Mohammed Alaoui

Prof. Mohammed Alaoui


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 February 2022 in Fluids
Verified
Journal Article
Open access
PDF file
JBJamal Baliti
Jamal Baliti
YEYoussef Elguennouni
Youssef Elguennouni
MHMohamed Hssikou
Mohamed Hssikou
MAMohammed Alaoui
Mohammed Alaoui
The natural convection of incompressible flow confined within an enclosed right-angled triangular and isosceles cavity was investigated numerically using the multirelaxation time lattice Boltzmann method (MRT-LBM). According to the left and inclined walls thermal boundary conditions, two cases were considered in this study. In the first case, the inclined side of the enclosure was adiabatic, and the horizontal wall was heated, while the left one was kept at a cold temperature. However, the states of the left and inclined walls were interchanged in the second case. As the flow is only transported under the convection force, this study was carried out for the Rayleigh number ranging from Ra=103 to 106. The effects of the Rayleigh number on velocity and temperature profiles, streamlines, isotherms, and average Nusselt number were investigated. The position of cold and adiabatic walls had a great effect on the results. The results obtained are in good agreement with those of the literature and show the robustness of the MRT-LBM approach. In both cases, the heat-transfer rate increases with the increase in the Rayleigh number.

25 November 2020 in Modelling and Simulation in Engineering
Verified
Journal Article
Open access
PDF file
MHMohamed Hssikou
Mohamed Hssikou
YEYoussef Elguennouni
Youssef Elguennouni
JBJamal Baliti
Jamal Baliti
MAMohammed Alaoui
Mohammed Alaoui
Natural convection of gas flow (air) confined within an enclosed square-section cavity is investigated numerically using the lattice Boltzmann method (LBM). The right (left) side of the enclosure is partially heated (cooled) by a hot (cold) chip, while the left (right) one is completely kept at cold (hot) temperature. However, the horizontal walls and vertical parts near the chip are kept adiabatic. The buoyancy effect induced by the gravity acceleration, related to the convection force, is evaluated through the Rayleigh number in the range of 103-106 (laminar regime). The wall heating-ratio effect on the flow properties such as temperature and velocity profiles was examined. The heat transfer is analyzed through the Nusselt number for different chip lengths. Results show that the wall heat ratio has an interesting effect on the flow behavior. Results show good agreement with those of full natural convection in the literature, experimental, and simulation data.

19 March 2020 in Mathematical Problems in Engineering
Verified
Journal Article
Open access
PDF file
YEYoussef Elguennouni
Youssef Elguennouni
MHMohamed Hssikou
Mohamed Hssikou
JBJamal Baliti
Jamal Baliti
MAMohammed Alaoui
Mohammed Alaoui
In this paper, the Thermal Lattice Boltzmann Method (TLBM) is used for the simulation of a gas microflow. A 2D heated microchannel flow driven by a constant inlet velocity profile Uin and nonisothermal walls is investigated numerically. Two cases of micro-Poiseuille flow are considered in the present study. In the first case, the temperature of the walls is kept uniform, equal to zero; therefore, the gas is driven along the channel under the inlet parameters of velocity and temperature. However, in the second one, the gas flow is also induced by the effect of temperature decreasing applied on the walls. For consistent results, velocity slip and temperature jump boundary conditions are used to capture the nonequilibrium effects near the walls. The rarefaction effects described by the Knudsen number, on the velocity and temperature profiles are evaluated. The aim of this study is to prove the efficiency of the TLBM method to simulate Poiseuille flow in case of nonisothermal walls, based on the average value of the Nusselt number and by comparing the results obtained from the TLBM with those obtained using the Finite Difference Method (FDM). The results also show an interesting sensitivity of velocity and temperature profiles with the rarefaction degree and the imposed temperature gradient of the walls.

23 September 2018 in Heat Transfer
Verified
Journal Article
Closed access
PDF file
JBJamal Baliti
Jamal Baliti
MHMohamed Hssikou
Mohamed Hssikou
MAMohammed Alaoui
Mohammed Alaoui

14 December 2016 in Modelling and Simulation in Engineering
Verified
Journal Article
Open access
PDF file
MHMohamed Hssikou
Mohamed Hssikou
JBJamal Baliti
Jamal Baliti
MAMohammed Alaoui
Mohammed Alaoui
The behaviour of monatomic and dilute gas is studied in the slip and early transition regimes using the extended macroscopic theory. The gas is confined within a two-dimensional microcavity where the longitudinal sides are in the opposite motion with constant velocity ±Uw. The microcavity walls are kept at the uniform and reference temperature T0. Thus, the gas flow is transported only by the shear stress induced by the motion of upper and lower walls. From the macroscopic point of view, the regularized 13-moment equations of Grad, R13, are solved numerically. The macroscopic gas proprieties are studied for different values of the so-called Knudsen number (Kn), which gives the gas-rarefaction degree. The results are compared with those obtained using the classical continuum theory of Navier-Stokes and Fourier (NSF).

1 January 2019 in Mathematical Problems in Engineering
Verified
Journal Article
Open access
PDF file
MHMohamed Hssikou
Mohamed Hssikou
JBJamal Baliti
Jamal Baliti
MAMohammed Alaoui
Mohammed Alaoui
A Maxwell gas confined within a micro cavity with nonisothermal walls is investigated in the slip and early transition regimes using the classical and extended continuum theories. The vertical sides of the cavity are kept at the uniform and environmental temperature T0, while the upper and bottom ones are linearly heated in opposite directions from the cold value T0 to the hot one TH. The gas flow is, therefore, induced only by the temperature gradient created along the longitudinal walls. The problem is treated from a macroscopic point of view by solving numerically the so‐called regularized 13‐moment equations (R13) recently developed as an extension of Grad 13‐moment theory to the third order of the Knudsen number powers in the Chapman‐Enskog expansion. The gas macroscopic properties obtained by this method are compared with the classical continuum theory results (NSF) using the first and second order of velocity slip and temperature jump boundary conditions. The gas flow behavior is studied as a function of the Knudsen number (Kn), nonlinear effects, for different heating rates T0/TH. The micro cavity aspect ratio effect is also evaluated on the flow fields in this study.