The development of cost-effective co-catalysts of high photocatalytic activity and recyclability is still a challenge in the energy transformation domain. In this study, 0D/2D Schottky heterojunctions, consisting of 0D ZnO and 2D Ti₃C₂, were successfully synthesized by the electrostatic self-assembling of ZnO nanoparticles on Ti₃C₂ nanosheets. In constructing these heterojunctions, Ti₃C₂ nanosheets acted as a co-catalyst for enhancing the transfer of excitons and their separation to support the photocatalytic response of ZnO. The as-prepared ZnO/Ti₃C₂ composites demonstrate an abbreviated charge transit channel, a huge interfacial contact area and the interfacial electrons’ transport potential. The extended optical response and large reactive area of the ZnO/Ti₃C₂ composite promoted the formation of excitons and reactive sites on the photocatalyst’s surface. The ZnO/Ti₃C₂ Schottky heterojunction showed significantly high photocatalytic activity for hydrogen production from a water–ethanol solution under the light illumination in the visible region. The hydrogen evolution overoptimized the ZnO/Ti₃C₂ composition with 30 wt.% of Ti₃C₂, which was eight times higher than the pristine ZnO. These findings can be helpful in developing 0D/2D heterojunction systems for photocatalytic applications by utilizing Ti₃C₂ as a low-cost co-catalyst.

The use of ZnO as a photocatalyst with a reduced recombination rate of charge carriers and maximum visible light harvesting remains a challenge for researchers. Herein, we designed and synthesized a unique La/ZnO/CNTs heterojunction system via a sol–gel method to evaluate its photocatalytic performance for hydrogen evolution. A ferrocene powder catalyst was tested for the production of CNT forests over Si/SiO₂/Al₂O₃ substrate. A chemical vapor deposition (CVD) route was followed for the forest growth of CNTs. The La/ZnO/CNTs composite showed improved photocatalytic efficiency towards hydrogen evolution (184.8 mmol/h) in contrast to 10.2 mmol/h of pristine ZnO. The characterization results show that promoted photocatalytic activity over La/ZnO/NTs is attributed to the spatial separation of the charge carriers and extended optical absorption towards the visible light spectrum. The optimum photocatalyst shows a 16 h cycle performance for hydrogen evolution. The H₂ evolution rate under visible light illumination reached 10.2 mmol/h, 145.9 mmol/h and 184.8 mmol/h over ZnO, La/ZnO and La/ZnO/CNTs, respectively. Among the prepared photocatalysts, ZnO showed the lowest H₂ evolution rate due to the fast recombination of electron–hole pairs than heterojunction photocatalysts. This research paves the way for the development of ZnO and CNT-based photocatalysts with a wide optical response and reduced charge carrier recombinations.

The use of non-thermal plasma technology in producing green fuels is a much-appreciated environmentally friendly approach. In this study, an Al₂O₃-supported Cr_xZnS semiconductor catalyst was tested for hydrogen evolution from hydrogen sulfide (H₂S) gas by using a single-layered dielectric barrier discharge (DBD) system. The Al₂O₃-supported Cr_xZnS catalyst (x = 0.20, 0.25, and 0.30) was produced by using a co-impregnation method and characterized for its structural and photocatalytic characteristics. The discharge column of the DBD system was filled with this catalyst and fed with hydrogen sulfide and argon gas. The DBD plasma was sustained with a fixed AC source of 10 kV where plasma produced species and UV radiations activated the catalyst to break H₂S molecules under ambient conditions. The catalyst (hexagonal-cubic-sphalerite structure) showed an inverse relationship between the band gap and the dopant concentration. The hydrogen evolution decreased with an increase in dopant concentration in the nanocomposite. The Cr_0.20ZnS catalyst showed excellent photocatalytic activity under the DBD exposure by delivering 100% conversion efficiency of H₂S into hydrogen. The conversion decreased to 96% and 90% in case of Cr_0.25ZnS and Cr_0.30ZnS, respectively.