This paper presents a performance of the open-graded asphalt concrete filled with a special cement grout in the road structures, introduces practical examples of the usage of this technology and defines the main properties. In addition, laboratory design of asphalt mixtures filled with special grout is researched. Finally, the results obtained from various laboratory tests are evaluated. The paper contains the open-graded asphalt concrete filled with a special cement grout mix design procedure and results of stiffness measurement, low temperature properties, permanent deformation and skid resistance. Open-graded asphalt concrete filled with a special cement grout mixture is compared to the commonly used asphalt mixes. The open-graded asphalt concrete filled with a special cement grout showed better results than the commonly used asphalt mixes by the stiffness and resistance to the permanent deformation characteristics but behavior at the low temperatures is slightly problematic.

In the European Union, more than 140 million tonnes of municipal solid waste is incinerated annually. It generates about 30–40 million tonnes of residues known as municipal solid waste incinerator bottom ash, which is typically landfilled. To deal with growing landfills, there is a need to utilize municipal solid waste incinerator bottom ash as a building material. It has been known that municipal solid waste incinerator bottom ash properties strongly depend on waste composition, which is directly influenced by people’s habits, economic policy, and technologies for metals recovery of bottom ash. Thus, municipal solid waste incinerator bottom ash produced in a specific country or region has primarily to be tested to determine its physical and mechanical properties. The main aim of this study is to determine municipal solid waste incinerator bottom ash physical and mechanical properties (aggregate particle size distribution, water content, oven-dried particle density, loose bulk density, Proctor density, optimal water content, California Bearing Ratio after and before soaking, permeability, Flakiness Index, Shape Index, percentage of crushed and broken surfaces, resistance to fragmentation (Los Angeles coefficient), water absorption and resistance to freezing and thawing). Municipal solid waste in-cinerator bottom ash produced in the waste-to-energy plant in Klaipėda (Lithuania) was used in this research. Ferrous and non-ferrous metals were separated after more than three months of municipal solid waste incinerator bottom ash ageing in the atmosphere. The study showed promising results from considering municipal solid waste incinerator bottom ash as possible aggregates for road building materials.

Low-noise pavements are used as an effective method of traffic noise mitigation. Low-noise pavements reduce the noise that arises due to interactions between tires and road surfaces (tire/road) via the implementation of three main components: low pavement roughness, negative pavement texture, and a high pavement air-void content. The tire/road noise reduction capabilities of the wearing layer vary depending on the aggregate type, gradation, bitumen and air-void content, and density. Consequently, the demand for an accurate tire/road noise prediction model has arisen from the design of asphalt mixtures. This paper deals with how asphalt mixture components of the wearing layer influence tire/pavement noise reduction and presents a model for tire/road noise level prediction based on the asphalt mixture composition. The paper demonstrates that the noise reduction level of low-noise asphalt pavements is dependent on the composition of the asphalt mixture. Asphalt wearing layer mixture composition parameters were tested in the laboratory from cores taken from 18 road sections, where acoustic properties were measured using a close-proximity (CPX) method. The proposed linear model is based on the bitumen amount, the air-void content of the mixture and aggregate shape and involves materials that comply with the general requirements for high-quality asphalt mixtures. The model allows for the prediction of the tire/road noise level at the asphalt mixture design stage using asphalt mixture components and volumetric properties. The proposed model is the first stage in the building of a complex model with a much wider range of low-noise asphalts components, pavement profile depth and CPX-value relationships.