Rômulo Marçal Gandia

Dr. Rômulo Marçal Gandia

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2019 in Engenharia Agrícola
Verified
Journal Article
Open access
PDF file
RGRômulo Marçal Gandia
Rômulo Marçal Gandia
ACAndrea A. R. Corrêa
Andrea A. R. Corrêa
FGFrancisco C. Gomes
Francisco C. Gomes
Diego MarinDiego Marin
Diego Marin
Lucas SantanaLucas Santana
Lucas Santana
Adobe is an efficient construction material for several reasons, such as its thermal comfort, sustainability, and lower energy cost, as well as the simplicity of its production and execution. However, challenges such as water absorption, capillarity, and compressive strength should be investigated to improve its physical and mechanical properties. “Synthetic termite saliva” (STS) is an excellent stabilizer with high cohesive and hydrophobic power. Therefore, the objective of this work was to evaluate the effects of STS incorporation into adobe, analyzing its physical, mechanical and thermal properties. Five treatments were studied: 0 (control); 0.1; 0.2; 0.4 and 0.8% STS by mass. These adobe samples were evaluated according to bulk density, linear shrinkage, capillarity, water absorption, thermal conductivity and compressive strength, according to Norma Técnica de Edificación (NTE) E0.80 testing using a new methodology. Linear shrinkage decreases from 2.7 to 1.91 cm with 0.4% STS. Capillarity decreases with the increasing amounts of STS. Water absorption decreased from 12.03 to 6.31% using 0.4% STS, and its mass was reduced from 779 to 19 grams. The thermal conductivity showed no differences between concentrations. The compressive strength was reduced but was still acceptable based on NTE E.080. The stabilization of the adobe using STS showed an improvement in its physical properties, mainly due to its hydrophobic power.

1 April 2019 in Revista Ceres
Verified
Journal Article
Open access
PDF file
Diego MarinDiego Marin
Diego Marin
MAMarcelo De Carvalho Alves
Marcelo De Carvalho Alves
EPEdson Ampélio Pozza
Edson Ampélio Pozza
RGRômulo Marçal Gandia
Rômulo Marçal Gandia
MCMatheus Luiz Jorge Cortez
Matheus Luiz Jorge Cortez
MMMatheus Campos Mattioli
Matheus Campos Mattioli
RESUMO O sensoriamento remoto multiespectral apresenta-se como metodologia confiável e viável para auxiliar o produtor na decisão para melhores práticas de manejo, garantindo uma produção agrícola mais eficiente e sustentável. Objetivou-se, com este trabalho, identificar e mapear o estresse em lavoura cafeeira, causado por variáveis bióticas e abióticas, por meio de índices de vegetação derivados de imagens multiespectrais Landsat-5 Thematic Mapper (TM). A malha amostral foi composta por 67 pontos, sendo cada ponto amostral constituído por cinco plantas. As análises de incidência de cercosporiose e de infestação do bicho-mineiro, nas folhas, de pH, matéria orgânica e textura do solo e teores foliares de nutrientes foram realizadas em cada um dos pontos amostrais e correlacionadas com 16 índices de vegetação obtidos de imagens referentes à época das análises. Os índices de vegetação apresentaram distribuição espacial semelhante à distribuição espacial das variáveis agronômicas, na lavoura. Houve correlação positiva dos índices com a infestação do bicho-mineiro e com os teores de silte e argila no solo e concentrações de Mg, Cu, B e Mn nas folhas, e negativa, com a incidência de cercosporiose e com pH e teor de areia do solo. Com base nesses resultados, foi possível mapear e identificar as alterações na reflectância espectral dos cafeeiros, causadas por essas variáveis agronômicas.

29 March 2022 in Agronomy
Verified
Journal Article
Open access
PDF file
RGRômulo Marçal Gandia
Rômulo Marçal Gandia
WPWisner Coimbra de Paula
Wisner Coimbra de Paula
EJEstácio Antunes de Oliveira Junior
Estácio Antunes de Oliveira Junior
GRGerardo Hernández Rodrigo
Gerardo Hernández Rodrigo
ÁPÁngel Ruiz Padín
Ángel Ruiz Padín
PRPedro José Aguado Rodríguez
Pedro José Aguado Rodríguez
Silos are used worldwide to store granular and powdered materials. Agricultural, food and feed products are commonly stored in silos. However, many questions remain unanswered about how to estimate the pressures applied by the bulk material, which are needed to design and calculate the structure of the silo. The complexity of the laws that govern the mechanical behavior of the stored material along with the low number of experimental stations in the world hinder progress in this field. The aim of this study was to elucidate the relationship of the hopper angle, flow pattern and vertical stress at the cylinder-to-hopper transition in slender silos. Therefore, a set of experiments was conducted on a test station to measure the vertical stress produced by maize at the cylinder-to-hopper transition. Five different hopper angles were used. The experiments comprised the filling, the static phase and the discharge. The results obtained show that the hopper angle influences the vertical stress at the cylinder-to-hopper transition. Some bottom configurations (flat bottom and bottom with an angle of 30°) led to vertical stresses that exceeded the value calculated according to Eurocode 1. It is clear that further experimental studies are still necessary to understand the underlying physical phenomena and the relations between pressures, silo geometry and flow pattern of the stored material.

