SITARAM DASH

Prof. Dr. SITARAM DASH


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 January 2022 in Nanomaterials
Verified
Journal Article
Open access
PDF file
RENU SHASTRIRENU SHASTRI
RENU SHASTRI
CMChinmaya Prasad Mohanty
Chinmaya Prasad Mohanty
SDSITARAM DASH
SITARAM DASH
KGKARTHICK M P G
KARTHICK M P G
Raja Annamalai ARaja Annamalai A
Raja Annamalai A
Chun-Ping JenChun-Ping Jen
Chun-Ping Jen
The most well-known and widely used non-traditional manufacturing method is electrical discharge machining (EDM). It is well-known for its ability to cut rigid materials and high-temperature alloys that are difficult to machine with traditional methods. The significant challenges encountered in EDM are high tool wear rate, low material removal rate, and high surface roughness caused by the continuous electric spark generated between the tool and the workpiece. Researchers have reported using a variety of approaches to overcome this challenge, such as combining the die-sinking EDM process with cryogenic treatment, cryogenic cooling, powder-mixed processing, ultrasonic assistance, and other methods. This paper examines the results of these association techniques on various performance measures, such as material removal rate (MRR), tool wear rate (TWR), surface roughness, surface integrity, and recast layer formed during machining, and identifies potential gap areas and proposes a solution. The manuscript is useful for improving performance and introducing new resolutions to the field of EDM machining.

24 May 2023 in Journal of Materials Engineering and Performance
Verified
Journal Article
Closed access
PDF file
SASayan Atta
Sayan Atta
UNU. NarendraKumar
U. NarendraKumar
KKK. V. A. N. P. S. Kumar
K. V. A. N. P. S. Kumar
DYD. P. Yadav
D. P. Yadav
SDSITARAM DASH
SITARAM DASH

1 January 2023 in AIP Conference Proceedings
Verified
Conference Paper
Open access
PDF file
SPSoumen Pal
Soumen Pal
RMRochak Malhotra
Rochak Malhotra
OMOm Adikrao More
Om Adikrao More
VSVinod Kumar Sharma
Vinod Kumar Sharma
SDSITARAM DASH
SITARAM DASH
Design, development and fabrication of an unmanned aerial vehicle (UAV) otherwise known in practice as drone is described. The special configuration involves an I-shaped design with propellers fixed onto either side of the chassis. This design accounts for thermal stability encountered by UAVs during flight. The scheme involving this UAV model provides an effective solution for higher thrust generation than the conventional options currently available. As a part of the process covering detail design, a software-based analysis to act as validation for the model was carried out. A significant finding of the model refers to vastly enhanced hover stability across line-of-sight heights. One of the specific outcomes of the model pertains to its capability for solving problems related to narrow range of manoeuvrability. This is achieved owing to its narrow framework-based architecture. It is also being reported that installation of fins on the electronic speed controller (ESC) leads to temperature reduction of approximately 50oC. Deflection of 3 mm was observed on the propellers while applying equal loads to all the propellers. The key design aspects are the I-shaped contour, material selection for the main frame and incorporation of overlapping propellers. The benefits accruing from such a design are space efficiency and superior turning speed.