Atmospheric pressure gas–liquid discharge plasma has garnered considerable attention for its efficacy in wastewater contaminant removal. This study utilized atmospheric oxygen gas–liquid discharge plasma for the treatment of ammonia nitrogen wastewater. The effect of applied voltage on the treatment of ammonia nitrogen wastewater by gas–liquid discharge plasma was discussed, and the potential reaction mechanism was elucidated. As the applied voltage increased from 9 kV to 17 kV, the ammonia nitrogen removal efficiency rose from 49.45% to 99.04%, with an N2 selectivity of 87.72%. The mechanism of ammonia nitrogen degradation by gas–liquid discharge plasma under different applied voltages was deduced through electrical characteristic analysis, emission spectrum diagnosis, and further measurement of the concentration of active species in the gas–liquid two-phase system. The degradation of ammonia nitrogen by gas–liquid discharge plasma primarily relies on the generation of active species in the liquid phase after plasma–gas interactions, rather than direct plasma effects. Increasing the applied voltage leads to changes in discharge morphology, higher energy input, elevated electron excitation temperatures, enhanced collisions, a decrease in plasma electron density, and an increase in rotational temperatures. The change in the plasma state enhances the gas–liquid transfer process and increases the concentration of H2O2, O3, and, in the liquid phase. Ultimately, the efficient removal of ammonia nitrogen from wastewater is achieved.
In this paper, a uniform and stable dielectric barrier discharge plasma is presented for degradation of benzene combined with a transition metal oxide catalyst. The discharge images, waveforms of discharge current, and the optical emission spectra are measured to investigate the plasma characteristics. The effects of catalyst types, applied voltage, driving frequency, and initial VOCs concentration on the degradation efficiency of benzene are studied. It is found that the addition of the packed dielectric materials can effectively improve the uniformity of discharge and enhance the intensity of discharge, thus promoting the benzene degradation efficiency. At 22 kV, the degradation efficiencies of dielectric barrier discharge plasma packed with CuO, ZnO and Fe3O4 are 93.6%, 93.2% and 76.2%, respectively. When packing with ZnO, the degradation efficiency of the dielectric barrier discharge plasma is improved from 86.8% to 94.9%, as the applied voltage increases from 16 kV to 24 kV. The catalysts were characterized by XPS, XRD and SEM. The synergistic mechanism and the property of the catalyst are responsible for benzene degradation in the plasma–catalysis system. In addition, the main physiochemical processes and possible degradation mechanism of benzene are discussed.
In this study, coaxial dielectric barrier discharge (DBD) plasma, in conjunction with a metal oxide catalyst, was used to degrade naphthalene. The characteristics of plasma discharge were studied by measuring voltage and current waveforms and the Lissajous figure. The effects of different parameters of the process on naphthalene decomposition in air were investigated. XRD, BET, and SEM data were used to investigate the nature, specific surface area, and surface morphology of the catalyst. The results show that the mineralization of naphthalene reached 82.2% when the initial naphthalene concentration was 21 ppm and the total gas flow rate was 1 L/min in the DBD reactor filled with Al2O3. The mineralization of naphthalene first increased and then became stable with the increase in treatment time and discharge power. The TiO2 catalyst has more apparent advantages than the two other studied catalysts in terms of the removal efficiency and mineralization of naphthalene due to this catalyst’s large specific surface area, porous structure, and photocatalytic properties. In addition, the introduction of a small amount of water vapor can promote the mineralization and CO2 selectivity of naphthalene. With further increases in the water vapor, Fe2O3 has a negative effect on the naphthalene oxidation due to its small pore size. The TiO2 catalyst can overcome the adverse effects of water molecule attachment due to its photocatalytic properties.