Solar energy is being used for the purpose of water distillation since long. The present work demonstrates the comprehensive experimental investigation of various heat transfer enhancement arrangements on tubular solar still for its performance improvement. These arrangements include; case-1: Tubular solar still (TSS) with flat plate basin (TSS-FP), case-2: TSS with U-corrugated basin (TSS-UA), case-3: TSS with the coupled cylindrical parabolic collector (TSS-CPC). According to the available literature, the exergy and economical analysis of tubular solar stills are not explored much in the previous studies. Thus, a comparative thermo-economic analysis, exergy analysis and system productivity analysis have been carried out. In addition to this, the study investigates the effects of different basin water depths on system productivity. It has been found that the case-3: TSS-CPC gives the highest productivity; it was 37.75% and 80.63% higher as compared to the case-2 and case-1 respectively. Also, in the same arrangement, the enhancement in the exergy efficiency was around 48.6% and 85.2% as compared to case-2 and case-1 respectively. The per liter cost of water obtained by TSS-FP, TSS-UA, and TSS-CPC were about 0.00592, 0.00511, and 0.00567 US $/m2 respectively. The study concludes that the U-Corrugated basin surface, less basin water depth, and the secondary heating arrangement improve the productivity of the tubular still significantly.
26 July 2021 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
A simple solar water heater (SSWH) is technically promising, and cost-effective (installation cost and long-term operating cost wise) solar thermal system. This technology is now widely adopted by many countries for domestic and industrial purposes. Till now, various modifications have been carried out and adopted by the researchers to enhance performance of SSWH. These modifications are related to various components of SSWH such as design of flow directing inserts, design of concentrating arrangements, use of nanofluids, application of fins, vortex generators, etc. This research paper presents a systematic review of recent research & development pertaining SSWH components. Different enhancement techniques (component-wise) have been identified, explored, and eventually some recommendations have been presented.
24 September 2021 in International Journal of Energy and Environmental Engineering
Proper transportation of cuttings to the surface, prevention of various well-controlled issues, stability of wellbore, formation damage minimization, etc. are very important issues that depend crucially on properly designed and maintained rheology of the drilling fluids. Search and selection of suitable drilling fluid additives that can favorably alter its rheology has always been a challenge for oilwell drilling industries. On the other hand, disposal of fly ash, which is a waste of thermal power industries is a big time issue to resolve considering these two important aspects, i.e., drilling fluid rheology investigation as well as suitable disposal outlet of fly ash, the present analysis was aimed to investigate the effective application of fly-ash (a waste of thermal power plants) as possible favorable rheology altering additives of water-based drilling fluids for wellbore drilling industries. Various drilling fluid samples based on fly ash were prepared and experimentally tested for their yield stress and thixotropic behavior. Rotational rheometer MCR-102 (Make: Anton-Paar) was used for the rheological analysis. The investigation compared different drilling fluid combinations based on fly ash and oil additives. Various time-dependent rheological aspects, i.e., thixotropic characteristics like thixotropic area, loss modulus, and damping coefficient were experimentally explored. Additionally, yield shear stress values were investigated by controlled shear stress tests with MCR-102. At the outset, the comprehensive thixotropic analysis concluded that nearly 10% of the fly ash addition would optimally be beneficial to sustain the favorable yield-thixotropy to water-based drilling fluids. It was also concluded that fly ash addition did not affect the chemical reactivity of the drilling fluid. All the samples exhibited the desired shear thinning behavior. The damping factor was greater than unity which implied the dissipative nature of all the drilling fluid samples, however presence of oil in the sample reduced it.