Wireless communication has become a very important part of our lives, and it is well known that meteorological factors affect the quality of communication links, especially at higher frequencies because the physical dimensions of raindrops, hail stones, and snowflakes are on a similar wavelength to the propagating radio frequency. Millimeter-waves are an important technology for fifth-generation cellular networks which are currently being deployed all over the world. Since atmospheric effects are challenging in millimeter-wave transmissions, in this paper, we conducted line-of-sight field measurements at 25 GHz and 38 GHz. We monitored the received signal during rainfall events and compared the theoretical attenuation and the recorded rain-induced attenuation. We also derived the rain-induced attenuation (A) and rainfall rate (R) relation for stratiform and convective rain, respectively, using local rain drop size distribution (DSD) information at our measurement site collected during the period of two years. Furthermore, opportunistic sensing of atmospheric phenomena using microwave or millimeter-wave communication links in commercial cellular networks has recently attracted more attention in meteorological research worldwide. The accuracy of calculating rainfall rates from microwave links highly depends on the retrieval model and values of coefficients in the model, i.e., a and b of the A-R relation model. Here, the coefficients a and b are estimated based on local DSD measurement, and the performance of the improved A-R model is evaluated using propagated signal power based on measurement data. Compared to the (a, b) coefficients in the International Telecommunication Union Recommendation (ITU-R) P.838 document, the derived coefficients achieved an improved rainfall rate estimation.

In order to improve the performance of X-band dual-polarization radars, it is necessary to conduct attenuation correction before using the X-band radar data. This study analyzes a variety of attenuation correction methods for the X-band radar reflectivity, and proposes a high-resolution slide self-consistency correction (SSCC) method, which is an improvement of Kim et al.’s method based on Bringi et al.’s original method. The new method is comprehensively evaluated with the observational data of convective cloud, stratiform cloud, and the stratiform cloud with embedded convection. Comparing with the intrinsic reflectivity at X-band calculated from the reflectivity at S-band, it is found that the new method can effectively reduce the correction errors when calculating differential propagation shift increments using the conventional self-consistency attenuation correction method. This method can efficiently correct the X-band dual-polarization radar reflectivity, in particular, for the echoes with reflectivity greater than 35 dBZ.

A uniformity index for the axis ratios (U_ar) derived from dual polarization weather radar data is proposed for raindrop area identification and analysis. The derivation of this new parameter is based on radar scattering simulations and assumptions. U_ar is between 0 and 1 and can be calculated from the differential reflectivity (Z_DR) and the copolar correlation coefficient (ρ_hv), which reflects the uniformity of the axis ratio (r) of the particle group. For raindrops, U_ar is close to 1 under ideal conditions, but is clearly different from that of ice particles whose value is close to 0. Studies conducted during two convective weather events observed by X-band and S-band radar are presented to show the U_ar features. In convective areas, high U_ar presents a U-shaped vertical structure. One branch corresponds to the Z_DR column, while the other branch is located at the rear of the convective cloud zone and is lower in altitude, representing the process of ice particles melting into raindrops and then being transported upward by a strong updraft. In stratiform cloud areas, a more than 95% overall identification ratio is obtained when the threshold of U_ar is set to 0.2~0.3 for discriminating rain layers.