Yue Yu

Prof. Yue Yu

The Institute of Technological Sciences,
+1
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 December 2020 in Crystals
Verified
Journal Article
Open access
PDF file
xia tangxia tang
xia tang
BLBotao Liu
Botao Liu
Yue YuYue Yu
Yue Yu
SLsheng liu
sheng liu
BGBing Gao
Bing Gao
The difficulties in growing large-size bulk β-Ga2O3 single crystals with the Czochralski method were numerically analyzed. The flow and temperature fields for crystals that were four and six inches in diameter were studied. When the crystal diameter is large and the crucible space becomes small, the flow field near the crystal edge becomes poorly controlled, which results in an unreasonable temperature field, which makes the interface velocity very sensitive to the phase boundary shape. The effect of seed rotation with increasing crystal diameter was also studied. With the increase in crystal diameter, the effect of seed rotation causes more uneven temperature distribution. The difficulty of growing large-size bulk β-Ga2O3 single crystals with the Czochralski method is caused by spiral growth. By using dynamic mesh technology to update the crystal growth interface, the calculation results show that the solid–liquid interface of the four-inch crystal is slightly convex and the center is slightly concave. With the increase of crystal growth time, the symmetry of cylindrical crystal will be broken, which will lead to spiral growth. The numerical results of the six-inch crystal show that the whole solid–liquid interface is concave and unstable, which is not conducive to crystal growth.

8 December 2021 in Materials
Verified
Journal Article
Open access
PDF file
BSBotao Song
Botao Song
BGBing Gao
Bing Gao
PHPengfei Han
Pengfei Han
Yue YuYue Yu
Yue Yu
xia tangxia tang
xia tang
Methyltrichlorosilane (CH3SiCl3, MTS) has good performance in stoichiometric silicon carbide (SiC) deposition and can be facilitated at relatively lower temperature. Simulations of the chemical vapor deposition in the two-dimensional horizontal hot-wall reactor for epitaxial processes of SiC, which were prepared from MTS-H2 gaseous system, were performed in this work by using the finite element method. The chemistry kinetic model of gas-phase reactions employed in this work was proposed by other researchers. The total gas flow rate, temperature, and ratio of MTS/H2 were the main process parameters in this work, and their effects on consumption rate of MTS, molar fraction of intermediate species and C/Si ratio inside the hot reaction chamber were analyzed in detail. The phenomena of our simulations are interesting. Both low total gas flow rate and high substrate temperature have obvious effectiveness on increasing the consumption rate of MTS. For all cases, the highest three C contained intermediates are CH4, C2H4 and C2H2, respectively, while the highest three Si/Cl contained intermediates are SiCl2, SiCl4 and HCl, respectively. Furthermore, low total gas flow results in a uniform C/Si ratio at different temperatures, and reducing the ratio of MTS/H2 is an interesting way to raise the C/Si ratio in the reactor.

25 May 2022 in Materials
Verified
Journal Article
Open access
PDF file
BSBotao Song
Botao Song
BGBing Gao
Bing Gao
PHPengfei Han
Pengfei Han
Yue YuYue Yu
Yue Yu
The chemical vapour deposition (CVD) technique could be used to fabricate a silicon carbide (SiC) epitaxial layer. Methyltrichlorosilane (CH3SiCl3, MTS) is widely used as a precursor for CVD of SiC with a wide range of allowable deposition temperatures. Typically, an appropriate model for the CVD process involves kinetic mechanisms of both gas-phase reactions and surface reactions. Here, we proposed the surface kinetic mechanisms of epitaxial SiC growth for MTS-H2 gaseous system where the MTS employed as the single precursor diluted in H2. The deposition face is assumed to be the Si face with a surface site terminated by an open site or H atom. The kinetic mechanisms for surface reactions proposed in this work for MTS-H2 gaseous system of epitaxial growth of SiC by CVD technique from mechanisms proposed for H-Si-C-Cl system are discussed in detail. Predicted components of surface species and growth rates at different mechanisms are discussed in detail.

