Thermoelectric materials can realize direct conversion between heat and electricity, showing excellent potential for waste heat recovery. Cu2Se is a typical superionic conductor thermoelectric material having extraordinary ZT values, but its superionic feature causes poor service stability and low mobility. Here, we reported a fast preparation method of self-propagating high-temperature synthesis to realize in situ compositing of BiCuSeO and Cu2Se to optimize the service stability. Additionally, using the interface design by introducing graphene in these composites, the carrier mobility could be obviously enhanced, and the strong phonon scatterings could lead to lower lattice thermal conductivity. Ultimately, the Cu2Se-BiCuSeO-graphene composites presented excellent thermoelectric properties with a ZTmax value of ~2.82 at 1000 K and a ZTave value of ~1.73 from 473 K to 1000 K. This work provides a facile and effective strategy to largely improve the performance of Cu2Se-based thermoelectric materials, which could be further adopted in other thermoelectric systems.
12 September 2018 in Journal of Materials Chemistry A
With good chemical and thermal stabilities, ZnO is a promising thermoelectric material that can be operated over a wide temperature range, particularly for high temperatures. For two dimensional (2D) thin films, modifying the thermal and electrical transport properties could be simplified due to the loss of one dimension. However, the carrier transport properties of pure ZnO have not yet been optimized. Herein, highly c-axis-orientated Ga-doped thin films have been epitaxially deposited at different temperatures, and the surface morphology and roughness have been modified. The GZO film deposited at 673 K exhibited an increased Hall mobility due to its high quality and crystallinity as well as higher carrier concentration due to enhanced Ga doping efficiency on Zn sites, resulting in its remarkable electrical conductivity. In addition, the enlarged effective mass, which could be mainly attributed to the enhancement in the density of states, allows the high retention of Seebeck coefficient value of GZO-673-AO upon increasing the carrier concentration. Ultimately, an improved power factor value of 256 μW m−1 K−2 at 623 K has been achieved for GZO-673-AO, demonstrating that Ga doping combined with optimized deposition temperatures could be a promising strategy for enhancing the thermoelectric properties of ZnO-based epitaxial films.
Thermoelectrics converting heat and electricity directly attract broad attentions. To enhance the thermoelectric figure of merit, zT, one of the key points is to decouple the carrier-phonon transport. Here, we propose an entropy engineering strategy to realize the carrier-phonon decoupling in the typical SrTiO3-based perovskite thermoelectrics. By high-entropy design, the lattice thermal conductivity could be reduced nearly to the amorphous limit, 1.25 W m−1 K−1. Simultaneously, entropy engineering can tune the Ti displacement, improving the weighted mobility to 65 cm2 V−1 s−1. Such carrier-phonon decoupling behaviors enable the greatly enhanced μW/κL of ~5.2 × 103 cm3 K J−1 V−1. The measured maximum zT of 0.24 at 488 K and the estimated zT of ~0.8 at 1173 K in (Sr0.2Ba0.2Ca0.2Pb0.2La0.2)TiO3 film are among the best of n-type thermoelectric oxides. These results reveal that the entropy engineering may be a promising strategy to decouple the carrier-phonon transport and achieve higher zT in thermoelectrics.
9 July 2024 in Journal of the American Chemical Society
This review outlines recent advancements in oxide thermoelectrics, spanning from material synthesis to optimization strategies, and emerging applications alongside future perspectives.