Wim Lammen

Mr. Wim Lammen

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 December 2019 in MATEC Web of Conferences
Verified
Journal Article
Open access
PDF file
JVJos Vankan
Jos Vankan
WLWim Lammen
Wim Lammen
This paper presents an investigation of the fuel- and energy-saving potential through the introduction of several hybrid electric propulsion (HEP) and more electric aircraft (MEA) systems on single aisle aircraft. More specifically, for an A320NEO the following main electric systems are considered: electric motors, batteries and power electronics for parallel HEP, electric components for replacement of the main pneumatic and hydraulic non-propulsive systems like environmental control system and actuators, and electric power transport and supply. The power sizing of the electric components, as well as their mass effects on overall aircraft mission performance are evaluated by system modelling of the aircraft, turbofan and the considered electric components. It is found for the considered aircraft and missions that the fuel saving potential of parallel HEP systems alone is very limited or absent. Typically the combination of HEP and MEA technologies shows potential for improved energy efficiency due to synergies of the involved systems and their operation.

17 June 2024 in Aerospace
Verified
Journal Article
Open access
PDF file
JVJos Vankan
Jos Vankan
WLWim Lammen
Wim Lammen
ESE. Scheers
E. Scheers
PDPieter-Jan Dewitte
Pieter-Jan Dewitte
SDSebastien Defoort
Sebastien Defoort
Ambitious targets for the coming decades have been set for further reductions in aviation greenhouse gas emissions. Hybrid electric propulsion (HEP) concepts offer potential for the mitigation of these aviation emissions. To investigate this potential in an adequate level of detail, the European research project IMOTHEP (Investigation and Maturation of Technologies for Hybrid Electric Propulsion) explores key technologies for HEP in close relation with developments of aircraft missions and configuration. This paper presents conceptual-level design investigations on radical HEP aircraft configurations for short–medium-range (SMR) missions. In particular, a blended-wing-body (BWB) configuration with a turbo-electric powertrain and distributed electric propulsion is investigated using NLR’s aircraft evaluation tool MASS. For the aircraft and powertrain design, representative top-level aircraft requirements have been defined in IMOTHEP, and the reference aircraft for the assessment of potential benefits is based on the Airbus A320neo aircraft. The models and data developed in IMOTHEP and presented in this paper show that the turbo-electric BWB configuration has potential for reduced fuel consumption in comparison to the reference aircraft. But in comparison to advanced turbofan-powered BWB configurations, which have the same benefits of the BWB airframe and advanced technology assumptions, this potential is limited.

20 January 2024 in Aerospace
Verified
Journal Article
Open access
PDF file
RRRui Roosien
Rui Roosien
MLM. N. A. Lim
M. N. A. Lim
SPS. M. Petermeijer
S. M. Petermeijer
WLWim Lammen
Wim Lammen
To reduce the carbon footprint of transport, policymakers are simultaneously stimulating cleaner vehicles and more sustainable mobility choices, such as a shift to rail for short-haul flights within Europe. The purpose of this study is to determine the climate impact of a journey within Europe by aircraft, train or passenger car, and to better understand what factors drive this impact in order to make smarter and more sustainable fact-based mobility choices. The study consists of a life cycle inventory (LCI) and life cycle impact assessment (LCA) of greenhouse gas emissions of specific vehicles in five case study travel scenarios in Europe. The energy and resulting direct emissions (including non-CO2) of the aircraft scenarios were calculated for the purpose of this study using the Mission Aircraft and Systems Simulation tool developed by the Royal Netherlands Aerospace Centre NLR. For other LCA phases and other modes of transport, the study relies on emission factors from public literature. A trip by train results in three to five times less emissions than a comparable trip by aircraft. In most scenarios, the passenger car with two people onboard emits significantly more than a train but slightly less than an aircraft. The study also shows what drives the climate impact of such a trip and how this is very different for different modes of transport. The study further highlights a lack of high-quality data, especially in the areas of indirect emissions and infrastructure, poor consistency among studies and a general under-documentation and lack of transparency regarding assumptions.

