potential, in particular under multi-axial loading. The objective of the present study is to determine by experiments the biaxial failure data for composite laminates produced by Fokker Aerostructures based on the thermoplastic UD carbon reinforced material AS4D/PEKK-FC. A test machine and accompanying cruciform specimens for in-plane biaxial failure tests have been developed. A coupon-level biaxial test program covering various biaxial load combinations in tension-tension, tension-compression and compression−compression has been successfully executed and biaxial failure values for the thermoplastic laminate have been determined. Besides, the experimental biaxial test program, also finite element models and analyses have been used to predict the global outcomes of the biaxial tests and to interpret the test results. Both plain (un-notched) and open-hole (notched) specimens of the thermoplastic laminate have been tested. The biaxial failure data have been collected and further processed in biaxial failure criteria. From the experiments, the failure strains, stresses and loads are determined and a failure envelope is created for both plain and open-hole specimens. Good agreement is found between the theoretically predicted envelopes and the test data. From the findings for biaxial failure criteria from this study, it is expected that structural weight saving can be achieved in the design of multi-axially loaded composite parts as compared to the design with the previous uni-axially based failure criteria.
Ambitious targets for the coming decades have been set for further reductions in aviation greenhouse gas emissions. Hybrid electric propulsion (HEP) concepts offer potential for the mitigation of these aviation emissions. To investigate this potential in an adequate level of detail, the European research project IMOTHEP (Investigation and Maturation of Technologies for Hybrid Electric Propulsion) explores key technologies for HEP in close relation with developments of aircraft missions and configuration. This paper presents conceptual-level design investigations on radical HEP aircraft configurations for short–medium-range (SMR) missions. In particular, a blended-wing-body (BWB) configuration with a turbo-electric powertrain and distributed electric propulsion is investigated using NLR’s aircraft evaluation tool MASS. For the aircraft and powertrain design, representative top-level aircraft requirements have been defined in IMOTHEP, and the reference aircraft for the assessment of potential benefits is based on the Airbus A320neo aircraft. The models and data developed in IMOTHEP and presented in this paper show that the turbo-electric BWB configuration has potential for reduced fuel consumption in comparison to the reference aircraft. But in comparison to advanced turbofan-powered BWB configurations, which have the same benefits of the BWB airframe and advanced technology assumptions, this potential is limited.
The development of new higher efficiency turbofan aero engines requires several design enhancements that typically result in shorter and slimmer nacelles. Consequently these engines provide less space for the engine systems installation and for maintenance accessibility. In the Novel Integration of Powerplant System Equipment project, optimisation methodologies are being investigated and developed for the integrated installation of equipment into the restricted volume of new architecture engines’ nacelles. The underlying optimisation methodology is built on a graph based approach involving efficient routing algorithms. Besides the methodology, also the software implementation and its application to engine equipment installation design cases are presented in this paper.