Concrete is prepared by substituting an equal volume of fly ash for fine aggregate, and the effect of substitution rate on its carbonation resistance is studied. Using a rapid carbonation test, the distribution law of the internal pH value of concrete with fly ash as fine aggregate (CFA) along the carbonation depth under different substitution rates (10%, 20%, 30%, and 40%) after carbonation is studied and compared with the test results of phenolphthalein solution. Then, to further clarify the damage mechanism of fly ash replacing fine aggregate on concrete carbonation, the changes in the pore structure and micromorphology of CFA after carbonation are studied by means of mercury intrusion pressure and electron microscope scanning tests. The results indicate that the carbonation depth of CFA increases gradually with increasing carbonation time. In particular, in the later stage of carbonation, the carbonation rate of concrete decreases significantly with an increase in the substitution rate. The carbonation depth XC of CFA measured by phenolphthalein solution is approximately 0.24–0.39 times of the complete noncarbonation depth measured by the pH method. The pH value test is a reliable test method that can reveal the carbonation mechanism of CFA. Carbonation can significantly reduce the proportion of more harmful holes in concrete with a large amount of fly ash, but it can also increase the proportion of less harmful and harmful holes. In general, the pore size distribution and micromorphology of concrete can be improved by replacing fine aggregates with fly ash.
Natural river sand resources are facing depletion, and large-scale mining pollutes the environment and harms humans. To utilize fly ash fully, this study used low-grade fly ash as a substitute for natural river sand in mortar. This has great potential to alleviate the shortage of natural river sand resources, reduce pollution, and improve the utilization of solid waste resources. Six types of green mortars were prepared by replacing different amounts of river sand (0, 20, 40, 60, 80, and 100%) with fly ash and other volumes. Their compressive strength, flexural strength, ultrasonic wave velocity, drying shrinkage, and high-temperature resistance were also investigated. Research has shown that fly ash can be used as a fine aggregate in the preparation of building mortar, thereby ensuring that green-building mortar has sufficient mechanical properties and better durability. The replacement rate for optimal strength and high-temperature performance was determined to be 80%.