Well-defined silica poly(2-methyl-2-oxazoline) nanoparticles were prepared via the “grafting to” method employing either click chemistry or silane coupling using different reaction conditions. In the first approach, alkyne-functionalized poly(2-methyl-2-oxazoline), P1, was prepared by ring opening cationic polymerization and clicked on azide-functionalized silica nanoparticles (SNPs), which led to the fabrication of hybrid nanoparticles. In the second approach, trimethoxysilane-functionalized poly(2-methyl-2-oxazoline), P2, was prepared similar to P1 and grafted on the surface of SNPs using coupling reactions between trimethoxysilane and hydroxyl groups of the silica nanoparticle. Hybrid particles were characterized by Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), transmission electron microscopy (TEM), and elemental analysis (EA). The grafting density ranged from 0.183 chains per nm2 for the click chemistry approach up to 0.45 chains per nm2 when using trimethoxysilane-functionalized P2 in acetonitrile at 80 °C. The water-in-oil microemulsion approach resulted still in a relatively high grafting density of 0.353 chains per nm2 and has the advantage of a one-step process and mild reaction conditions.
One commonly used lubricant in rolling bearings is grease, which consists of base oil, thickener and small amounts of additives. Commercial greases are mostly produced from petrochemical base oil and thickener. Recently, the development of base oils from renewable resources have been significantly focused on in the lubricant industry. However, to produce an entirely bio-based grease, the thickener must also be produced from renewable materials. Therefore, this work presents the design and evaluation of three different bio-based polymer thickener systems. Tribological tests are performed to characterize lubrication properties of developed bio-based greases. The effect of thickener type on film thickness and friction behavior of the produced bio-based greases is evaluated on a ball-on-disc tribometer. Moreover, the results are compared to a commercial petrochemical grease chosen as benchmark.
Particles in the sub-100 nm range have attracted widespread attention in the past few years due to their application in drug delivery and diagnostics. Here we describe the synthesis of two bifunctional, amphiphilic poly(2-oxazoline) macromonomers with multiple acrylate groups in their hydrophobic block and azide or primary amino end groups. The amphiphilic macromonomers were applied in a microemulsion polymerization to form well-defined core-crosslinked nanoparticles with surface functional azide or amine groups. Therefore, an amphiphilic poly(2-oxazoline) was prepared by cationic ring-opening polymerization of 2-methyl-2-oxazoline to form the hydrophilic block and a mixture of 2-heptyl-2-oxazoline and 2-(5-pentyl-[(1,2,3-triazol)-4-yl-methacrylat)]-oxazoline to form the hydrophobic block and was terminated with an azide moiety as end group. The introduction of multiple methacrylate groups into the poly(2-oxazoline) macromonomers serve as a stabilizer in the microemulsion process to covalently link the polymer to the particle core. Variable particle sizes of 20–75 nm have been prepared by encapsulating different amounts of 1,6-hexanedioldimethacrylate (HDDMA) to swell the micellar core before subsequent crosslinking takes place. Finally, particle surface functionalization was achieved by converting the terminal azide group via Staudinger-reaction to a primary amine group. Nanoparticles with surface primary amine groups were functionalized with folic acid (FA), a GRGDS-peptide derivative and fluorescein isothiocyanate (FITC) by simple amidation reaction (FA, RGD-peptide) or thiourea formation (FITC).