Suboptimal reproductive performance of maiden (primiparous) ewes remains a source of inefficiency for the Australian sheep industry. However, the extent and causes of the poorer reproductive performance of maiden ewes on Australian sheep farms are not well understood. Here, we show the reproductive performance of maiden ewes relative to their multiparous counterparts on the same farms across Australia using a cohort survey. The difference in marking rate for non-Merino maiden ewe lambs compared to multiparous ewes was 58% (74 vs. 132%; p < 0.001), and this was attributable to a 50% difference in reproductive rate (109 vs. 159%; p < 0.001) and 16% difference in lamb survival to marking (67 vs. 83%; p < 0.001). The difference in marking rate for maiden Merino two-tooth ewes lambing at approximately 2 years-of-age compared to mature multiparous ewes was 22% (80 vs. 102%; p < 0.001) and this was attributable to a 24% difference in reproductive rate (108 vs. 132%; p < 0.001) and 3% difference for lamb survival (75 vs. 78%; p < 0.05). Positive correlations for reproduction traits (reproductive rate, lamb survival and marking rate) between maidens and multiparous ewes were observed for maiden Merino two-tooth ewes (p < 0.001), but these correlations were weak or non-existent for non-Merino ewe lambs. Strategies to improve both reproductive rate and lamb survival can address the poorer and more variable reproductive performance of maiden ewes.

This study evaluated the impacts of management of body condition score (BCS) between pregnancy scanning and lamb marking on the mortality of triplet-bearing ewes and their lambs at 19 research sites across Southern Australia. Triplet-bearing ewes of Maternal (crossbred or composite) or Merino breed were randomly allocated to treatment at pregnancy scanning at an average of 97 days from the start of joining: High or Low BCS. The BCS of individual ewes was assessed at pregnancy scanning, pre-lambing (average of 137 days from the start of joining) and marking (average of 165 days from the end of joining), and ewe and lamb mortality to marking, recorded for each mob. The average BCS at pregnancy scanning was 3.4 for Maternal ewes and 3.3 for Merino ewes. There were no breed by BCS treatment effects on the BCS of ewes at pregnancy scanning or lamb marking or on the change in BCS between pregnancy scanning and pre-lambing or between pre-lambing and marking. The change in BCS differed between the High and Low BCS treatments, between pregnancy scanning and pre-lambing (0.12 vs. −0.33; p < 0.001) and between pre-lambing and marking (−0.39 vs. 0.07; p < 0.001) but did not differ between breeds. The average BCS at marking for ewes managed at the High and Low BCS treatments was 3.1 and 3.0 for Maternals and 3.0 and 2.8 for Merinos. Survival of triplet-bearing Merino ewes (p < 0.01) and their lambs (p < 0.001) was greater when ewes were managed at the High BCS compared to the Low BCS. The BCS treatment did not impact the survival of Maternal ewes or their lambs. The survival of Merino but not Maternal lambs was higher when ewes were in greater BCS pre-lambing (p < 0.01) and when ewes gained BCS between pregnancy scanning and pre-lambing (p < 0.01). Ewe mortality was lower when ewes gained BCS between pregnancy scanning and pre-lambing (p < 0.05). Merino ewes were more likely to die than Maternal ewes for a given change in BCS between pregnancy scanning and pre-lambing (p = 0.065). Overall, our findings demonstrate that producers should manage the nutrition of triplet-bearing Merino ewes so that ewes are in greater BCS at lambing and/or to gain BCS between pregnancy scanning and lambing to improve ewe and lamb survival. Triplet-bearing Maternal ewes should be managed to gain BCS between pregnancy scanning and lambing to improve ewe survival.

Industry consultation in Australia revealed that the potential impact of the mob size of ewes during lambing on the survival of triplet-born lambs was an important research priority. Previous research has demonstrated that smaller mob sizes at lambing improve the survival of single- and especially twin-born lambs, regardless of ewe stocking rate. Therefore, we hypothesised that lambing triplet-bearing ewes in smaller mobs, regardless of stocking rate, will increase the survival of their lambs. Research sites were established on 12 commercial sheep farms across southern Australia between 2019 and 2021. One farm used Merinos whilst the remainder of the farms used non-Merino breeds, consisting of composite ewes joined to composite or terminal sires. Three of the farms were used in two years of the experiment. Adult, triplet-bearing ewes were randomly allocated into one of two treatments, ‘High’ or ‘Low’ mob size, at an average of 135 days from the start of joining. Ewe and lamb survival were assessed between allocation to treatments and lamb marking. Lamb survival was significantly greater for lambs born in the Low (65.6%) compared with the High (56.6%) mob size treatments (p < 0.001). There was no effect of mob size at lambing on the mortality of triplet-bearing ewes. Analysis of the effect of the actual mob sizes showed that reducing the mob size at lambing by 10 triplet-bearing ewes increased the survival of their lambs to marking by 1.5% (p < 0.001). This study has shown that the survival of triplet-born lambs can be improved by lambing triplet-bearing ewes in smaller mobs regardless of stocking rate when ranging from 0.7–13 ewes/ha.

There is a perceived difficulty in getting tertiary agricultural graduates to undertake a career in agriculture. Increasing students’ understanding of the agricultural industry can be achieved through enlisting industry professionals to build and deliver content. Positive interactions with the industry in a supportive learning environment can further enhance students' engagement and interest, potentially leading to an increased uptake of careers in agriculture. This study uses student feedback collected from various surveys and formative feedback systems by Murdoch University Bachelor of Agriculture undergraduate students in 2023. Data was extrapolated from student responses from one core and one elective subject, selected due to their focus on increasing student exposure to multiple industry professionals and enhancing employability, with the goal of inspiring students to pursue careers in the agricultural industry after graduation. Student feedback highlighted a marked increase in confidence and understanding of the industry due to exposure to industry professionals. This industry involvement in content delivery and module development positively impacted students' confidence and their ability to enter the industry upon graduation. Ensuring flow and consistency across modules within a subject will continue to be a major challenge for subject coordinators when multiple industry professionals are involved in one subject. Improving feedback systems at all levels, from subject, to university and industry, is needed to inform on the key employment sectors graduates are working in, enabling educators to be reflective of shifts in industry trends and ensuring graduates are provided with the necessary skill set for a successful career in agriculture.