There are few data on patient satisfaction with surgery for the correction of neuromuscular scoliosis or on the correlation between patient satisfaction and the degree of curve correction achieved by surgery. Our aim was to determine the correlations between both patient satisfaction and perception of quality of life and the degree of curve correction. We interviewed 18 patients and administered a questionnaire that collected social and economic data and information about functional ability, comorbidities and satisfaction. Statistical analysis was performed using chi-square tests, Pearson correlation and paired t-tests. The mean correction achieved was 42.8%, i.e., 34.17 degrees. Early and late complication rates were low (11.1% each). Almost all of the patients (94.4%) were satisfied with the surgery, and expectations were met for 61.1% of them. Quality of life and aesthetics were improved in 83.4% and 94.4% of cases, respectively. No correlation was found between satisfaction and degree of correction. Our surgical results are similar to those of other studies with respect to the degree of correction and patient satisfaction. The disparity between satisfaction and fulfillment of expectations may be due to unrealistic initial expectations or misunderstanding of the objective of surgery. Our findings corroborate the hypothesis that satisfaction is multifactorial and not restricted to a quantitative goal. The satisfaction of patients who undergo operation for neuromuscular scoliosis does not depend directly on the degree of deformity correction. The relationship between satisfaction and the success of the correction procedure is complex and multifactorial.
Objective: Adolescent idiopathic scoliosis (AIS) is characterized by rotational and lateral deformity of the spine. The measurement of vertebral rotation is important for prognosis and treatment. Our objective was to evaluate whether the Nash-Moe method can be used to measure axial deformity correction with surgical treatment using the rod derotation maneuver at both the apex and extremities of the deformity in patients with AIS. Methods: Rotation was assessed using the Nash and Moe criteria, on preoperative and postoperative radiographs. We also evaluated the severity on the coronal plane using the Cobb method, ratio of correction achieved, screw density, and number of vertebrae involved in the instrumentation. Results: The Cobb method correction average was 54.8%. When we disregarded vertebrae that presented preoperative Nash-Moe grade 0, the average measurable correction was 54.5% in the first non-instrumented vertebra above, 69.2% in the first instrumented vertebra, 32.2% in the apical vertebra, 36.8% in the last instrumented vertebra, and 30% in the first non-instrumented vertebra below. In our study, 32.14% of the patients presented a measurable correction in the apical vertebra. Conclusion: On the axial plane, correction can be satisfactorily evaluated using the Nash-Moe method. Level of Evidence VI. Case Series.
The intrathecal route has not yet been thoroughly standardized and evaluated in an experimental model of spinal cord injury (SCI) in Wistar rats. The objective of this study was to standardize and evaluate the effect of intradural injection in this animal ...
Objective: Lumbosacral fixation presents problems in its arthrodesis, mainly due to pseudoarthrosis. Iliac screws minimize this problem, however, they show problems in the operative wound. The S2-Alar-iliac (S2AI) screw presents a lower rate of these complications. The anatomical differences between the populations and the sexes analyzed in the literature justify the study of the S2AI screw technique in Brazilian women. Methods: A total of 14 adult female CT scans were analyzed by 4 evaluators. Results: The mean bone length was 131.8 mm, the largest bone diameter was 22.6 mm, and the smallest bone diameter was 22.6 mm. Conclusions: The data presented are compatible with the literature and may assist spine surgeons in choosing the best implant and surgical technique. Level of Evidence I; Diagnostic Studies — Investigating a Diagnostic Test (anatomical investigation).
The halo ring can be applied in children, through skeletal traction or a halo vest device, to treat many cervical spine pathologies, including traumatic injuries and pathologies related to deformities. However, the procedure is associated with various complications, such as infection, pin loosening, and respiratory and neurological problems. Although widely studied in adults, the best pin insertion site in children and the correlations of pin insertion sites with outcomes and complications have not been completely elucidated. This study aimed to determine alternative pin placement sites based on a morphological analysis of the infant skull by computerized tomography (CT). An analytical-descriptive study was performed using 50 CT scans from children. The Wilcoxon and Friedman tests were used. A linear and directly proportional relation was found between cranial thickness and patient age. The average thicknesses of the anterior points across all ages analyzed ranged from 4.16 mm to 4.98 mm. The thicknesses of the posterior points varied from 3.94 mm to 4.27 mm. Within each age range, points 1 cm above the standard insertion sites had thicknesses similar to those of the standard sites, and points 2 cm above the standard insertion sites had thicknesses greater than those of the standard sites. The cranial thickness at all points increases linearly with age. Points 1 and 2 cm above the standard insertion sites are viable alternatives for the placement of halo pins. Preoperative CT can aid in choosing the best positioning sites for pins in the skull.