The real resistance that a ship must face when it is navigating in ice floes is the key factor for knowing the necessary power and the required engine size. The aim of this work is to provide valuable data to help other research in which numerical frameworks will be developed to study ship navigation in broken ice. In this work, we used paraffin wax as an alternative to obtain affordable solutions, avoiding the high cost of ice tests. The experiments were carried out in a traditional basin facility and they consisted of towing tank tests with a ship model using different concentrations of blocks simulated by the use of paraffin wax. Photogrammetry was used as technique to determine the initial position of the ice blocks, which is important as starting data in the current development of numerical simulation code for studying the features of ship resistance in drift ice. These data are available for some ice concentrations in attached files. In addition, a procedure for testing in traditional towing facilities is presented and discussed. The results of the resistance obtained in the experiments in the presence of simulated floes are presented for three concentrations and three model speeds. Some findings may be applicable to ice sailing, under given circumstances.
17 December 2022 in Journal of Ocean Engineering and Marine Energy
Purpose: This paper addresses the influence of the main bulb’s parameters of a containership on heave and pitch RAO for head waves.Design/methodology/approach: To obtain the RAO curves, these parameters are scattered over the design space through latin hypercube sampling (LHS), where different bulb designs are obtained using the free form deformation (FFD) technique. Linear RAO curves are calculated based on numerical software, split into various frequency intervals and assessed according to six evaluation parameters.Findings: The findings show that maximum, minimum and average values of the RAO curve are useful indicators to study the RAO of a ship. Average values of the curve are reduced more than 6% for heave and over 24% for pitch with respect to a vessel with a conventional bulbous bow. The best designs concentrate the volume around the mid-lower part of the bulb, whilst the worst designs concentrate the bulb volume towards the upper part of the bulb.Originality/value: In the literature, we get an overview of the influence of different bows on seakeeping. However, the influence of the bulb or large variations of the bow in a parametric way have not been studied yet. Since most of these parameters are derived from the RAO curve and ship motions, this paper focuses on studying the RAO curve for heave and ship motions of a bulbous bow containership. The objective is to minimize the RAO values of the curves so that most derived parameters reduce their values as well.
The increase of the average temperature in artic regions is boosting the ice setback, which allows keeping the artic navigation routes open for longer periods, open new ones, and expand the commercial fishing. In fact, shipping lines are more and more enthusiastic about the potential that these new routes offer, given the save of time and energy cost that might provide compared to longer traditional routes. In this sense, this paper presents some issues regarding with experimentation carried out at CEHINAV Towing Tank (Spain) to study the ship resistance in broken ice. The tests were conducted using paraffin wax as simulated broken ice. First, some aspects regarding with ship ice navigation are exposed. Second, main particulars of a ship model based on B.I.O. Hesperides (Spanish Army) to carry out the towing tests are shown. Third, hypothesis used to configure tests are explained. Finally, some conclusions and results are exposed regarding with experimentation conducted.
Efficiency estimation of a propeller behind a vessel’s hull while sailing through ice floes, together with the ship’s resistance to motion, is a key factor in designing the power plant and determining the safety measures of a ship. This paper encloses the results from the experiments conducted at the CEHINAV towing tank, which consisted of analyzing the influence of the concentration at the free surface of artificial blocks, simulating ice, in propeller–block interactions. Thrust and torque were measured for a towed self-propelled ship model through simulated broken ice blocks made of paraffin wax. Three block concentrations of different block sizes and three model speeds were studied during the experimentation. Open-water self-propulsion tests and artificial broken ice towed self-propulsion tests are shown and compared in this work. The most relevant observations are outlined at the end of this paper, as well as some guidelines for conducting artificial ice-towed self-propulsion tests in traditional towing tanks.