Thermal energy storage (TES) is a key technology to enhance the efficiency of energy systems as well as to increase the share of renewable energies. In this context, the present paper reports a literature review of the recent advancement in the field of adsorption TES systems. After an initial introduction concerning different heat storage technologies, the working principle of the adsorption TES is explained and compared to other technologies. Subsequently, promising features and critical issues at a material, component and system level are deeply analyzed and the ongoing activities to make this technology ready for marketing are introduced.

The high environmental impact of conventional methods of cooling and heating increased the need for renewable energy deployment for covering thermal loads. Toward that direction, the proposed system aims at offering an efficient solar powered alternative, coupling a zeolite–water adsorption chiller with a conventional vapor compression cycle. The system is designed to operate under intermittent heat supply of low-temperature solar thermal energy (<90 °C) provided by evacuated tube collectors. A prototype was developed and tested in cooling mode operation. The results from the testing of separate components showed that the adsorption chiller was operating efficiently, achieving a maximum coefficient of performance (COP) of 0.65. With respect to the combined performance of the system, evaluated on a typical week of summer in Athens, the maximum reported COP was approximately 0.575, mainly due to the lower driving temperatures with a range of 75 °C. The corresponding mean energy efficiency ratio (EER) obtained was 5.8.

Adsorption heat transformation (AHT) is energy and environment saving technology that allows the effective utilization of renewable and waste heat with low-temperature potential. For the enhancement of AHT efficiency, properties of the working pair “adsorbent–adsorbate” have to be intelligently adapted to the operating conditions of the specific AHT cycle. In this work, the applicability of ATH technology in the Russian Federation (RF) was analyzed. For various geographic zones of the RF, the proper AHT application (cooling, heating, heat amplification, or storage) was selected depending on the zone climatic conditions. Data on the adsorption equilibrium for more than 40 “adsorbent–adsorbate” pairs collected from the literature were analyzed to select the most suitable pairs for the particular application/zone. Recommendations on AHT applications and the proper working pairs for the considered RF climatic zones are made.

This paper investigates the thermal performance of thermoacoustic heat exchangers subjected to acoustically oscillating flows. The analysis is carried out by experimental measurements of the heat fluxes sustained by the ambient heat exchanger of a prime mover of the standing wave type. A home-made parallel-plate heat exchanger is considered for the study. The gas-side convection heat transfer coefficients expressed as Nusselt numbers are determined over a wide range of velocity amplitudes of the oscillating flow. The experimental results are then compared to the predictions of a number of theoretical models currently applied in thermoacoustics such as the time-average steady-flow equivalent (TASFE) model, the root mean square Reynolds number (RMS-Re) model, and the boundary layer conduction model. The comparison suggests that the boundary layer model performs better than the rms-Re and TASFE models in predicting the heat transfer coefficients in oscillating flows. The relative difference between the model predictions and the experimental data amounts to 19%. A new correlation law, based on regression of the experimental data, is also proposed.