A high power and efficiency mid-infrared optical parametric oscillator based on a BaGa₄Se₇ crystal is demonstrated in this paper. It was pumped by a 500 Hz Q-switched Nd:YAG laser at room temperature. Without cooling, up to 0.76 W output power at 4.43 μm was generated with respect to the incident pump power (1064 nm) of 5.52 W, corresponding to an optical-to-optical conversion efficiency of 13.7%. The corresponding slope efficiency was as high as 18.7%. The pulse width of the signal wave was 5.2 ns at the pump pulse of 13.7 ns. To the best of our knowledge, this is to date the highest output power achieved at 4–5 μm from a 1064 nm pumped BGSe OPO laser. Considering that no additional cooling system was applied, this work provides a good solution for a high-efficient, compact or even portable mid-infrared solid-state laser device.

The process of casing the wellbore in oil and gas drilling consumes a significant amount of time and economic resources. High-energy laser rock fracturing, as an efficient and cost-effective new approach, holds the potential to create a glass-like casing by irradiating the rocks as an alternative to traditional casing. The mechanism behind the vitrification of rocks using laser irradiation, a key factor in achieving glassified casings, remains to be studied. This paper, based on experiments involving scanning sandstone with a line laser, investigates the mechanism of rock vitrification using numerical simulations and X-ray diffractometers. The results demonstrate that the sandstone surface is transformed into glass after laser scanning, with multiple scans and the application of high-speed airflow helping to reduce the formation of bubbles and other phenomena. Furthermore, the speed of laser scanning showed a negative correlation with the laser ablation depth, glass thickness, temperature diffusion rate, and temperature gradient. Based on these findings, a groundbreaking method is proposed for creating high-quality glass by moving the laser to scan the rocks multiple times, offering insights for research into laser-manufactured wellbore casings. Furthermore, this approach holds promising prospects for enhancing and embellishing the exterior of structures and for in situ environmental modifications on planetary surfaces and beyond.

The sealed neutron tube shell dissection process utilizing the traditional lathe turning method suffers from low efficiency and high cost due to the frequency of replacement of the diamond knife. In this study, a hybrid dissection method is introduced by combining the continuous-wave (CW) laser for efficient tangential groove production with an ultra-short pulse laser for delamination scanning removal. In this method, a high-power CW laser is firstly employed to make a tapered groove on the shell’s surface, and then a femtosecond pulse laser is used to micromachine the groove in order to obtain a cutting kerf. The thermal field was theoretically investigated in a finite element model. The simulation results show that the width of the area of temperature exceeding 100 °C is 1.9 mm and 0.4 mm with rotating speeds of 20 rad/s and 60 rad/s, respectively. In addition, a 2 mm deep slot in the 25 mm diameter tube was successfully produced in 1 min by a kilowatt fiber laser, and a 500-femtosecond pulse laser was employed to cut a plate with a material removal rate of 0.2 mm³/min. By using the hybrid method, the cutting efficiency was improved about 49 times compared to the femtosecond laser cutting. According to the simulation and experimental results, this method provides a high-efficiency and non-thermal cutting technique for reclaimed metallic neutron tube shells with millimeter-level thick walls, which has the advantages of non-contact, minimal thermal diffusion, and no effect of molten slag. It is indicated that the hybrid dissection method not only offers a new solution for thick neutron tube shell cutting but also extends the application of laser cutting techniques.