Yao Li

Yao Li


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 September 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
SLShuqi Li
Shuqi Li
YLYunhu Liu
Yunhu Liu
HYHao Yuan
Hao Yuan
JLJianping Liang
Jianping Liang
MZMin Zhang
Min Zhang
Dezheng YangDezheng Yang
Dezheng Yang
In this paper, a high-density gas–liquid discharge plasma is obtained combined with nanosecond pulse voltage and a floating electrode. The discharge images, the waveforms of pulse voltage and discharge current, and the optical emission spectra are recorded. Gas temperature and electron density are calculated by the optical emission spectra of N2 (C3Πu → B3Πg) and the Stark broadening of Hα, respectively. The emission intensities of N2 (C3Πu → B3Πg), N2+ (B2Σ → X2Π), OH (A2Σ → X2Π), O (3p5P → 3s5S0), He (3d3D → 3p3P20), gas temperature, and electron density are acquired by optical emission spectra to discuss plasma characteristics varying with spatial distribution, discharge gap, and gas flow rate. The spatial distributions of discharge characteristics, including gas temperature, electron density, and emission intensities of N2 (C3Πu → B3Πg), N2+ (B2Σ → X2Π), OH (A2Σ → X2Π), O (3p5P → 3s5S0), and He (3d3D → 3p3P20), are presented. It is found that a high-density discharge plasma with the electron density of 2.2 × 1015 cm−3 and low gas temperature close to room temperature is generated. While setting the discharge gap distance at 10 mm, the discharge area over liquid surface has the largest diameter of 20 mm; under the same conditions, electron density is in the order of 1015 cm−3, and gas temperature is approximately 330 K. In addition, the discharge plasma characteristics are not kept consistent in the axial direction, in which the emission intensities of N2+ (B2Σ → X2Π), N2 (C3Πu → B3Πg), OH (A2Σ → X2Π), and gas temperature increased near the liquid surface. As the discharge gap is enlarged, the gas temperature increases, whereas the electron density remains almost constant. Moreover, as the gas flow rate was turned up, the electron density increased and the gas temperature was kept constant at 320 K.

2 November 2023 in Water
Verified
Journal Article
Open access
PDF file
ZZZhi Zheng
Zhi Zheng
DCDalei Chang
Dalei Chang
JLJianping Liang
Jianping Liang
KLKe Lu
Ke Lu
XCXiao Cui
Xiao Cui
Dezheng YangDezheng Yang
Dezheng Yang
Atmospheric pressure gas–liquid discharge plasma has garnered considerable attention for its efficacy in wastewater contaminant removal. This study utilized atmospheric oxygen gas–liquid discharge plasma for the treatment of ammonia nitrogen wastewater. The effect of applied voltage on the treatment of ammonia nitrogen wastewater by gas–liquid discharge plasma was discussed, and the potential reaction mechanism was elucidated. As the applied voltage increased from 9 kV to 17 kV, the ammonia nitrogen removal efficiency rose from 49.45% to 99.04%, with an N2 selectivity of 87.72%. The mechanism of ammonia nitrogen degradation by gas–liquid discharge plasma under different applied voltages was deduced through electrical characteristic analysis, emission spectrum diagnosis, and further measurement of the concentration of active species in the gas–liquid two-phase system. The degradation of ammonia nitrogen by gas–liquid discharge plasma primarily relies on the generation of active species in the liquid phase after plasma–gas interactions, rather than direct plasma effects. Increasing the applied voltage leads to changes in discharge morphology, higher energy input, elevated electron excitation temperatures, enhanced collisions, a decrease in plasma electron density, and an increase in rotational temperatures. The change in the plasma state enhances the gas–liquid transfer process and increases the concentration of H2O2, O3, and, ⋅OH in the liquid phase. Ultimately, the efficient removal of ammonia nitrogen from wastewater is achieved.

20 February 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
YLYao Li
Yao Li
QLQin Liang
Qin Liang
Dezheng YangDezheng Yang
Dezheng Yang
LZLi Zhang
Li Zhang
WWWenchun Wang
Wenchun Wang
In this paper, the packed bed dielectric barrier discharge (DBD) with needle-plate electrode configuration is presented to study the effects of electrical parameters, such as pulse duration and pulse rising and falling time, on discharge characteristics under air and nitrogen. The waveforms of the voltage and the discharge current, discharge evolution images, and the emission spectral of N2 (C3Пu → B3Пg) and N2+ (B2Σu+ → X2Σg+) are collected to investigate the discharge current, as well as the spatial distribution of the discharge modes and the reactive species in the packed bed reactor specifically. It is found that the pulse duration and pulse rising and falling time can regulate the discharge current. Firstly, increasing the pulse duration and the pulse rising and falling time can both increase the discharge duration. Secondly, the peak value of the discharge current has an obvious increasing trend with the pulse duration. Finally, the discharge start time can be delayed by increasing the pulse rising and falling time. A bright discharge channel is distributed at the top of the reactor, while the discharge is diffused at the bottom of the reactor. The generation of N2+ (B2Σu+) tends to depend on the existence of the streamer channel, and N2 (C3Пu) can be generated in the entire discharge area. In addition, the discharge operated in pure nitrogen can reach higher current values, a stronger discharge intensity, and longer existence time for the reactive species than in the air.

7 September 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
WSWenxiao Sun
Wenxiao Sun
QYQianqian Yu
Qianqian Yu
YLYao Li
Yao Li
HYHao Yuan
Hao Yuan
Dezheng YangDezheng Yang
Dezheng Yang
In this study, a single-outer-spiral electrode with inductance of 20 μH is employed to couple the energy input of a bipolar nanosecond pulse for the purpose of generating a large-scale atmospheric pressure plasma jet. When the spiral electrode is wrapped around a plasma jet tube with a length of 35 cm, the electrical field can be optimized, resulting in a stable laminar flow field, and a plasma jet with a length and diameter larger than 14 cm and 1.2 cm can be generated. A comparative study of the bipolar and unipolar pulse excitation voltages is also conducted, showing that the maximum lengths of the plasma jet excited by a bipolar pulse voltage, positive pulse voltage, and negative are 14 cm, 10 cm, and 7 cm, respectively. The temporal and spatially resolved spectra of the plasma jets excited by both bipolar and unipolar pulses are investigated, respectively, and the main physiochemical processes of the active species and the plasma dynamics’ evolution are discussed.