Ayham AlAkhras

Mr. Ayham AlAkhras

University of Ottawa
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 January 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
AAAyham AlAkhras
Ayham AlAkhras
ISIlham Hassan Sattar
Ilham Hassan Sattar
MAMuhammad Alvi
Muhammad Alvi
MQMohammed Waleed Qanbar
Mohammed Waleed Qanbar
MJMohammad A. Jaradat
Mohammad A. Jaradat
MAMuhannad Alkaddour
Muhannad Alkaddour
Conventionally, aerial manipulators, when used for inspection, use drone rotors to stabilize the center of gravity (CoG) shifts, which highly affects its performance. This paper discusses the development of a self-balancing lightweight cable aerial manipulator that can be used for construction inspection purposes. The design is based on a 3D-printed, three degrees of freedom (DoF), planar cable manipulator that is mounted on an extended platform below it as a counter-balance mechanism. The actuators control the manipulator links through a cable system, allowing them to be mounted at the system base to reduce the moving mass of the manipulator during operation. The counter-balance mechanism compensates for any shifts in the CoG of the system by actively sliding a counter-balance weight, mainly a battery, which powers the setup. This mechanism can be attached beneath an off-the-shelf quadrotor to solve the problem of CoG shifts. CoG shifts are due to the manipulator operation when a payload or inspection tool is attached to the end effector to perform a given task. For construction integrity inspection, the aerial manipulator must remain stable during the push or slide processes on both flat and curved surfaces while the non-destructive tests are carried out. To validate the effectiveness of the proposed design, an experimental setup was used, and comparisons were made between the compensated and uncompensated tilt angles of the aerial manipulator. Significant tilt angle reductions were observed with an average of 94.69% improvement, undergoing different manipulator motions during different operation scenarios, as a result of an active compensation of the CoG shift and lightweight design of the system, without sacrificing the functionality of the manipulator for the task.

23 December 2024 in Sensors
Verified
Journal Article
Open access
PDF file
SPScott Pardoel
Scott Pardoel
AAAyham AlAkhras
Ayham AlAkhras
EJEnsieh Jafari
Ensieh Jafari
JKJonathan Kofman
Jonathan Kofman
Edward LemaireEdward Lemaire
Edward Lemaire
JNJulie Nantel
Julie Nantel
Freezing of gait (FOG) is a walking disturbance that can lead to postural instability, falling, and decreased mobility in people with Parkinson’s disease. This research used machine learning to predict and detect FOG episodes from plantar-pressure data and compared the performance of decision tree ensemble classifiers when trained on three different datasets. Dataset 1 (n = 11) was collected in a previous study. Dataset 2 (n = 10) included six new participants and four participants from Dataset 1 who were re-tested (approximately 2 years later), and Dataset 3 (n = 21) combined Datasets 1 and 2. The prediction model trained on Dataset 3 had a 2.28% higher sensitivity and 3.09% lower specificity compared to the models trained on Dataset 1. The model trained on Dataset 3 identified 86.84% of the total FOG episodes compared to 74.31% from the model trained on Dataset 1. Also, the model using Dataset 3 identified the FOG episodes 0.3 s earlier than the model developed with Dataset 1. The model trained using Dataset 3 showed improved performance in sensitivity, identification time, and FOG identification. The improvements using the expanded dataset (Dataset 3) in this study compared to the previous model reinforce the validity and generalizability of the original model. The model was able to predict and detect FOG well and is, therefore, ready to be implemented in a FOG prevention device.

22 July 2026 in European Journal of Neuroscience
Verified
Journal Article
Open access
PDF file
AAAyham AlAkhras
Ayham AlAkhras
SPScott Pardoel
Scott Pardoel
EJEnsieh Jafari
Ensieh Jafari
ELEdward D. Lemaire
Edward D. Lemaire
JNJulie Nantel
Julie Nantel
Freezing of gait is a debilitating walking disturbance that can severely worsen quality of life for people with Parkinson's disease. However, current Parkinson's disease treatments do not effectively address freezing of gait, leading researchers to explore cueing to mitigate the symptom. Somatosensory stimulation is an emerging cueing strategy that could be discreet and practical to mitigate freezing of gait duration. Twenty‐six participants (seven females) attempted walking trials in a freeze‐inducing path while wearing a functional electrical stimulation cueing device. Functional electrical stimulation cueing was activated autonomously in real time. Constrained random sampling was used to designate each trial as cueing system on or off, providing a control for within‐participant analysis. A total of 576 freezing episodes were recorded with the device on. Of those, 492 were successfully stimulated. To assess cueing performance, freezing of gait time per trial in the on and off device states was calculated for each participant. On average, freezing of gait time per trial decreased from 5.84 to 5.69 s (2.44%). Freezing of gait time per trial increased for half the participants and the other half experienced a decrease. There were no statistically significant group‐level effects, though electrical stimulation cueing elicits a wide range of responses from different participants, with the technology mitigating freezing of gait for some individuals. Because functional electrical stimulation has numerous modifiable parameters that influence sensation and nervous system response, personalizing these parameters could enhance the effectiveness of freezing of gait mitigation and provide deeper insights into freezing of gait.