In solvent extraction, the self-assembly of amphiphilic molecules into an organized structure is the phenomenon responsible for the transfer of the metal ion from the aqueous phase to the organic solvent. Despite their significance for chemical engineering and separation science, the forces driving the solute transfer are not fully understood. Instead of assuming the simple complexation reaction with predefined stoichiometry, we model synergistic extraction systems by a colloidal approach that explicitly takes into account the self-assembly resulting from the amphiphilic nature of the extractants. Contrary to the current paradigm of simple stoichiometry behind liquid-liquid extraction, there is a severe polydispersity of aggregates completely different in compositions, but similar in the free energy. This variety of structures on the nanoscale is responsible for the synergistic transfer of ion to the organic phase. Synergy can be understood as a reciprocal effect of chelation: it enhances extraction because it increases the configurational entropy of an extracted ion. The global overview of the complex nature of synergistic mixture shows different regimes in self-assembly, and thus in the extraction efficiency which can be tuned with respect to the green chemistry aspect.

The aim of this study was to investigate and understand bacterial adhesion to different dental material surfaces like amalgam, Chromasit, an Co-Cr alloy, an IPS InLine ceramic, yttrium stabilized tetragonal polycrystalline zirconia (TPZ), a resin-based composite, an Au-Pt alloy, and a tooth. For all materials, the surface roughness was assessed by profilometry, the surface hydrophobicity was determined by tensiometry, and the zeta potential was measured by electrokinetic phenomena. The arithmetic average roughness was the lowest for the TPZ ceramic (R_a = 0.23 µm ± 0.02 µm), while the highest value was observed for the Au-Pt alloy (R_a = 0.356 µm ± 0.075 µm). The hydrophobicity was the lowest on the TPZ ceramic and the highest on the Co-Cr alloy. All measured streaming potentials were negative. The most important cause of tooth caries is the bacterium Streptococcus mutans, which was chosen for this study. The bacterial adhesion to all material surfaces was determined by scanning electron microscopy. We showed that the lowest bacterial extent was on the amalgam, whereas the greatest extent was on tooth surfaces. In general, measurements showed that surface properties like roughness, hydrophobicity and charge have a significant influence on bacterial adhesion extent. Therefore, dental material development should focus on improving surface characteristics to reduce the risk of secondary caries.

Bacterial adhesion can be controlled by different material surface properties, such as surface charge, on which we concentrate in our study. We use a silica surface on which poly(allylamine hydrochloride)/sodium poly(4-styrenesulfonate) (PAH/PSS) polyelectrolyte multilayers were formed. The corresponding surface roughness and hydrophobicity were determined by atomic force microscopy and tensiometry. The surface charge was examined by the zeta potential measurements of silica particles covered with polyelectrolyte multilayers, whereby ionic strength and polyelectrolyte concentrations significantly influenced the build-up process. For adhesion experiments, we used the bacterium Pseudomonas aeruginosa. The extent of adhered bacteria on the surface was determined by scanning electron microscopy. The results showed that the extent of adhered bacteria mostly depends on the type of terminating polyelectrolyte layer, since relatively low differences in surface roughness and hydrophobicity were obtained. In the case of polyelectrolyte multilayers terminating with a positively charged layer, bacterial adhesion was more pronounced than in the case when the polyelectrolyte layer was negatively charged.