Emmanouil Skondras

Dr. Emmanouil Skondras


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 June 2021 in Sensors
Verified
Journal Article
Open access
PDF file
Emmanouel T. MichailidisEmmanouel T. Michailidis
Emmanouel T. Michailidis
NMNikolaos I. Miridakis
Nikolaos I. Miridakis
AMAngelos Michalas
Angelos Michalas
ESEmmanouil Skondras
Emmanouil Skondras
DVDimitrios J. Vergados
Dimitrios J. Vergados
Mobile edge computing (MEC) represents an enabling technology for prospective Internet of Vehicles (IoV) networks. However, the complex vehicular propagation environment may hinder computation offloading. To this end, this paper proposes a novel computation offloading framework for IoV and presents an unmanned aerial vehicle (UAV)-aided network architecture. It is considered that the connected vehicles in a IoV ecosystem should fully offload latency-critical computation-intensive tasks to road side units (RSUs) that integrate MEC functionalities. In this regard, a UAV is deployed to serve as an aerial RSU (ARSU) and also operate as an aerial relay to offload part of the tasks to a ground RSU (GRSU). In order to further enhance the end-to-end communication during data offloading, the proposed architecture relies on reconfigurable intelligent surface (RIS) units consisting of arrays of reflecting elements. In particular, a dual-RIS configuration is presented, where each RIS unit serves its nearby network nodes. Since perfect phase estimation or high-precision configuration of the reflection phases is impractical in highly mobile IoV environments, data offloading via RIS units with phase errors is considered. As the efficient energy management of resource-constrained electric vehicles and battery-enabled RSUs is of outmost importance, this paper proposes an optimization approach that intends to minimize the weighted total energy consumption (WTEC) of the vehicles and ARSU subject to transmit power constraints, timeslot scheduling, and task allocation. Extensive numerical calculations are carried out to verify the efficacy of the optimized dual-RIS-assisted wireless transmission.

19 June 2021 in Electronics
Verified
Journal Article
Open access
PDF file
ESEmmanouil Skondras
Emmanouil Skondras
AMAngelos Michalas
Angelos Michalas
DVDimitrios J. Vergados
Dimitrios J. Vergados
Emmanouel T. MichailidisEmmanouel T. Michailidis
Emmanouel T. Michailidis
NMNikolaos I. Miridakis
Nikolaos I. Miridakis
DVDimitrios D. Vergados
Dimitrios D. Vergados
Fifth generation Vehicular Cloud Computing (5G-VCC) systems support various services with strict Quality of Service (QoS) constraints. Network access technologies such as Long-Term Evolution Advanced Pro with Full Dimensional Multiple-Input Multiple-Output (LTE-A Pro FD-MIMO) and LTE Vehicle to Everything (LTE-V2X) undertake the service of an increasing number of vehicular users, since each vehicle could serve multiple passenger with multiple services. Therefore, the design of efficient resource allocation schemes for 5G-VCC infrastructures is needed. This paper describes a network slicing scheme for 5G-VCC systems that aims to improve the performance of modern vehicular services. The QoS that each user perceives for his services as well as the energy consumption that each access network causes to user equipment are considered. Subsequently, the satisfactory grade of the user services is estimated by taking into consideration both the perceived QoS and the energy consumption. If the estimated satisfactory grade is above a predefined service threshold, then the necessary Resource Blocks (RBs) from the current Point of Access (PoA) are allocated to support the user’s services. On the contrary, if the estimated satisfactory grade is lower than the aforementioned threshold, additional RBs from a Virtual Resource Pool (VRP) located at the Software Defined Network (SDN) controller are committed by the PoA in order to satisfy the required services. The proposed scheme uses a Management and Orchestration (MANO) entity implemented by a SDN controller, orchestrating the entire procedure avoiding situations of interference from RBs of neighboring PoAs. Performance evaluation shows that the suggested method improves the resource allocation and enhances the performance of the offered services in terms of packet transfer delay, jitter, throughput and packet loss ratio.

30 July 2021 in Drones
Verified
Journal Article
Open access
PDF file
ESEmmanouil Skondras
Emmanouil Skondras
Emmanouel T. MichailidisEmmanouel T. Michailidis
Emmanouel T. Michailidis
AMAngelos Michalas
Angelos Michalas
DVDimitrios J. Vergados
Dimitrios J. Vergados
NMNikolaos I. Miridakis
Nikolaos I. Miridakis
DVDimitrios D. Vergados
Dimitrios D. Vergados
In a fifth generation (5G) vehicular network architecture, several point of access (PoA) types, including both road side units (RSUs) and aerial relay nodes (ARNs), can be leveraged to undertake the service of an increasing number of vehicular users. In such an architecture, the application of efficient resource allocation schemes is indispensable. In this direction, this paper describes a network slicing scheme for 5G vehicular networks that aims to optimize the performance of modern network services. The proposed architecture consists of ground RSUs and unmanned aerial vehicles (UAVs) acting as ARNs enabling the communication between ground vehicular nodes and providing additional communication resources. Both RSUs and ARNs implement the LTE vehicle-to-everything (LTE-V2X) technology, while the position of each ARN is optimized by applying a fuzzy multi-attribute decision-making (fuzzy MADM) technique. With regard to the proposed network architecture, each RSU maintains a local virtual resource pool (LVRP) which contains local RBs (LRBs) and shared RBs (SRBs), while an SDN controller maintains a virtual resource pool (VRP), where the SRBs of the RSUs are stored. In addition, each ARN maintains its own resource blocks (RBs). For users connected to the RSUs, if the remaining RBs of the current RSU can satisfy the predefined threshold value, the LRBs of the RSU are allocated to user services. On the contrary, if the remaining RBs of the current RSU cannot satisfy the threshold, extra RBs from the VRP are allocated to user services. Similarly, for users connected to ARNs, the satisfaction grade of each user service is monitored considering both the QoS and the signal-to-noise plus interference (SINR) factors. If the satisfaction grade is higher than the predefined threshold value, the service requirements can be satisfied by the remaining RBs of the ARN. On the contrary, if the estimated satisfaction grade is lower than the predefined threshold value, the ARN borrows extra RBs from the LVRP of the corresponding RSU to achieve the required satisfaction grade. Performance evaluation shows that the suggested method optimizes the resource allocation and improves the performance of the offered services in terms of throughput, packet transfer delay, jitter and packet loss ratio, since the use of ARNs that obtain optimal positions improves the channel conditions observed from each vehicular user.

