yang wen

Prof. yang wen

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 October 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
YYYuan Yang
Yuan Yang
YWyang wen
yang wen
YGYong Gao
Yong Gao
Featuring higher switching speed and lower losses, the silicon carbide MOSFETs (SiC MOSFETs) are widely used in higher power density and higher efficiency power electronic applications as a new solution. However, the increase of the switching speed induces oscillations, overshoots, electromagnetic interference (EMI) and even additional losses. In this paper, a novel active gate driver (AGD) for high-power SiC MOSFETs is presented to fully utilize its potential of high-speed characteristic under different operation temperatures and load currents. The principle of the AGD is based on drive voltage decrement during the voltage and current slopes since high dV/dt and dI/dt are the source of the overshoots, oscillations and EMI problems. In addition, the optimal drive voltage switching delay time has been analyzed and calculated considering a tradeoff between switching losses and switching stresses. Compared to conventional gate driver (CGD) with fixed drive voltage, the proposed AGD has the capability of suppressing the overshoots, oscillations and reducing losses without compromising the EMI. Finally, the switching performance of the AGD was experimentally verified on 1.2 kV/300 A and 1.7 kV/300 A SiC MOSFETs in double pulse test. In addition, an EMI discussion and cost analysis were realized for AGD.

30 June 2020 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
YWyang wen
yang wen
YYYuan Yang
Yuan Yang
YGYong Gao
Yong Gao
Featuring higher switching speed and lower losses, the silicon carbide MOSFETs (SiC MOSFETs) are widely used in higher power density and higher efficiency power electronic applications as a new solution. Due to the limited current capability of single module, more modules parallel-connected are necessary in higher power application. However, current sharing is the key obstacle. In this paper, an active gate driver (AGD) for high-power SiC MOSFETs is presented to balance the currents of parallel-connected SiC MOSFET modules. The principle of the AGD is based on dynamic gate drive voltage adjustment to synchronize current edges and current slopes among parallel-connected SiC MOSFET modules automatically. Each AGD measures and controls the current of its SiC MOSFET module individually. No extra supervising control circuit is needed. In addition, the hardware and software configurations are independent of the system design and no restrictions on the number of SiC MOSFET modules connected in parallel exist. Finally, the switching performance of the AGD was experimentally verified on two parallel-connected SiC MOSFET modules in multi-pulse test under constant and variable load currents. In addition, the effectiveness of AGD under different control topologies has been studied with simulation and verified using three parallel-connected SiC MOSFET modules.

25 January 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
QLQiang Li
Qiang Li
YYYuan Yang
Yuan Yang
YWyang wen
yang wen
XTXue Tian
Xue Tian
YLYalan Li
Yalan Li
Wei XiangWei Xiang
Wei Xiang
This letter proposes a fast overcurrent protection integrated circuit (IC) for silicon carbide (SiC) mosfet based on current detection. With the proposed protection IC, the voltage between the Kelvin source and power source of SiC mosfet is sensed through an off-chip resistance. Thus, a detection voltage proportional to the drain current of SiC mosfet is obtained. Comparing the detection voltage to on-chip reference voltages, the proposed protection IC can provide both overload (OL) and short circuit (SC) protections for SiC mosfet . Moreover, a soft turn- off circuit is integrated into the protection IC. The proposed protection IC is implemented in a 0.5- $\mu$ m bipolar-CMOS-DMOS process and the die size is about 2 mm $^{2}$ . With the 1200 V/80 m $\Omega$ SiC mosfet , the proposed protection IC is verified on our test bench. With the proposed protection IC, the response time of the SC protection is 24 ns and the SC duration time of the SiC mosfet is 43 ns. Owing to the soft turn- off circuit of the protection IC, the drain voltage overshoot of the SiC mosfet is lower than 90 V during the OL and SC protections.

14 August 2024 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Open access
QLQiang Li
Qiang Li
YYYuan Yang
Yuan Yang
YWyang wen
yang wen
GZGuoliang Zhang
Guoliang Zhang
WXWenbin Xing
Wenbin Xing
Silicon carbide (SiC) MOSFET featuring faster switching speed, higher breakdown voltage, and excellent thermal conductivity is widely used in power converters to improve their conversion efficiency, power density, and reliability. However, high dv/dt and di/dt, along with parasitic capacitance and inductance, are more prone to overshoot and oscillation in both voltage and current, which can result in electrical stress, electromagnetic interference (EMI), and additional energy loss. This article proposes an active gate driver with the independent suppression of overshoot and oscillation (IS-AGD) to improve the switching performance of SiC MOSFET modules. Equivalent models for the overshoots and oscillations are built. Based on the models, the modulating strategy is presented and discussed. Finally, the proposed IS-AGD is experimentally verified with a 1.2 kV/120 A SiC MOSFET module under different gate resistances, load currents, and temperatures. The experimental results show that the proposed IS-AGD can reduce the overshoots and oscillations in voltage and current. Compared with the conventional gate driver (CGD), the switching loss and delay time are also decreased by the IS-AGD under different voltage and current overshoots. In addition, optimization considerations are discussed to guide practical applications.

10 March 2025 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
YWyang wen
yang wen
YYYuan Yang
Yuan Yang
YLYan Li
Yan Li
Featuring higher switching speed and lower losses, the silicon carbide (SiC) mosfets are widely used in high power density and higher efficiency power electronic applications as a new solution. However, the limited and temperature-dependent short-circuit (SC) capability is the key obstacles to its wide application. In this article, a novel short circuit protection (SCP) based on power evaluation method (PEM) considering operation temperature for SiC mosfet module is presented to address the aforementioned obstacles. The principle of the PEM is based on power evaluation of SiC mosfet and dynamically adjusting the protection threshold according to the operation temperature since overheating is the main cause of the device's SC failure. Finally, the performance of the PEM was experimentally verified on a 1.2 kV/120 A SiC mosfet in an SC test. The results show that the PEM features better response time and peak current performance both in hard switching fault and fault under load conditions compared to traditional desaturation and improved di/dt methods.

1 May 2018
Verified
Conference Paper
Closed access
YYYuan Yang
Yuan Yang
YWYan Wang
Yan Wang
YWyang wen
yang wen
An active gate driver (AGD) is presented in this work for Silicon Carbide (SiC) devices to fully utilize their potential of high-speed characteristic in higher power density and higher efficiency applications. It can actively adjust the drive voltage during the switching transient of SiC MOSFET and with simple circuit implementation. Compared to the conventional gate driver (CGD) with fixed drive voltage, the proposed method has the capability of increasing the switching speed while minimizing the switching stress. The operation principle of the proposed AGD and control concept are introduced in detail. Finally, based on 1200V/19A SiC MOSFETs from CREE, experimental verification is carried out in double pulse test to illustrate the proposed AGD and the obtained results indeed verify its superiority than the CGD.