1 December 2019 in Engenharia Agrícola
Verified
Journal Article
Open access
PDF file
RGRômulo Marçal Gandia
Rômulo Marçal Gandia
FGFrancisco C. Gomes
Francisco C. Gomes
ACAndréa A. R. Corrêa
Andréa A. R. Corrêa
MRMaykmiller C. Rodrigues
Maykmiller C. Rodrigues
Diego MarinDiego Marin
Diego Marin
The need for treated water is essential for life. With the constant increase in population, the most common way to purify surface water is through conventional water treatment plants (WTPs). The high volume of residue (sludge) generated in this process is most often returned to the catchment site, negatively affecting the ecosystem. The sludge of WTPs is similar to soil because it is composed of inorganic solids. Adobe is a construction material made from water and soil without the burning process, so it is considered sustainable, recyclable, and energy-efficient and can be stabilized with various materials. Therefore, the objective of this work is to develop adobes using the sludge of WTPs and to analyse their physical, mechanical and thermal properties. Adobes were produced with five concentrations of sludge by mass: 0, 1, 3, 5 and 7%. It was observed that with the increase in the sludge concentration, there was an increase in the capillarity and a decrease in mass, the water absorption was limited to 3% of sludge, and there was an increase in the bulk density. The linear shrinkage, thermal conductivity and compressive strength were not influenced. The addition of WTP sludge altered some properties of adobe. The use of WTP sludge in adobe is limited to 3%; above that, the adobe becomes unstable in relation to water. Therefore, the use of WTP sludge in the manufacture of adobe is feasible in controlled concentrations and is a sustainable use of the residue.

1 January 2019 in Brazilian Archives of Biology and Technology
Verified
Journal Article
Open access
PDF file
GSGabriela Rezende de Souza
Gabriela Rezende de Souza
LOLuiz Fernando Coutinho de Oliveira
Luiz Fernando Coutinho de Oliveira
IBItaloema Pinheiro Bello
Italoema Pinheiro Bello
LSLuciene Alves Batista Siniscalchi
Luciene Alves Batista Siniscalchi
RFRonaldo Fia
Ronaldo Fia
RGRômulo Marçal Gandia
Rômulo Marçal Gandia
The aim of this work is to evaluate the performance of upflow anaerobic fixed bed reactors filled with espresso coffee capsules to treat sanitary sewage. Three reactors (R1, R2 and R3) were constructed in blue PVC pipes measuring 30 cm height and 150 mm diameter and filled with coffee capsules made of aluminum and plastic. The sewage from the pre-treatment phase of the wastewater treatment plant of the Federal University of Lavras fed the system. Temperature, pH, alkalinity and volatile acids concentration, COD, TS, TVS and TSS of the influent and effluent were analyzed to evaluate the reactors performances. Statistics tests were run in the software Statistica 10. Changes occurred in the organic loading rates caused two different operating phases, one at an OLR of 2.1 kg COD m-3d-1 and another at 4.0 kg COD m-3d-1. The average temperature during the monitoring period was 18°C. In spite of the operating conditions variations, the reactors showed satisfactory performances, presenting COD efficiency removals up to 80% in both phases. The capsules characteristics were similar to other materials used as support. Hence, it is possible to utilize coffee capsules as support material in anaerobic reactors, providing satisfactory pollutants removal efficiencies.

1 December 2021 in Engenharia Agrícola
Verified
Journal Article
Open access
RGRômulo Marçal Gandia
Rômulo Marçal Gandia
EJEstácio A. de Oliveira Júnior
Estácio A. de Oliveira Júnior
FGFrancisco C. Gomes
Francisco C. Gomes
WPWisner C. de Paula
Wisner C. de Paula
KDKaroline C. Dornelas
Karoline C. Dornelas