This article summarizes methods for determining proton surface charge at mineral/water interfaces. It covers conventional experimental procedures and discusses problems with the techniques. Also it involves recommendations for obtaining reasonable and comparable results. The term "comparable results" refers to comparison between results for the same solid as obtained in different laboratories. The most important parameters for the surface titrations are discussed. We also propose a reference titration procedure that would allow direct, unbiased comparisons of experimental data. The article finally includes a check-list for researchers and reviewers which should allow limiting the amount of titration data that are not useful for future uses. (doi: 10.5562/cca2062

Bacterial adhesion can be controlled by different material surface properties, such as surface charge, on which we concentrate in our study. We use a silica surface on which poly(allylamine hydrochloride)/sodium poly(4-styrenesulfonate) (PAH/PSS) polyelectrolyte multilayers were formed. The corresponding surface roughness and hydrophobicity were determined by atomic force microscopy and tensiometry. The surface charge was examined by the zeta potential measurements of silica particles covered with polyelectrolyte multilayers, whereby ionic strength and polyelectrolyte concentrations significantly influenced the build-up process. For adhesion experiments, we used the bacterium Pseudomonas aeruginosa. The extent of adhered bacteria on the surface was determined by scanning electron microscopy. The results showed that the extent of adhered bacteria mostly depends on the type of terminating polyelectrolyte layer, since relatively low differences in surface roughness and hydrophobicity were obtained. In the case of polyelectrolyte multilayers terminating with a positively charged layer, bacterial adhesion was more pronounced than in the case when the polyelectrolyte layer was negatively charged.