3D printing, as a versatile additive manufacturing technique, offers high design flexibility, rapid prototyping, minimal material waste, and the capability to fabricate complex, customized geometries. These attributes make it particularly well-suited for low-temperature hydrogen electrochemical conversion devices—specifically, proton exchange membrane fuel cells, proton exchange membrane electrolyzer cells, anion exchange membrane electrolyzer cells, and alkaline electrolyzers—which demand finely structured components such as catalyst layers, gas diffusion layers, electrodes, porous transport layers, and bipolar plates. This review provides a focused and critical summary of the current progress in applying 3D printing technologies to these key components. It begins with a concise introduction to the principles and classifications of mainstream 3D printing methods relevant to the hydrogen energy sector and proceeds to analyze their specific applications and performance impacts across different device architectures. Finally, the review identifies existing technical challenges and outlines future research directions to accelerate the integration of 3D printing in next-generation low-temperature hydrogen energy systems.
17 April 2026 in International Journal of Hydrogen Energy
The engineering of porous transport layer (PTL)–catalyst layer (CL) interfacial architecture plays a critical role in optimizing the performance of proton exchange membrane water electrolyzers (PEMWEs). Particularly, at the PTL-CL interface, our results reveal that anode catalyst loadings affect the modulation of the PTL surface structure on the overpotentials of PEMWEs. Under high anode catalyst loadings, the magnitude of overpotentials is predominantly governed by the electronic conductivity and mass transport resistance within the CL, where the modifying effects of PTL-CL interfacial contact characteristics become negligible. However, when the catalyst loading is reduced, the PTL-CL interfacial contact characteristics become critical for electron conduction, mass transport, and kinetic reaction. Under low catalyst loadings, the etched PTL demonstrates a maximum reduction of 59 mV compared to the pristine PTL at 4 A/cm2, with the former exhibiting a 10 mΩ·cm2 reduction. Meanwhile, the etched PTL integrated with a cell demonstrates superior performance in both mass transport and kinetic overpotentials compared to a pristine PTL. This clearly indicates that the surface structure of the PTL plays an increasingly significant role in regulating the overpotentials of PEMWEs as the catalyst loadings decrease.