Qiang Li

Dr. Qiang Li

Xi’an University of Technology
+1
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 January 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
QLQiang Li
Qiang Li
YYYuan Yang
Yuan Yang
YWyang wen
yang wen
XTXue Tian
Xue Tian
YLYalan Li
Yalan Li
Wei XiangWei Xiang
Wei Xiang
This letter proposes a fast overcurrent protection integrated circuit (IC) for silicon carbide (SiC) mosfet based on current detection. With the proposed protection IC, the voltage between the Kelvin source and power source of SiC mosfet is sensed through an off-chip resistance. Thus, a detection voltage proportional to the drain current of SiC mosfet is obtained. Comparing the detection voltage to on-chip reference voltages, the proposed protection IC can provide both overload (OL) and short circuit (SC) protections for SiC mosfet . Moreover, a soft turn- off circuit is integrated into the protection IC. The proposed protection IC is implemented in a 0.5- $\mu$ m bipolar-CMOS-DMOS process and the die size is about 2 mm $^{2}$ . With the 1200 V/80 m $\Omega$ SiC mosfet , the proposed protection IC is verified on our test bench. With the proposed protection IC, the response time of the SC protection is 24 ns and the SC duration time of the SiC mosfet is 43 ns. Owing to the soft turn- off circuit of the protection IC, the drain voltage overshoot of the SiC mosfet is lower than 90 V during the OL and SC protections.

14 August 2024 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Open access
QLQiang Li
Qiang Li
YYYuan Yang
Yuan Yang
YWyang wen
yang wen
GZGuoliang Zhang
Guoliang Zhang
WXWenbin Xing
Wenbin Xing
Silicon carbide (SiC) MOSFET featuring faster switching speed, higher breakdown voltage, and excellent thermal conductivity is widely used in power converters to improve their conversion efficiency, power density, and reliability. However, high dv/dt and di/dt, along with parasitic capacitance and inductance, are more prone to overshoot and oscillation in both voltage and current, which can result in electrical stress, electromagnetic interference (EMI), and additional energy loss. This article proposes an active gate driver with the independent suppression of overshoot and oscillation (IS-AGD) to improve the switching performance of SiC MOSFET modules. Equivalent models for the overshoots and oscillations are built. Based on the models, the modulating strategy is presented and discussed. Finally, the proposed IS-AGD is experimentally verified with a 1.2 kV/120 A SiC MOSFET module under different gate resistances, load currents, and temperatures. The experimental results show that the proposed IS-AGD can reduce the overshoots and oscillations in voltage and current. Compared with the conventional gate driver (CGD), the switching loss and delay time are also decreased by the IS-AGD under different voltage and current overshoots. In addition, optimization considerations are discussed to guide practical applications.

24 February 2022 in Sensors
Verified
Journal Article
Open access
PDF file
QLQiang Li
Qiang Li
YYYuan Yang
Yuan Yang
HMHaohao Ma
Haohao Ma
YZYangle Zhou
Yangle Zhou
GYGuolong You
Guolong You
Wei XiangWei Xiang
Wei Xiang
This paper proposes a novel floating high-voltage level shifter (FHV-LS) with the pre-storage technique for high speed and low deviation in propagation delay. With this technology, the transmission paths from input to output are optimized, and thus the propagation delay of the proposed FHV-LS is reduced to as low as the sub-nanosecond scale. To further reduce the propagation delay, a pull-up network with regulated strength is introduced to reduce the fall time, which is a crucial part of the propagation delay. In addition, a pseudosymmetrical input pair is used to improve the symmetry of FHV-LS structurally to balance between the rising and falling propagation delays. Moreover, a start-up circuit is developed to initialize the output state of FHV-LS during the VDDH power up. The proposed FHV-LS is implemented using 0.3-µm HVCMOS technology. Post-layout simulation shows that the propagation delays and energy per transition of the proposed FHV-LS are 384 ps and 77.7 pJ @VH = 5 V, respectively. Finally, the 500-points Monte Carlo are performed to verify the performance and the stability.

29 October 2025 in Circuits, Systems, and Signal Processing
Verified
Journal Article
Closed access
PDF file
YYYuan Yang
Yuan Yang
YWYaxin Wang
Yaxin Wang
QLQiang Li
Qiang Li
WYWei Yang
Wei Yang
HMHaohao Ma
Haohao Ma
KJKai Jing
Kai Jing