With a high moisture content, fresh peppers are perishable and rot easily. Drying is essential for shelf-life extension. The natural thin wax layer on the pepper surface hinders moisture transfer. Traditionally, chemical dipping or mechanical pricking is used to remove this wax layer. However, in chemical dipping, chemical residues can trigger food-safety issues, while the low efficiency of mechanical pricking hinders its industrial application. Feasible pretreatment methods are advantageous for industrial use. Here, an emerging pretreatment technique (high-humidity hot-air impingement blanching, HHAIB) was used for peppers before drying and its effects on drying characteristics, microstructure, and polyphenol oxidase (PPO) activity were explored. The impact of drying temperature on color parameters and red pigment content of pulsed-vacuum-dried peppers was also evaluated. PPO activity was reduced to less than 20% after blanching at 110 °C for 60 s. HHAIB reduced drying time and PPO activity and promoted chemical-substance release. Effective water diffusivity was highest (5.01 × 10⁻¹⁰ m²/s) after blanching at 110 °C for 90 s, and the brightness value and red pigment content were highest (9.94 g/kg) at 70 °C. HHAIB and pulsed vacuum drying are promising pretreatment and drying methods for enhancing the drying rate and quality of red peppers.

Sea buckthorn berries are important ingredients in Chinese medicine and food processing; however, their high moisture content can reduce their shelf life. Effective drying is crucial for extending their shelf life. In the present study, we investigated the effects of hot-air drying (HAD), infrared drying (IRD), infrared-assisted hot-air drying (IR-HAD), pulsed-vacuum drying (PVD), and vacuum freeze-drying (VFD) on the drying kinetics, microstructure, physicochemical properties (color, non-enzyme browning index, and rehydration ratio), and total phenol, total flavonoid, and ascorbic acid contents of sea buckthorn berries. The results showed that the IR-HAD time was the shortest, followed by the HAD, IRD, and PVD times, whereas the VFD time was the longest. The value of the color parameter L* decreased from 53.44 in fresh sea buckthorn berries to 44.18 (VFD), 42.60 (PVD), 37.58 (IRD), 36.39 (HAD), and 36.00 (IR-HAD) in dried berries. The browning index also showed the same trend as the color change. Vacuum freeze-dried berries had the lowest browning index (0.24 Abs/g d.m.) followed by that of pulsed-vacuum–(0.28 Abs/g d.m.), infrared- (0.35 Abs/g d.m.), hot-air–(0.42 Abs/g d.m.), and infrared-assisted hot-air–dried berries (0.59 Abs/g d.m.). The ascorbic acid content of sea buckthorn berries decreased by 45.39, 53.81, 74.23, 77.09, and 79.93% after VFD, PVD, IRD, IR-HAD, and HAD, respectively. The vacuum freeze-dried and pulsed-vacuum–dried sea buckthorn berries had better physicochemical properties than those dried by HAD, IRD, and IR-HAD. Overall, VFD and PVD had the highest ascorbic acid and total phenolic contents, good rehydration ability, and bright color. Nonetheless, considering the high cost of VFD, we suggest that PVD is an optimal drying technology for sea buckthorn berries, with the potential for industrial application.

Large amounts of waste result from licorice mold rot; moreover, prompt drying directly influences product quality and value. This study compared various glycyrrhiza drying methods (Hot air drying (HAD), infrared combined hot air drying (IR-HAD), vacuum freeze drying (VFD), microwave vacuum drying (MVD), and vacuum pulsation drying (VPD)) that are used in the processing of traditional Chinese medicine. To investigate the effects of various drying methods on the drying characteristics and internal quality of licorice slices, their color, browning, total phenol, total flavonoid, and active components (liquiritin and glycyrrhizic acid) were chosen as qualitative and quantitative evaluation indices. Our results revealed that VFD had the longest drying time, but it could effectively maintain the contents of total phenol, total flavonoid, and liquiritin and glycyrrhizic acid. The results also showed that VFD samples had the best color and the lowest degree of browning, followed by HAD, IR-HAD, and VPD. We think that VFD is the best approach to ensure that licorice is dry.

Seabuckthorn berries are difficult to dry because the outermost surface is covered with a dense wax layer, which prevents moisture transfer during the drying process. In this study, uses of ultrasonic-assisted alkali (UA), pricking holes in the skin (PH) and their combination (UA + PH) as pretreatment methods prior to hot air drying and their effects on drying characteristics and quality attributes of seabuckthorn berries were investigated. Selected properties include color, microstructure, rehydration capacity, as well as total flavonoids, phenolics and ascorbic acid contents. Finally, the coefficient of variation method was used for comprehensive evaluation. The results showed that all pretreatment methods increased the drying rate; the combination of ultrasonic-assisted alkali (time, 15 min) and pricking holes (number, 6) (UA15 + PH6) had the highest drying rate that compared with the control group, the drying time was shortened by 33.05%; scanning electron microscopy images revealed that the pretreatment of UA could dissolve the wax layer of seabuckthorn berries, helped to form micropores, which promoted the process of water migration. All the pretreatments reduced the color difference and increased the lightness. The PH3 samples had the highest value of vitamin C content (54.71 mg/100 g), the UA5 and PH1 samples had the highest value of total flavonoid content (11.41 mg/g) and total phenolic content (14.20 mg/g), respectively. Compared to other pretreatment groups, UA15 + PH6 achieved the highest quality comprehensive score (1.013). Results indicate that UA15 + PH6 treatment is the most appropriate pretreatment method for improving the drying characteristics and quality attributes of seabuckthorn berries.

The effects of temperature, air velocity, and infrared radiation distances on the drying characteristics and quality of apple slices were investigated using infrared-assisted-hot air drying (IRAHAD). Drying temperature and air velocity had remarkable effects on the drying kinetics, color, total phenol content, total flavonoid content, and vitamin C content (VCC) of apple slices. Infrared radiation distance demonstrated similar results, other than for VCC and color. The shortest drying time was obtained at 70 °C, air velocity of 3 m/s and infrared radiation distance of 10 cm. A deep neural network (DNN) was developed, based on 4526 groups of apple slice drying data, and was applied to predict changes in moisture ratio (MR) and dry basis moisture content (DBMC) of apple slices during drying. DNN predicted that the coefficient of determination (R²) was 0.9975 and 1.0000, and the mean absolute error (MAE) was 0.001100 and 0.000127, for MR and DBMC, respectively. Furthermore, DNN obtained the highest R² and lowest MAE values when compared with multilayer perceptron (MLP) and support vector regression (SVR). Therefore, DNN can provide new ideas for the rapid detection of apple moisture and guide apple processing in order to improve quality and intelligent control in the drying process.

Single or combined heat pump technologies are generally used to dry fruits and vegetables, with combined heat pump technologies offering superior performance. This review summarizes the applications of single and combined heat pump drying technologies for fruits and vegetables in China and globally, discusses their current advantages and disadvantages, and outlines future development directions for heat pump-based drying methods. Future research should focus on improving combined heat pump technologies and enhancing the performance of single heat pump drying systems to enhance the effectiveness and feasibility of these technologies for drying fruits and vegetables. Improved technologies would also help meet the increasing demand for high-quality food and social development. Moreover, changes in the mechanisms of key indicators, such as mechanical and thermodynamic properties, should be continuously monitored while drying various fruits and vegetables. Future research into combined heat pump technologies should focus on determining the conversion methods between pairs of drying technologies and identifying the most effective drying technology combinations. Future research into single heat pump technologies should focus on improving the performance levels of core components, such as compressors and drying media.