Today, ship hull fouling is managed through fouling-control coatings, complemented with in-water cleaning. During cleaning, coating damage and wear must be avoided, for maximum coating lifetime and reduced antifoulant release. When possible, cleaning should target early stages of fouling, using minimal forces. However, such forces, and their effects on coatings, have not yet been fully quantified. In this one-year study, minimal cleaning forces were determined using a newly-designed immersed waterjet. The results show that bi-monthly/monthly cleaning, with maximum wall shear stress up to ∼1.3 kPa and jet stagnation pressure ∼0.17 MPa, did not appear to cause damage or wear on either the biocidal antifouling (AF) or the biocide-free foul-release (FR) coatings. The AF coating required bi-monthly cleanings to keep fouling to incipient slime (time-averaged results), while the FR coating had a similar fouling level even without cleaning. The reported forces may be used in matching cleaning parameters to the adhesion strength of the early stages of fouling.
Biofouling is detrimental to the hydrodynamic performance of ships. In spite of advances in hull coating technology, a ship must usually undergo underwater hull cleaning to remove biofouling during her in-service time. However, some cleaning practices may also lead to decreased lifetime of the fouling-control coating. Therefore, cleaning forces should be minimized, according to the adhesion strength of marine organisms present on the hull. In this article, values of adhesion strength found in available literature are discussed in the light of current knowledge on hull cleaning technology. Finally, the following knowledge gaps are identified: (1) data on adhesion strength of naturally-occurring biofouling communities are practically absent; (2) shear forces imparted by current cleaning devices on low-form fouling (microfouling) and corresponding effects on hull coatings are largely unknown. This knowledge would be valuable for both developers and users of cleaning technology.
1 February 2018 in International Journal of Heat and Mass Transfer
Hull biofouling is a well-known problem for the shipping industry, leading to increased resistance and fuel consumption. Considering that the effects of hull form on resistance are known to be higher for a less slender hull, it is hypothesised in this paper that the effect of biofouling roughness on resistance is also dependent on the hull form. To test this hypothesis, previously reported full-scale numerical results on a containership are re-analysed. Form effects on roughness penalties, corresponding to KΔCT = 0.058 ± 0.025, are observed at a low speed (19 knots, Res = 2.29 × 109), which are however cancelled out by traditionally neglected roughness effects on wave-making resistance at a higher speed (24 knots, Res = 2.89 × 109). It is concluded that hull form effects on biofouling penalties can be significant at low speeds, though not generalisable for higher speeds, namely when wave-making resistance corresponds to ≥ 29% of total resistance.