This paper presents the analysis and design of an X-band reflectarray. The proposed antenna can be used for a medium Earth orbit (MEO) remote sensing satellite system in the 8.5 GHz band. To obtain a nearly constant response along the coverage area of this satellite system, the proposed antenna was designed with a flat-top radiation pattern with a beam width of around 29° for the required MEO system. In addition, broadside pencil beam and tilted pencil beam reflectarrays were also investigated. The feeding element of the proposed reflectarray antennas is a Yagi–Uda array. The amplitude and phase distribution of the fields due to the feeding element on the aperture of the reflectarray antenna are obtained directly by numerical simulation without introducing any approximation. The required phase distribution along the aperture of the reflectarray to obtain the required flat-top radiation pattern is obtained using the genetic algorithm (GA) optimization method. The reflecting elements of the reflectarray are composed of stacked circular patches. This stacked configuration was found to be appropriate for obtaining a wide range of reflection phase shift, which is required to implement the required phase distribution on the reflectarray aperture. The antenna was fabricated and measured for verification.
7 September 2023 in AEU - International Journal of Electronics and Communications
The reduction of radar cross-section (RCS) becomes an essential requirement for many military and civilian applications. One of the ways to achieve this is by using artificial magnetic conductors (AMCs) as electromagnetic surfaces. In this research, the reduction of the RCS is realized by adding a novel single layer AMC based metasurface unit cells that depend on polarization to cancel backscattering for Ka applications. The proposed AMC unit cell consists of a rectangular patch with open ended microstrip stubs. This unit cell exhibits a wide band phase difference about 180°±38° between the two reflected orthogonal field components in the frequency range from 27 to 56.5 GHz (about 71% relative bandwidth). Four AMC block arrays perpendicular to each other are combined in a chessboard configuration. To validate the capability of achieving a good RCS reduction, a substrate integrated wave guide (SIW) cavity-backed slot antenna is placed in the center of the AMC sheet. Simulation results show that the proposed AMC unit cell significantly reduces backscattered energy from 29.5 GHz to 50 GHz and from 28.5 GHz to 48.5 GHz in both y – and x –polarization, respectively, and covers a –10 dB backscattering reduction at antenna working band (32.2–34 GHz). The antenna’s bistatic performance at different frequencies is also presented. The fabricated design’s measurements and simulations match well, verifying and validating the proposed design.
11 June 2024 in Microwave and Optical Technology Letters
This paper presents the analysis and the design of a polarization detector for sub–6 GHz 5G applications. The proposed design operates in the frequency range from 2 to 4 GHz to cover the 5G NR frequency bands n40/n41/n78. The proposed polarization detector consists of a six-port network with two input and four output ports. The two input ports of this six-port network are connected to two identical orthogonal linearly polarized wideband antennas; vertical and horizontal. Two orthogonal tapered slot antennas are designed for this purpose. On the other hand, the other four outputs of the six-port network are connected to power amplitude detectors. These four power magnitudes are used to determine the ratio of the vertical to horizontal components of the field incident on the polarization detector. They are also used to determine the phase difference between the vertical and horizontal components. Based on the relative magnitude and the phase difference between the horizontal and vertical components of the incident field, the polarization parameters of the incident field are obtained; like the tilt angle, the axial ratio and the direction of rotation. To obtain the phase difference between the two inputs, a reference wideband differential phase shifter is included in the six-port network. This wideband differential phase shifter is implemented by using a modified Schiffman phase shifter. From the experimental results, the proposed polarization detector proved its reliability in detecting the polarization and discriminating the direction of the wave rotation; left or right hand rotation.