This work addresses environmental problems connected with biowaste management, the chemical industry, and agriculture. These sectors of human activity cause greenhouse gas (GHG) emissions in the air, climate change, leaching of excess mineral fertilizers applied to soil into ground water, and eutrophication. To mitigate this problem in agriculture, controlled release fertilizers (CRFs) are made by coating mineral fertilizers granules with synthetic polymers produced from the fossil-based chemical industry. This strategy aggravates GHG emission. In the present work, six formulations containing sunflower protein concentrate (SPC) and a new biopolymer (BP) obtained from sunflower oil cake and by hydrolysis of municipal biowaste, respectively, and commercial urea were tested as CRFs for spinach cultivation against the control growing substrate Evergreen TS and commercial Osmocote^®. The results show large differences in plants’ nitrate concentration due to the different treatments, although the same nitrogen amount is added to the substrate in all trials. BP is the key component mitigating nitrate accumulation in plants. The plants grown in the substrates containing BP together with SPC and/or urea, although exhibiting relatively high total N uptake (47–52 g kg⁻¹), have significantly lower nitric to total N ratio (9.6–12.0) than that (15.3–16.5) shown by the plants grown in the substrates containing SPC and/or urea, but no BP. The data confirm that all composites containing BP yield the safest crop coupled with high biomass production. Replication of BP effects for the cultivation of different plants will contribute to the development of a biobased chemical industry exploiting biowastes as feedstock.

Controlled-release fertilizers (CRF) are needed under current agriculture practice to decrease the environmental impact caused by fertilizer doses applied in excess of plants’ uptake rate. Commercial CRF are available. They are manufactured from mineral fertilizers encapsulated into a synthetic polymer matrix or coated by a polymer layer. However, substitution of fossil sourced organic polymers with biopolymers is a major environmental concern. In the present paper, we describe the manufacture by a continuous twin-screw extrusion process, and the mechanical and chemical properties of injection-molded composite pellets containing 90% sunflower protein concentrate (SPC) matrix, and 5–10% of a biopolymer (BP) obtained from municipal biowastes (MBW), and/or urea (U). The reported results show that SPC-BP-U behaves as an efficient eco-friendly CRF. BP contributes to several benefits to the performance of the composite pellets, upon increasing surface hardness, and controlling the formation of ammonia from urea hydrolysis and the release of organic nitrogen. The SPC-BP-U appears a powerful eco-friendly CRF to supply organic C and the three major N, P, and K nutrients to soil and plants. It offers worthwhile scope for being tested in the cultivation of specific plants under the real operational conditions of agriculture practices.

A computational tool is developed for the estimation of the energy requirements of Miscanthus x giganteus on individual fields that includes a detailed analysis and account of the involved in-field and transport operations. The tool takes into account all the individual involved in-field and transport operations and provides a detailed analysis on the energy requirements of the components that contribute to the energy input. A basic scenario was implemented to demonstrate the capabilities of the tool. Specifically, the variability of the energy requirements as a function of field area and field-storage distance changes was shown. The field-storage distance highly affects the energy requirements resulting in a variation in the efficiency if energy (output/input ratio) from 15.8 up to 23.7 for the targeted cases. Not only the field-distance highly affects the energy requirements but also the biomass transportation system. Based on the presented example, different transportation systems adhering to the same configuration of the production system creates variation in the efficiency of energy (EoE) between 12.9 and 17.5. The presented tool provides individualized results that can be used for the processes of designing or evaluating a specific production system since the outcomes are not based on average norms.