Sources of anisotropy in metals are discusssed as well as ways of interpreting and modelling this behaviour. A number of case studies are presented relating to mechanical and magnetic properties.
The oxide growth rate of zirconium alloys, e.g., Zircaloy-2 and Zircaloy-4, has been proposed to be controlled mainly by the transformation of the zirconium oxide from tetragonal to monoclinic structure at some distance from the metal-oxide interface, leading to cracking. This oxide growth rate model is inconsistent with our results. Zirconium alloys of varying chemical composition but with identical manufacturing process had markedly different oxide growth and hydriding properties in autoclave testing (400°C steam). The materials were characterized by several methods, e.g., electron microscopy (SEM), X-ray diffraction (XRD), and electrochemical impedance (EIS). The SEM and some of the XRD investigations of the oxide were performed on the metal-oxide interface after dissolution of the metal. The oxide growth developed through three different stages with an altered oxide morphology at the metaloxide interface at each stage. The developments of the stages were correlated with the oxide growth rate. Impedance measurements suggested that the oxide film had three layers, the outermost being extensively porous. Relaxation of the oxide film stress showed that the compressive stress in the oxide was not essential for retention of a significant amount of the tetragonal phase.
The paper summarizes the creation of a robust online grain size gauge for a hot strip mill. A method and algorithm for calculating the grain size from the measured ultrasonic attenuation is presented. This new method is self-calibrating, does not rely on a geometrical reference sample and can cope with the effects of diffraction on the attenuation. The model is based on 52 quenched samples measured with more than 23,000 laser ultrasonics shots and has a correlation coefficient R2 of 0.8. Typical online laser ultrasonic measurements from the hot strip mill and the calculated grain size versus length are presented for a couple of steel strips.
Motors are essential components in electric vehicles and there are at present worldwide efforts to improve their efficiency and reduce their weight. One of these areas concerns improving the quality of steel laminations that are used for their magnetic properties in rotors and stators. These are ‘soft’ magnetically, meaning that they can be easily magnetised and demagnetised. Improvements in magnetic quality, i.e. reductions in power loss during magnetisation, have been pursued for many years but the high-speed motors in vehicles are also subject to greater mechanical loading, in particular in the rotors of IPM-machines (Internal Permanent Magnet rotor machines). These are the dominating type of electric motor for electrified vehicles due to their high efficiency and high power/torque density. As a result, there are increasing requirements for new steel products that combine low power losses with high strength. This is difficult because most ways of raising the strength result in the magnetic characteristics becoming also undesirably harder. The present paper starts with a consideration of how magnetic power losses are defined and the factors that influence these. Then, different strengthening methods are considered together with their effects on magnetisation. Strengthening can be achieved by (i) solid solution alloying, (ii) grain refinement, (iii) work hardening, (iv) precipitation and (v) texture control. Most commonly, the requirements are in conflict. Only solid solution strengthening can confer benefits to both strength and power loss although extremely fine nanoprecipitation can raise the strength with little or no magnetic detriment. Based on this analysis, results from research publications and patents are summarised and reviewed.