29 June 2021 in Crystals
Verified
Journal Article
Open access
PDF file
xia tangxia tang
xia tang
BLBotao Liu
Botao Liu
Yue YuYue Yu
Yue Yu
BSBotao Song
Botao Song
PHPengfei Han
Pengfei Han
BGBing Gao
Bing Gao
As a crystal grows, the temperature distribution of the crystal and melt will change. It is necessary to study the dynamic process of single-crystal growth. Due to the relatively low crystallization rates used in the industrial Czochralski growth system, a steady state is used to compute the temperature distribution and melt flow. A two-dimensional axisymmetric model of the whole Czochralski furnace was established. The dynamic growth process of large-size bulk β-Ga2O3 single crystal using the Czochralski method has been numerically analyzed with the parameter sweep method. In this paper, two cases of internal radiation and no internal radiation were compared to study the effect of radiation on the process parameters. The temperature distribution of the furnace, the temperature field, and the flow field of the melt was calculated. The temperature, the temperature gradient of the crystal, the temperature at the bottom of the crucible, and the heater power were studied for the crystals grown in the two cases of radiation. The results obtained in this study clearly show that the loss calculated by including the internal radiation is higher compared to that including the surface radiation.

22 December 2021 in Materials
Verified
Journal Article
Open access
PDF file
Yue YuYue Yu
Yue Yu
BLBotao Liu
Botao Liu
xia tangxia tang
xia tang
BSBotao Song
Botao Song
PHPengfei Han
Pengfei Han
BGBing Gao
Bing Gao
The appropriate distribution of temperature in the growth system is critical for obtaining a large size high quality aluminum nitride (AlN) single crystal by the physical vapor transport (PVT) method. As the crystal size increases, the influence of the crucible on the temperature distribution inside the growth chamber becomes greater. In order to optimize the field of temperature and study the specific effects of various parts of the crucible on the large size AlN single crystal growth system, this study carried out a series of numerical simulations of the temperature field of two crucibles of different materials and put forward the concept of a composite crucible, which combines different materials in the crucible parts. Four composite crucible models were established with different proportions and positions of tantalum carbide (TaC) parts and graphite parts in the crucible. Calculations reveal that different parts of the crucible have different effects on the internal temperature distribution. The axial temperature gradient at the crystal was mainly governed by the crucible wall, whereas the temperature gradient was determined by the integrated effect of the crucible lid and the crucible wall in the radial direction. One type of composite crucible was chosen to minimize the thermal stress in grown AlN crystal, which is applicable to the growth of large sized AlN crystals in the future; it can also be used to grow AlN single crystals at present as well.

10 June 2022 in Materials
Verified
Journal Article
Open access
PDF file
PHPengfei Han
Pengfei Han
BGBing Gao
Bing Gao
BSBotao Song
Botao Song
Yue YuYue Yu
Yue Yu
xia tangxia tang
xia tang
BLBotao Liu
Botao Liu
The ammonothermal method is considered the most promising method of fabricating bulk gallium nitride (GaN) crystals. This paper improves the ammonothermal growth model by replacing the heater-long fixed temperature boundary with two resistance heaters and considering the real thermal boundary outside the shell. The relationship between power values and temperatures of dissolution and crystallization is expressed by the backpropagation (BP) neural network, and the optimal power values for specific systems are found using the non-dominated sorting genetic algorithm (NSGAII). Simulation results show that there are several discrepancies between updated and simplified models. It is necessary to build an ammonothermal system model with resistance heaters as a heat source. Then large-sized GaN crystal growth is analyzed based on the well-developed numerical model. According to the simulation results, both the increasing rate and maximum stable values of the metastable GaN concentration gradient are reduced for a larger-sized system, which is caused by the inhomogeneity of heat transfer in the autoclave.