Time-domain back projection (BP) is a widely known method used in Synthetic Aperture Radar (SAR) image formation. Despite its advantages over other image formation algorithms, the BP method is hindered due to its computational complexity and its requirement of higher number of operations and processing power. Recently, Field Programmable Gate Array (FPGA) devices have been used for BP acceleration mainly due to their parallel processing capabilities, reconfigurability, scalability, and low power requirement. This paper presents a new Fixed-point based BP (FxBP) design for FPGA devices and a Floating-point based BP (FlBP) design to compare performance. Both designs are developed with N-Dimensional Range (NDR) structure and Single Work Item (SWI) structure using OpenCL. The FPGA performance is evaluated using a FPGA performance metric (FPM). It is shown that FxBP-NDR and FxBP-SWI designs generate high quality back projected images compared to FlBP designs, while saving 16.87% and 42.54% on logic resources and gaining 17.90% and 91.62% on FPGA performance in NDR and SWI, respectively. Obtained results clearly indicate that FPGA devices perform significantly better with FxBP designs compared to FlBP designs, even with hardened FPUs.
This study introduces electro-optical (EO) sensors (TurbNet sensors) that utilize a remote laser beacon (either coherent or incoherent) and an optical receiver with CCD camera and embedded edge AI computer (Jetson Xavier Nx) for in situ evaluation of the path-averaged atmospheric turbulence refractive index structure parameter at a high temporal rate. Evaluation of values was performed using deep neural network (DNN)-based real-time processing of short-exposure laser-beacon light intensity scintillation patterns (images) captured by a TurbNet sensor optical receiver. Several pre-trained DNN models were loaded onto the AI computer and used for TurbNet sensor performance evaluation in a set of atmospheric propagation inference trials under diverse turbulence and meteorological conditions. DNN model training, validation, and testing were performed using datasets comprised of a large number of instances of scintillation frames and corresponding reference (“true”) values that were measured side-by-side with a commercial scintillometer (BLS 2000). Generation of datasets and inference trials was performed at the University of Dayton’s (UD) 7-km atmospheric propagation test range. The results demonstrated a 70–90% correlation between values obtained with the TurbNet sensors and those measured side-by-side with the scintillometer.
In this paper, we present the results of an experimental analysis of atmospheric optical turbulence dynamics during the 2024 total solar eclipse (TSE). Changes in atmospheric optical turbulence strength throughout the entire TSE event were investigated by measuring the refractive index structure parameter (Cn2) and analyzing the corresponding short-exposure intensity scintillation patterns of a laser beam propagating over a 7 km near-ground atmospheric path. Data collection was conducted using a commercial large-aperture scintillometer and the recently developed AI-based TurbNet sensor, which enables high temporal resolution for Cn2 evaluation. The observed Cn2 parameter time evolution was characterized by the presence of dual turbulence quiescent (neutral stratification) phases and the generation of quasi-periodic oscillatory patterns during totality and for several minutes afterward.
Time-domain back projection (BP) is a widely known method used in Synthetic Aperture Radar (SAR) image formation. Despite its advantages over other image formation algorithms, the BP method is hindered due to its computational complexity and its requirement of higher number of operations and processing power. Recently, Field Programmable Gate Array (FPGA) devices have been used for BP acceleration mainly due to their parallel processing capabilities, reconfigurability, scalability, and low power requirement. This paper presents a new Fixed-point based BP (FxBP) design for FPGA devices and a Floating-point based BP (FlBP) design to compare performance. Both designs are developed with N-Dimensional Range (NDR) structure and Single Work Item (SWI) structure using OpenCL. The FPGA performance is evaluated using a FPGA performance metric (FPM). It is shown that FxBP-NDR and FxBP-SWI designs generate high quality back projected images compared to FlBP designs, while saving 16.87 % and 42.54 % on logic resources and gaining 17.90 % and 91.62 % on FPGA performance in NDR and SWI, respectively. Obtained results clearly indicate that FPGA devices perform significantly better with FxBP designs compared to FlBP designs, even with hardened FPUs.