13 March 2022 in Future Internet
Verified
Journal Article
Open access
PDF file
IKIoannis Kosmopoulos
Ioannis Kosmopoulos
ESEmmanouil Skondras
Emmanouil Skondras
AMAngelos Michalas
Angelos Michalas
Emmanouel T. MichailidisEmmanouel T. Michailidis
Emmanouel T. Michailidis
DVDimitrios D. Vergados
Dimitrios D. Vergados
Fifth-Generation (5G) vehicular networks support novel services with increased Quality of Service (QoS) requirements. Vehicular users need to be continuously connected to networks that fulfil the constraints of their services. Thus, the implementation of optimal Handover (HO) mechanisms for 5G vehicular architectures is deemed necessary. This work describes a scheme for performing HOs in 5G vehicular networks using the functionalities of the Media-Independent Handover (MIH) and Fast Proxy Mobile IPv6 (FPMIP) standards. The scheme supports both predictive and reactive HO scenarios. A velocity and alternative network monitoring process prepares each vehicle for both HO cases. In the case of predictive HO, each time the satisfaction grade of the vehicular user drops below a predefined threshold, the HO is initiated. On the other hand, in the case of reactive HO, the vehicle loses the connectivity with its serving network and connects to the available network that has obtained the higher ranking from the network selection process. Furthermore, the HO implementation is based on an improved version of the FPMIPv6 protocol. For the evaluation of the described methodology, a 5G vehicular network architecture was simulated. In this architecture, multiple network access technologies coexist, while the experimental results showed that the proposed scheme outperformed existing HO methods.

17 December 2022 in Drones
Verified
Journal Article
Open access
PDF file
ESEmmanouil Skondras
Emmanouil Skondras
IKIoannis Kosmopoulos
Ioannis Kosmopoulos
Emmanouel T. MichailidisEmmanouel T. Michailidis
Emmanouel T. Michailidis
AMAngelos Michalas
Angelos Michalas
DVDimitrios D. Vergados
Dimitrios D. Vergados
Next generation mobile networks are expected to integrate multiple drones organized in Flying Ad Hoc Networks (FANETs) to support demanding and diverse services. The highly mobile drones should always be connected to the network in order to satisfy the strict requirements of upcoming applications. As the number of drones increases, they burden the network with the management of signaling and continuous monitoring of the drones during data transmission. Therefore, designing transmission mechanisms for fifth-generation (5G) drone-aided networks and using clustering algorithms for their grouping is of paramount importance. In this paper, a clustering and selection algorithm of the cluster head is proposed together with an efficient Group Handover (GHO) scheme that details how the respective Point of Access (PoA) groups will be clustered. Subsequently, for each cluster, the PoA elects a Cluster Head (CH), which is responsible for manipulating the mobility of the cluster by orchestrating the handover initiation (HO initiation), the network selection, and the handover execution (HO execution) processes. Moreover, the members of the cluster are informed about the impending HO from the CH. As a result, they establish new uplink and downlink communication channels to exchange data packets. In order to evaluate the proposed HO scheme, extensive simulations are carried out for a next-generation drone network architecture that supports Internet of Things (IoT) and multimedia services. This architecture relies on IEEE 802.11p Wireless Access for Vehicular Environment (WAVE) Road Side Units (RSUs) as well as Long-Term Evolution Advanced (LTE-A) and IEEE 802.16 Worldwide Interoperability for Microwave Access (WiMAX). Furthermore, the proposed scheme is also evaluated in a real-world scenario using a testbed deployed in a controlled laboratory environment. Both simulation and real-world experimental results verify that the proposed scheme outperforms existing HO algorithms.

20 May 2024
Verified
Book Chapter
Closed access
PDF file
TDTheodoros Dimitriou
Theodoros Dimitriou
ESEmmanouil Skondras
Emmanouil Skondras
CHChristos Hitiris
Christos Hitiris
CGCleopatra Gkola
Cleopatra Gkola
IPIoannis S. Papapanagiotou
Ioannis S. Papapanagiotou
DVDimitrios D. Vergados
Dimitrios D. Vergados