In this paper, the two-dimensional Kelvin–Helmholtz (KH) instability occurring in the shear flow of polymer fluids is modeled by the dissipative particle dynamics (DPD) method at the coarse-grained molecular level. A revised FENE model is proposed to properly describe the polymer chains. In this revised model, the elastic repulsion and tension are both considered between the adjacent beads, the bond length of which is set as one segment’s equilibrium length. The entanglements between polymer chains are described with a bead repulsive potential. The characteristics of such a KH instability in polymer fluid shear flow can be successfully captured in the simulations by the use of the modified FENE model. The numerical results show that the waves and vortexes grow more slowly in the shear flow of the polymer fluids than in the Newtonian fluid case, these vortexes become flat, and the polymer impedes the mixing of fluids and inhibits the generation of turbulence. The effects of the polymer concentration, chain length, and extensibility are also investigated regarding the evolution of KH instability. It is shown that the mixing of two polymer fluids reduces, and the KH instability becomes more suppressed as the polymer concentration increases. The vortexes become much longer with the evolution of the elongated interface as the chain length turns longer. As the extensibility increases, the vortexes become more flattened. Moreover, the roll-up process is significantly suppressed if the polymer has sufficiently high extensibility. These observations show that the polymer and its properties significantly influence the formation and evolution of the coherent structures such as the waves and vortexes in the KH instability progress.
This study investigate the morphology of oil-in-water at high density ratio controlled by electric field. We incorporated the electric field into the Lattice Boltzmann method (LBM). The focus is on the modified lattice Boltzmann color gradient model simulate the evolution of the oil-in-water and analyze the relation between morphologies and electric field parameters. The results show that the stretching, merging and even breaking can be regulated by electric field strength, conductivity, dielectric constant, oil-water density ratio and droplet radius. Simulation results showed that the larger dielectric constant resulted in the smaller deformation, and the larger conductivity related to the greater deformation. Meanwhile, the larger radius droplet is easier to deform and break, and the higher density droplet is less likely to break. And this paper also gives the morphology of the stretching and destabilization of the droplets at each stage. These results are in good agreement with the relevant theoretical and experimental results.
The discrete element method (DEM) coupled with computational dynamics (CFD) has been considered one of the most sensitive ways of studying fluidized beds. This paper presents gas-solid fluidized bed simulations by use of CFD-DEM. The two-phase interaction is calculated in a way of decoupling. Within the effective neighborhood of the particles, the kernel approximation method is used to calculate the local porosity, thereby calculating the drag force on the particles. At the grid scale, the momentum exchange coefficient is calculated using a two fluid model based method, thereby calculating the source term of the phase interaction in the fluid control equation. The simulated form, size and motion process of the big bubble are all consistent with experimental observations. The simulated solid volume fraction and relative pressure averaged in a horizontal plane at 45 mm above the bottom are in reasonable agreement with the experimental data. The fluctuation of the simulated bed height over time is similar to the experimental measurement results. The reproduction of these qualitative and quantitative results indicates that the proposed method effectively improves simulation performance and accuracy.
24 March 2026 in Emission Control Science and Technology