The origin of the hysteresis is investigated by electrochemical measurements,in situIR spectroscopy and simulations. It is concluded that the formation of platinum oxides rather than the formation of blocking intermediates causes the hysteresis.
Electrochemical macrokinetics contains the interaction of electrode reactions with transport phenomena. To disentangle the individual processes, dynamic techniques such as electrochemical impedance spectroscopy are widely used. Additional information can be obtained when further quantities besides current and potential are recorded. Here, we present and analyze a method to observe the dynamics of the flux of volatile species, i.e. mass transfer, in porous electrodes during electrochemical reactions with a high time resolution. We call this technique species frequency response analysis (sFRA). It is experimentally demonstrated with electrochemical methanol oxidation reaction on a porous Pt/Ru electrode. The dynamic relationship between current, potential and the flux of the gaseous reaction product CO2 is measured by differential electrochemical mass spectrometry. The resulting transfer function that relates current density with CO2 flux is analysed in detail by means of a one-dimensional mathematical model. It is demonstrated how the influence of reaction and transport phenomena can be separated in the sFRA Nyquist plot. Practical aspects such as sensitivity and accessible frequency range are discussed as well as the overall prospects and limitations of the technique.
In the present study, it is shown that the concentration dependency of undefined mixed culture anodic biofilms does not follow a single kinetic curve, such as the Nernst‐Monod curve. The biofilms adapt to concentration changes, which inevitably have to be applied to record kinetic curves, resulting in strong shifts of the kinetic parameters. The substrate concentration in a continuously operated bioelectrochemical system was changed rapidly via acetate pulses to record Nernst‐Monod curves which are not influenced by biofilm adaptation processes. The values of the maximum current density jmax and apparent half‐saturation rate constant Ks increased from 0.5 to 1 mA cm−2 and from 0.5 to 1.6 mmol L−1, respectively, within approximately 5 h. Double pulse experiments with a starvation phase between the two acetate pulses showed that jmax and Ks decrease reversibly through an adaptation process when no acetate is available. Pseudo‐capacitive charge values estimated from non‐turnover cyclic voltammograms (CV) led to the hypothesis that biofilm adaptation and the observed shift of the Nernst‐Monod curves occurred due to changes in the concentration of active redox proteins in the biofilm. It is argued that concentration‐related parameters of kinetic models for electroactive biofilms are only valid for the operating points where they have been determined and should always be reported with those conditions.
Electrocatalytic hydrogenation (ECH) of biomass derived compounds is an emerging technology for the production of biofuels. Herein, the ECH of furfural was investigated systematically on femtosecond laser‐structured copper electrodes, amending the work on commonly used bulk copper electrodes or electrodeposits. Laser‐structuring was used to vary the amount of active sites and the crystallographic orientation on the copper electrodes (evidenced with scanning electron microscopy and X‐ray diffraction), and to achieve nickel alloying with the structured copper surface. We showed that the production rate and the Faradaic efficiency for furfural ECH on both Cu (111) and Ni‐alloyed Cu were substantially increased. This improvement was ascribed to more catalytic sites offered for hydrogen and interactions of furanic intermediates. Moreover, the Ni‐alloyed Cu electrode enabled the stable production of 2‐methylfuran even at large overpotentials. The mechanistic insights gained could open up new pathways to produce sustainable biofuel candidates with more stable electrodes.