The Me1/AlN/Me2/(100) diamond structure has been theoretically analyzed and experimentally investigated in the range 0.5–10 GHz using high-overtone bulk acoustic resonators with different electrodes topologies based on the Al/AlN/Mo/(100) diamond structure. The maximum quality parameter Q × f ≈ 1014 Hz was obtained at f = 9.5 GHz. The layered structure has been analyzed using the developed HBAR software v. 2.3. It is demonstrated that the features in the frequency dependences of the parameters of such resonators are related to the behavior of a loaded thin-film piezoelectric transducer. The calculation results are in good agreement with the experiment. The frequency dependences of the equivalent parameters of the resonators have been calculated. It is shown that the synthetic type IIa diamond single crystal in combination with aluminum nitride is promising for implementation of high-Q acoustoelectronic microwave devices.
The paper demonstrates for the first time the possibility of using aluminum nitride–scandium as an effective piezoelectric material in composite acoustic resonators on synthetic diamond substrates....
We have implemented a 1D and 2D simulation of excitation and propagation of Lamb waves in Al/AlN/(100)-diamond and Al-IDT/AlN/(100)-diamond piezoelectric layered structures (the last in a SAW resonator configuration), respectively. The distribution of elastic displacements in Lamb waves of different orders has been calculated, the mode types have been identified, and the dispersion dependences of the phase velocities have been studied including the excitation at ultrahigh frequencies. The phase velocity values calculated using the 1D and 2D models are in good agreement with those determined experimentally. We have shown that, above a synchronism frequency of an IDT, resonances which occur in these structures, are determined by excitation of Lamb waves in a substrate. The quality factor of these resonances is extremely higher than that on surface acoustic waves. This is confirmed by the experimental data. The amplitude-frequency responses and frequency dependences of the quality factor calculated using the 2D model are in good agreement with the experiment.
The authors have carried out an experimental and theoretical study of the propagation of surface acoustic waves (SAW)—Rayleigh, Sezawa and SH-modes, as well as Lamb waves in Me-IDT/AlN/(100) diamond (Me = Pt, Al) piezoelectric layered structures with a SAW resonator configuration. The types of modes are identified and the dispersion curves of the phase velocities and electromechanical coupling coefficients for SAW and Lamb waves are obtained. The excitation of Lamb waves up to a frequency of 7.3 GHz was observed experimentally. The resonance curves for Lamb waves have a higher quality factor Q compared to surface acoustic waves propagating on the same substrates. At a frequency of about 7 GHz, the loaded Q-factor reaches 3400, while the quality parameter Q × f = 2.4 × 1013 Hz. An unusual effect of a significant increase in the Q-factor of Lamb waves with the frequency increasing from 760 at 1.5 GHz to 3400 at 7 GHz is noted.