The use of pesticides in agriculture has ensured the production of different crops. However, pesticides have become an emerging public health problem for Latin American countries due to their excessive use, inadequate application, toxic characteristics, and minimal residue control. The current project evaluates the ability of two strains of algae (Chlorella and Scenedesmus sp.) and one cyanobacteria (Hapalosyphon sp.) to remove excess pesticides and other nutrients present in runoff water from rice production. Different concentrations of wastewater and carbon sources (Na2CO3 and NaHCO3) were evaluated. According to the results, all three strains can be grown in wastewater without dilution (100%), with a biomass concentration comparable to a synthetic medium. All three strains significantly reduced the concentration of NO3 and PO4 (95 and 85%, respectively), with no difference between Na2CO3 or NaHCO3. Finally, Chlorella sp. obtained the highest removal efficiency of the pesticide (Chlorpyrifos), followed by Scenedesmus and Hapalosyphon sp. (100, 75, and 50%, respectively). This work shows that it is possible to use this type of waste as an alternative source of nutrients to obtain biomass and metabolites of interest, such as lipids and carbohydrates, to produce biofuels.
This study evaluates the role of different LED lights (white, blue/red), intensity (µmol m−2 s−1), and photoperiod in the production of biomass and phycocyanin-C, allophycocyanin and phycoerythrin (C-PC, APC, and PE respectively) from a novel thermotolerant strain of Oscillatoria sp. Results show that a mixture of white with blue/red LEDs can effectively double the biomass concentration up to 1.3 g/L, while the concentration of the selected phycobiliproteins increased proportionally to biomass. Results also indicate that high light intensities (>120 µmol m−2 s−1) can diminish the final concentration of C-PC, APC, and PE, significantly reducing the overall biomass produced. Finally, the photoperiod analysis showed that longer light exposure times (18:6 h) improved both biomass and phycobiliproteins concentration. These results demonstrate that the application of LEDs to produce a novel strain of Oscillatoria sp can double the biomass concentration, and the photoperiod regulation can eventually enhance the final concentration of specific phycobiliproteins such as APC and PE.
Drying the biomass produced is one of the critical steps to avoid cell degradation; however, its high energy cost is a significant technological barrier to improving this type of bioprocess’s technical and economic feasibility. This work explores the impact of the biomass drying method of a strain of Potamosiphon sp. on the extraction efficiency of a phycoerythrin-rich protein extract. To achieve the above, the effect of time (12–24 h), temperature (40–70 °C), and drying method (convection oven and dehydrator) were determined using an I-best design with a response surface. According to the statistical results, the factors that most influence the extraction and purity of phycoerythrin are temperature and moisture removal by dehydration. The latter demonstrates that gentle drying of the biomass allows removing the most significant amount of moisture from the biomass without affecting the concentration or quality of temperature-sensitive proteins.
This study evaluated the role of C/N/P in the increase in the synthesis of carbohydrates, proteins, and lipids in two high-mountain strains of algae (Chlorella sp. UFPS019 and Desmodesmus sp. UFPS021). Three carbon sources (sodium acetate, sodium carbonate, and sodium bicarbonate), and the sources of nitrogen (NaNO3) and phosphate (KH2PO4 and K2HPO4) were analyzed using a surface response (3 factors, 2 levels). In Chlorella sp. UFPS019, the optimal conditions to enhance the synthesis of carbohydrates were high sodium carbonate content (3.53 g/L), high KH2PO4 and K2HPO4 content (0.06 and 0.14 g/L, respectively), and medium-high NaNO3 (0.1875 g/L). In the case of lipids, a high concentration of sodium acetate (1.19 g/L) coupled with high KH2PO4 and K2HPO4 content (0.056 and 0.131 g/L, respectively) and a low concentration of NaNO3 (0.075 g/L) drastically induced the synthesis of lipids. In the case of Desmodesmus sp. UFPS021, the protein content was increased using high sodium acetate (2 g/L), high KH2PO4 and K2HPO4 content (0.056 and 0.131 g/L, respectively), and high NaNO3 concentration (0.25 g/L). These results demonstrate that the correct adjustment of the C/N/P ratio can enhance the capacity of high-mountain strains of algae to produce high concentrations of carbohydrates, proteins, and lipids.
3 November 2021 in Journal of Water and Land Development
The production of biofuels using wastewater as a microalgae culture medium is a little explored technology, but with potential for success. In order to contribute to the knowledge of these technologies and their technical feasibility for microalgae growth, in this work the Chlorella sp. strain was cultivated in two types of effluents generated in an experimental farm located in eastern Colombia, before and after a biological treatment process. The consumption of the main nutrients that regulate growth and lipid production was evaluated, in order to extract, quantify, characterize and convert them into biodiesel. The results showed that Chlorella sp. growth and lipid production is more favourable in R2 medium of treated water than in R1 medium of raw water, mainly due to phosphorus limitation and higher N-NO3 concentration in R2 compared to R1. In the R2 medium culture, a percentage of 42.54% of long-chain fatty acids was found, which is necessary to obtain a high quality biodiesel. Finally, the best transesterification experiment allowed reaching a fatty acid methyl esters (FAME) percentage of 90.1 ± 2.7%. In general, the results demonstrated the potential viability of using the wastewater generated in the San Pablo farm to produce biomass with lipid content to obtain biodiesel, finding that where the concentration of nutrients, mainly nitrogen, has a great influence on the microalgal metabolism for lipid accumulation.
In this work, a UV/H2O2 system in real tannery wastewater was evaluated by an experimental design with optimal stage 2-level I-optimal reaction surface using Design Expert software to analyze the effects of temperature, pH, UV lamp power (W), and H2O2 concentration on COD removal and nitrification. It was found that pH and temperature were the variables that affected the process the most. It was found that an acidic pH of 4.5–5.5 and temperatures between 50 and 70 °C favored improved COD and ammonium oxidation. The process conditions—temperature 54.6 °C, pH 4, pW-UV 60 W and hydrogen peroxide 0.5—were confirmed in the next phase of the study using a one-way statistical analysis ANOVA. Under these conditions, the nitrite removal rate was 98.4%, ammonium 94.53%, chromium 92.3%, chlorides 62.4%, BOD 67.4%, COD 44.5%, and color 48%.