27 January 2025 in Aerospace
Verified
Journal Article
Open access
PDF file
WLWim Lammen
Wim Lammen
PDPieter-Jan Dewitte
Pieter-Jan Dewitte
ESElise Scheers
Elise Scheers
Retrofitting regional turboprop aircraft with hydrogen (H2)-electric powertrains, using fuel cell systems (FCSs), has gained interest in the last decade. This type of powertrain eliminates CO2, NOx, and fine particle emissions during flight, as FCSs only emit water. In this context, the “Hydrogen Aircraft Powertrain and Storage Systems” (HAPSS) project targets the development of a H2-electric propulsion system for retrofitting Dash 8-300 series aircraft. The purpose of the study described in this paper is to analyze the performance of the retrofitted H2-electric aircraft during critical operating conditions. Takeoff, as well as climb, cruise and go-around performances are addressed. The NLR in-house tool MASS (Mission, Aircraft and Systems Simulation) was used for the performance analyses. The results show that the retrofitted H2-electric aircraft has a slightly increased takeoff distance compared to the Dash 8-300 and it requires a maximum rated shaft power of 1.9 MW per propeller. A total rated FCS output power of 3.1 MW is sufficient to satisfy the takeoff requirements, at the cost of lower cruise altitude and reduced cruise speed as compared to the Dash 8-300. Furthermore, a higher-rated FCS is required to achieve the climb performance required for the typical climb profile of the Dash 8-300.

31 January 2020 in HAL
Verified
Preprint
Open access
PDF file
MZMengmeng Zhang
Mengmeng Zhang
NBNathalie Bartoli
Nathalie Bartoli
AJAidan Jungo
Aidan Jungo
WLWim Lammen
Wim Lammen
EBErik Baalbergen
Erik Baalbergen
MVMark Voskuijl
Mark Voskuijl
In the modern aircraft design process numerical simulation is one of the key enablers. However, computational time increases exponentially with the level of fidelity of the simulation. In the EU Horizon 2020 project AGILE different computation tools relative to different levels of fidelity are used. One of the challenges is to reduce the computational time - e.g. to facilitate an efficient optimization process - by processing the analysis data of various fidelity levels in a global surrogate model. This paper focuses on data fusion via an automatic iterative process embedded in the MDA chains as applied in AGILE. Surrogate modeling techniques are applied, taking into account the optimal sampling and the corresponding fidelities of the samples. This paper will detail the different steps of the proposed approach. As a test case handling qualities analysis of the AGILE reference conventional aircraft is performed, by fusing the computed aerodynamic coefficients and derivatives. A full spreadsheet of aerodynamic data computed either with different levels of fidelity or with only a low-fidelity tool has been derived and evaluated. By applying the data set with multiple levels of fidelity, the accuracy of the flight performance analysis was significantly improved especially for the transonic region in which the low fidelity aerodynamic method is not reliable. Moreover, the test case shows that by using a surrogate model based data fusion technique, the fidelity of the analysis data can be significantly improved with maximum RMSE less than 5% with minimum computation effort.

6 December 2024 in Preprints.org
Verified
Preprint
Open access
PDF file
WLWim Lammen
Wim Lammen
PDPieter-Jan Dewitte
Pieter-Jan Dewitte
ESElise Scheers
Elise Scheers
Retrofitting regional turboprop aircraft with hydrogen (H2)-electric powertrains, using fuel cell systems (FCS), has gained interest in the last decade. This type of powertrain eliminates CO2, NOx, and fine particle emissions during flight, as FCS only emit water. In this context, the "Hydrogen Aircraft Powertrain and Storage Solutions" (HAPSS) project targets the development of a H2-electric propulsion system for retrofitting Dash 8-300 series aircraft. The purpose of the study described in this paper is to analyze the performance of the retrofitted H2-electric aircraft during critical operating conditions. Takeoff as well as climb, cruise and go-around performances are addressed. The NLR in-house tool MASS (Mission, Aircraft and Systems Simulation) was used for the performance analyses. The results show that the retrofitted H2-electric aircraft has a slightly increased takeoff distance compared to the Dash 8-300 and it requires a maximum rated shaft power of 1.9 MW per propeller. A total rated FCS output power of 3.1 MW is sufficient to satisfy the takeoff requirements, at the cost of lower cruise altitude and reduced cruise speed as compared to the Dash 8-300. Furthermore, a higher rated FCS is required to achieve the climb performance required for the typical climb profile of the Dash 8-300.