This communication deals with the new design of a printed dual-band quasi-Yagi antenna with an ends-fed dipole-like driver. In contrast to conventional quasi-Yagi antenna design, the proposed antenna has an additional degree of freedom. Its architecture allows the use of any out-of-phase power divider which plays the role of a balun. A printed circuit board prototype was simulated through the full-wave solver “CST Studio” Suite and successfully implemented. The measured results confirm the proposed approach. In particular, the reflection coefficient of the antenna is equal (-18) dB or less at both the central frequencies of the section working bands. The measured maximum cross-polarization intensities of the radiation in upper hemisphere were found less than (-18) dB in both the principal cuts.
7 July 2015 in Journal of Electromagnetic Waves and Applications
The modified waveguide-fed dipole-like antenna is designed using the induced emf method. To excite the antenna arms, the two equal in magnitude and 180° and out-of-phase excitations are created using the standard rectangular waveguide. Since the area around the radiating arms is free of any conductors (exception for a finite ground plane), the antenna radiation is of high polarization purity. The stand-alone antenna operating near 1.7 GHz was fabricated and tested to verify the design validity. Both the far-field pattern and the return loss level show good agreement with the designed parameters. Such antenna is optimal for using as a building block in the linearly polarized assemblies as well as the stand-alone radiators.
The novel microwave quasi-elliptic bandstop filter, which uses the initially uncoupled strip transmission lines, is considered in this work. The proposed filter is based on the reentrant structure, where the metallic body with a floating potential is asymmetric. Generally speaking, the internal and external dielectric fillings must have their unequal relative permittivities. As a result, additional symmetrical reflection zeros are reached at the lower and upper pass bands of the stop band leading to the quasi-elliptic function response that improves the filter selectivity. The general transverse electromagnetic (TEM) circuit model for the proposed filter in terms of a series connection of the multi-ports is presented and then used to predict the initial electrical and geometrical parameters. An experimental printed circuit prototype has been manufactured and evaluated to validate the design concept. The measured filter parameters correlate well with the simulation-derived ones and that increases the degree of freedom in the fabrication of microwave frequency selective components.
1 June 2017 in Radiophysics and Quantum Electronics