The dry-hot wind climate is one of the major agro-meteorological disasters associated with high temperature, low humidity, and specific wind forces, which seriously affects the yield of wheat in the North China Plain. A field experiment was conducted to investigate the field microclimate, net photosynthetic rate, chlorophyll content of flag leaves, grain filling rate, and wheat yield after sprinkler misting under the condition of a dry-hot wind climate in the 2018 and 2019 seasons. Two travel speeds, full and half speed, and the corresponding irrigation amounts of 2.5 and 5 mm were used by a center pivot irrigation system during dry-hot wind conditions. A treatment without irrigation was applied as a control. The results showed that the air temperature and relative air humidity were greatly improved within 60 min after irrigation, especially in the upper part of the canopy. The net photosynthetic rate of flag leaves under 5 mm irrigation was higher than that under 2.5 mm irrigation during the middle and late grain filling periods. The adverse effects of dry-hot wind on the chlorophyll content of the flag leaves were mainly concentrated in the late grain filling stage. In the two years of the experiment, the average 1000-grain weights of 5 and 2.5 mm of irrigation treatments were 4.3 and 2.8% higher, and the grain yields were 5.8 and 3.3% higher, respectively, than those of the non-irrigated yields. Overall, applying a small amount of water between 12:00–14:00 with a center pivot before the occurrence of dry-hot wind is an effective means to regulate the field microclimate and produce more yield in the North China Plain.
The integration of remote sensing technology and machine learning algorithms represents a new research direction for the rapid and large-scale detection of water stress in modern agricultural crops. However, in solving practical agricultural problems, single machine learning algorithms cannot fully explore the potential information within the data, lacking stability and accuracy. Stacking ensemble learning (SEL) can combine the advantages of multiple single machine learning algorithms to construct more stable predictive models. In this study, threshold values of stomatal conductance (gs) under different soil water stress indices (SWSIs) were proposed to assist managers in irrigation scheduling. In the present study, six irrigation treatments were established for winter wheat to simulate various soil moisture supply conditions. During the critical growth stages, gs was measured and the SWSI was calculated. A spectral camera mounted on an unmanned aerial vehicle (UAV) captured reflectance images in five bands, from which vegetation indices and texture information were extracted. The results indicated that gs at different growth stages of winter wheat was sensitive to soil moisture supply conditions. The correlation between the gs value and SWSI value was high (R2 > 0.79). Therefore, the gs value threshold can reflect the current soil water stress level. Compared with individual machine learning models, the SEL model exhibited higher prediction accuracy, with R2 increasing by 6.67–17.14%. Using a reserved test set, the SEL model demonstrated excellent performance in various evaluation metrics across different growth stages (R2: 0.69–0.87, RMSE: 0.04–0.08 mol m−2 s−1; NRMSE: 12.3–23.6%, MAE: 0.03–0.06 mol m−2 s−1) and exhibited excellent stability and accuracy. This research can play a significant role in achieving large-scale monitoring of crop growth status through UAV, enabling the real-time capture of winter wheat water deficit changes, and providing technical support for precision irrigation.
High efficient nitrogen (N) application method and proper N management strategies can further reduce the losses and enhance N use efficiency. Field experiments were conducted in the 2015–2016 and 2016–2017 growing seasons to evaluate the effects of four fertigation frequencies treatments (FT-1: all the topdressing N was applied at the jointing stage; FT-2: 67% and 33% of the topdressing N was applied at the jointing and filling stages; FT-3: 33%, 50% and 17% of the topdressing N was applied at the regreening, jointing and filling stages; FT-4: 33%, 33%, 17% and 17% of the topdressing N were applied at the regreening, jointing, anthesis and filling stages) on wheat yield, water use efficiency (WUE), partial productivity of N fertilizer (PFPN) and N harvest index (NHI). In addition, one-time topdressing by surface broadcasting at the jointing stage was set up as a control (BC-1). The results showed that FT-3 and FT-4 supplied sufficient NO3−-N in the 0–40 cm soil layer, which reduced the risk of soil NO3−-N leaching to the deeper layers. FT-4 had the highest grain yield, WUE, PFPN and NHI, with average values of 9153.4 kg ha−1, 2.1 kg m−3, 0.74 kg kg−1 and 31.3 kg kg−1, respectively, followed by these values corresponding to the FT-3 in two years. These findings suggest that topdressing N split with 3–4 times, that is to say applying approximately 16.7% of topdressing N in anthesis and filling stages, respectively by the center pivot fertigation method can significantly improve yield, WUE, PFPN and NHI.
