18 March 2013 in Applied Physics Letters
First, the Al/AlN/Al/Cr/diamond single crystal piezoelectric layered structure has been developed, and its properties have been investigated up to 8 GHz. The peculiarities associated with the influence of piezoelectric film on the Q factor of high overtones of substrate have been pointed out. High Q ∼ 104 has been found at 6–7 GHz band.
1 December 1993 in Journal of Alloys and Compounds
22 February 2021 in Applied Physics Letters
We have obtained an excitation of longitudinal bulk acoustic waves in a diamond-based High overtone Bulk Acoustic Resonator (HBAR) at microwave and enhanced frequency bands as EHF up to 40 GHz. As an effective piezoelectric transducer, an aluminum-scandium nitride film is employed. The frequency response of acoustic overtones excited in the HBARs with a different aperture in the 1.0 up to 40 GHz range is measured. Some peculiarities of HBAR's frequency response concerned with the thin film piezoelectric transducer are studied. It is established that the maximal magnitude of the quality factor varies near the value of about 10 000 within all the frequency bands investigated. The approximately frequency-independent Q-factor behavior can explain in terms the Landau–Rumer approximation describing the acoustic attenuation in a diamond. An estimation of the HBAR's quality parameter as Q × f ≈ 4 × 1014 Hz at 40 GHz is obtained. In our opinion, that value exceeds all known data among the given devices. The results obtained will be helpful in the development of microwave and EHF acoustic resonators as well as highly sensitive acoustic sensors. The development of the EHF band opens up the possibility of obtaining acoustic waves of submicrometer and nanometer scales (in various media) and implementing acoustic studies of micro- and nanoobjects.
1 November 2021 in Acoustical Physics
We have implemented a 1D and 2D simulation of excitation and propagation of Lamb waves in Al/AlN/(100)-diamond and Al-IDT/AlN/(100)-diamond piezoelectric layered structures (the last in a SAW resonator configuration), respectively. The distribution of elastic displacements in Lamb waves of different orders has been calculated, the mode types have been identified, and the dispersion dependences of the phase velocities have been studied including the excitation at ultrahigh frequencies. The phase velocity values calculated using the 1D and 2D models are in good agreement with those determined experimentally. We have shown that, above a synchronism frequency of an IDT, resonances which occur in these structures, are determined by excitation of Lamb waves in a substrate. The quality factor of these resonances is extremely higher than that on surface acoustic waves. This is confirmed by the experimental data. The amplitude-frequency responses and frequency dependences of the quality factor calculated using the 2D model are in good agreement with the experiment.
1 January 2021 in Acoustical Physics
The authors have carried out an experimental and theoretical study of the propagation of surface acoustic waves (SAW)—Rayleigh, Sezawa and SH-modes, as well as Lamb waves in Me-IDT/AlN/(100) diamond (Me = Pt, Al) piezoelectric layered structures with a SAW resonator configuration. The types of modes are identified and the dispersion curves of the phase velocities and electromechanical coupling coefficients for SAW and Lamb waves are obtained. The excitation of Lamb waves up to a frequency of 7.3 GHz was observed experimentally. The resonance curves for Lamb waves have a higher quality factor Q compared to surface acoustic waves propagating on the same substrates. At a frequency of about 7 GHz, the loaded Q-factor reaches 3400, while the quality parameter Q × f = 2.4 × 1013 Hz. An unusual effect of a significant increase in the Q-factor of Lamb waves with the frequency increasing from 760 at 1.5 GHz to 3400 at 7 GHz is noted.
4 March 2024 in Applied Physics Letters
Synthetic nitrogen-doped diamond single crystals have various high-tech applications, but their electronic properties have not been sufficiently studied. In this research, we investigated temperature dependencies in the range T = (550–1143) K of the electrical resistivity and Hall mobility in synthetic single-crystal Ib-type diamonds doped with nitrogen during growth. A series of experimental samples were cut from diamond crystals grown by temperature gradient high-pressure high-temperature (TG-HPHT) and chemical vapor deposition (CVD) methods. They contain (0.085–6.5) × 1019 cm−3 single substitutional nitrogen atoms (C-centers) as measured by optical spectrometry methods. The Hall mobility of free electrons decreases from 600 to 150 cm2 V−1 s−1 in the CVD grown sample with the lowest N content and from 300 to 100 cm2 V−1 s−1 in highly doped HPHT grown samples in the temperature range of 550–900 K. At T = (900–1100) K, the mobility decreases to 50 cm2 V−1 s−1 in highly doped samples. The activation energies of electrical conductivity Ea and impurity-to-band energies of nitrogen donors ED decrease with increasing N concentration in the ranges (1.55–1.32) and (1.63–1.33) eV, respectively. The lowest compensation ratio k ∼ 1% in the moderately doped CVD diamond is unique for n-type diamonds. Typical values of k in highly N-doped crystals are in the range of 10%–20%, facilitating the use of N-doped diamonds in durable high-temperature electronic devices.