This study illustrates the impact of single discrete arc-shaped ribs (SDASR)-type artificial roughness on the performance of a jet impingement solar thermal collector (JISTC). The impact of parametric variations of SDASR on the Nusselt number , friction factor , and thermohydraulic performance is examined. The spacer length () of the SDASR was changed from 0 mm to 300 mm in stages of 100 mm during the experiment. The fixed parameters of the SDASR were a relative discrete distance of 0.67, relative discrete width of 0.87, relative rib height of 0.047, relative rib pitch of 1.7, angle of an arc of 60°, jet diameter ratio of 0.065, streamwise pitch ratio of 1.72, and spanwise pitch ratio of 0.82. The Reynolds number was altered from 3000 to 19,000. The and of a JISTC with a roughened absorber plate was found to be enhanced by 5.25 and 5.98 times as compared to an STC without artificial roughness. The optimal findings of , and were achieved at = 0 mm. The maximum value of the obtained at = 0 mm was 2.9.
1 October 2021 in Sustainable Energy Technologies and Assessments
Influence of wind speed, mass-flow rate of water, irradiance, and ambient temperature on concentrated photovoltaic thermal module (PVT) equipped with linear Fresnel lens as primary optic element and convex lens as secondary optic element have been investigated in this study. Influence of these parameters on module performance in terms of thermal efficiency and electrical efficiency are also examined during investigation. The thermal efficiency and electrical efficiency without consideration of parameters was found to be 14.3% and 51.2%, respectively. With consideration of mentioned four parameters, the results reveal that electrical efficiency of 17.2% and thermal efficiency of 55.3% can be achieved for designed set-up. Thus, there is 20% and 8% increase in electrical efficiency and thermal efficiency, respectively. The electrical efficiency increases with increase in flluid-flow rate, wind speed, and irradiance. Electrical efficiency de-creases with increase in ambient temperature. The thermal efficiency increases with increment in water mass-flow rate, irradiance, and ambient temperature. However, with increase in wind speed, the thermal efficiency decreases.
The current examination used a multi-criteria decision-making (MCDM) approach to optimize the roughness parameters of S-shaped ribs (SSRs) in a solar thermal collector (STC) duct using air as the working fluid. Different SSRs were tested to identify the combination of parameters resulting in the best performance. Geometrical parameters such as relative roughness pitch () varied from 4 to 12, relative roughness height () from 0.022 to 0.054, arc angle () from 30° to 75°, and relative roughness width () from 1 to 4. The Nusselt number () and friction factor (), findings which impact the STC performance, rely on SSRs. The performance measurements show that no combination of SSR parameters lead to the best enhancement heat transfer rate at low enhancement in the friction. So, a hybrid multi-criteria decision-making strategy using the Analytical Hierarchy Process (AHP) for criterion significance and Multi Attributive Border Approximation Area Comparison (MABAC) for alternative ranking was used to determine which combination of geometrical parameters will result in the optimum performance of a roughened STC. This work employs a hybrid MCDM technique to optimise the effectiveness of an STC roughened with SSRs. To optimize the SSR design parameters, this study used the hybrid AHP-MABAC technique for analytical assessment of a roughened STC. The optimization results showed that the STC roughened with SSRs achieved the optimum performance at = 8, = 0.043, = 60° and = 3.