Subsurface drip irrigation is an advanced technique that significantly enhances agricultural water efficiency and conserves irrigation resources. The Heilonggang region is highly representative of the maize–wheat rotation system in China. This region was selected for conducting operations and maintenance experiments on subsurface drip irrigation systems. The primary objective of this study was to determine the most suitable type of drip tape for application in the North China Plain and to identify specific maintenance measures necessary to ensure the long-term functionality of subsurface drip irrigation systems. The experiment was conducted in Jing County, Hengshui City. Anti-blocking drip tape (Netafim Co., Ltd. Beijing, China) with automatic functionality was evenly laid in the test area. The experimental area was divided into six rotational irrigation groups. The key parameter examined in this single-factor experiment was the drip tape wall thickness, with values of 0.2, 0.225, 0.25, 0.28, 0.31, and 0.38 mm. Drip tape treatments were randomly sampled in rotational irrigation groups, and there were three repeat plots in each treatment. Each replicate plot contained ten drip irrigation belts spaced 60 cm apart, with an interval of more than 2 m between adjacent plots. The subsurface drip irrigation system was installed in October 2023. Prior to irrigation, drip tape troubleshooting was conducted and recorded manually on 12 March 2024 (wheat regreening stage) and 29 June 2024 (maize-sowing stage). The experimental findings indicated that the primary factor influencing the stability of the irrigation system was the wall thickness of the drip tapes, while other system components operated efficiently. A significant correlation was observed between the wall thickness of the drip tape and the number of water leakage points (p < 0.05), with an absolute correlation coefficient exceeding 0.9. The number of leakage points in drip tapes with wall thicknesses of 0.2–0.28 mm (267 instances) was significantly higher than those with wall thicknesses of 0.31–0.38 mm (29 instances), primarily due to damage caused by mole crickets and wireworms. Following the injection of 40% phoxim, 2.5% lambda-cyhalothrin, and 70% imidacloprid insecticides (at a cost of 16.7 USD·ha−1) into the subsurface drip irrigation system, the insect pests were nearly eradicated within one month. A cumulative cost evaluation over a 6–10-year period recommended the use of drip tapes with a wall thickness of 0.31 mm and the application of insecticides every 1–2 months to maintain optimal system performance in this region. These measures can effectively support the stable operation of this irrigation technique at a relatively low cost.
Optimizing nitrogen form under drip fertigation may improve wheat productivity by regulating the root-zone inorganic N environment during early vegetative growth. A two-year field experiment evaluated nitrate-dominant (N1), balanced ammonium–nitrate (N2), and ammonium-enriched nitrogen strategies (N3) during GS13–GS31, with conventional farmer practice (CK) and a zero-N control (N0) for comparison. Nitrogen-form regulation markedly altered the soil NH4+-N ratios, especially in the 0–20 cm soil layer, with N3 highest, N1 lowest, and N2 intermediate. Compared with the nitrate- or ammonium-dominant strategy, the balanced treatment N2 improved spike formation rate and maintained relatively higher N accumulation at GS31 and GS65, and showed greater N translocation and contribution of translocated N to grain N than N1. Correlation analyses indicated that spike formation rate was closely related to spike number (R2 = 0.764) and N accumulation at GS31 was positively related to Ntrans (R2 = 0.588). N2 showed the most favorable overall performance, with the highest numerical values for grain yield, nitrogen recovery efficiency, irrigation water use efficiency, and net profit among the fertigation treatments. However, the advantages of N2 over N3 in grain yield and SPAD-AUC were modest and not consistently significant. These results indicate that balancing ammonium and nitrate supply during GS13–GS31 under drip fertigation can improve root-zone N conditions and support better overall agronomic performance in winter wheat under the alkaline soil conditions of the North China Plain.