In this work, g-C3N4/TiO2 composites were fabricated through a hydrothermal method for the efficient photocatalytic degradation of imidacloprid (IMI) pesticide. The composites were fabricated at varying loading of sonochemically exfoliated g-C3N4 (denoted as CNS). Complementary characterization results indicate that the heterojunction between the CNS and TiO2 formed. Among the composites, the 0.5CNS/TiO2 material gave the highest photocatalytic activity (93% IMI removal efficiency) under UV-Vis light irradiation, which was 2.2 times over the pristine g-C3N4. The high photocatalytic activity of the g-C3N4/TiO2 composites could be ascribed to the band gap energy reduction and suppression of photo-induced charge carrier recombination on both TiO2 and CNS surfaces. In addition, it was found that the active species involved in the photodegradation process are OH• and holes, and a possible mechanism was proposed. The g-C3N4/TiO2 photocatalysts exhibited stable photocatalytic performance after regeneration, which shows that g-C3N4/TiO2 is a promising material for the photodegradation of imidacloprid pesticide in wastewater.
This research employed g-C3N4 nanosheets in the hydrothermal synthesis of TiO2/g-C3N4 hybrid photocatalysts. The TiO2/g-C3N4 heterojunctions, well-dispersed TiO2 nanoparticles on the g-C3N4 nanosheets, are effective photocatalysts for the degradation of monochlorophenols (MCPs: 2-CP, 3-CP, and 4-CP) which are prominent water contaminants. The removal efficiency of 2-CP and 4-CP reached 87% and 64%, respectively, after treatment of 25 ppm CP solutions with the photocatalyst (40TiO2/g-C3N4, 1 g/L) and irradiation with UV–Vis light. Treatment of CP solutions with g-C3N4 nanosheets or TiO2 alone in conjunction with irradiation gave removal efficiencies lower than 50%, which suggests the two act synergically to enhance the photocatalytic activity of the 40TiO2/g-C3N4 nanocomposite. Superoxide and hydroxyl radicals are key active species produced during CP photodegradation. In addition, the observed nitrogen and Ti3+ defects and oxygen vacancies in the TiO2/g-C3N4 nanocomposites may improve the light-harvesting ability of the composite and assist preventing rapid electron-hole recombination on the surface, enhancing the photocatalytic performance. In addition, interfacial interactions between the MCPs (low polarity) and thermally exfoliated carbon nitride in the TiO2/g-C3N4 nanocomposites may also enhance MCP degradation.
A new approach to recycling low-value eggshell food waste was to produce a CaFe2O4 semiconductor with a narrow band gap (Eg = 2.81 eV) via hydrothermal treatments of powdered eggshell suspended in aqueous ferric salt (Fe3+) solutions at varying Fe loadings.
Cu-HyS-urea and Cu-HyS-NaOH, which are hydrotalcite-like copper hydroxyl salts, were prepared by two different methods, urea hydrolysis and precipitation, respectively. Both synthesis methods provided the successful formation of a copper hydroxyl salt, Cu2(OH)3NO3. From XRD and UV-DRS results, the product from the urea hydrolysis methods (Cu-HyS-urea) displayed higher crystallinity, small bandgap energy (Eg), and high light absorption ability because of some intercalated carbonate anions. For the Cr(VI) removal test, the Cu-HyS-NaOH showed superior adsorption of Cr(VI) than Cu-HyS-urea due to a higher specific surface area, confirmed by BET analysis. However, the Cu-HyS-urea presented higher photocatalytic Cr(VI) reduction under light irradiation than Cu-HyS-NaOH, owing to narrow Eg, less recombination, and a high transfer of the photogenerated charge carriers, proven by the results from photoluminescence, photocurrent density, and electrochemical impedance spectroscopy. Thus, this work provides a new function of the hydrotalcite-like copper hydroxyl salts (Cu-HyS-urea and Cu-HyS-NaOH) that can be utilized not only for adsorption of Cr(VI) but also as photocatalysts for Cr(VI) reduction under light irradiation.