The integration of renewable energy sources (RESs) is a strategic goal in Saudi Arabia. The energy source diversification plan comprises the penetration of various technologies, including solar photovoltaic (PV) and wind energy. In this research, an optimal microgrid system design is proposed and analyzed at the Islamic University of Madinah. The research intends to facilitate the decision-making process in the incorporation of RESs in Saudi universities. A pilot project has been established at the Faculty of Engineering and the measured load profile has been incorporated. Three alternatives are investigated, and their technical and economic performance is determined (i.e., PV system, wind system, and hybrid system). To enhance the accuracy of the simulated models, on-the-ground weather data have been utilized to formulate a typical meteorological year profile. The results demonstrate that a PV system of 1.5 MW installed capacity can cover up to 3.03% of the university’s annual electrical consumption, with a levelized cost of energy (LCOE) of 0.051 USD/kWh. The PV alternative can generate annual energy of 2.68 GWh with a capacity factor of 20.2% and a simple payback period of 18.6 years. The wind energy system has a capacity factor of 1.1 MW and yields a higher ratio of energy production to installed capacity, owing to a higher capacity factor at 29.5%, and annual energy of 2.71 GWh. However, due to the higher initial cost and insufficiency of wind resources at the proposed location, this wind energy alternative results in higher LCOE at 0.064 USD/kWh and a simple payback period of 23.6 years. The hybrid alternative facilitates the integration of diverse RESs. It has a capacity factor of 1.37 MW, leading to an annual generation of 3.27 GWh and a renewable fraction of 3.7%. The LCOE of the hybrid option is determined to be 0.061 USD/kWh and the simple payback period at 20.7 years. All alternatives help in the reduction of carbon dioxide (CO₂), sulfur dioxide (SO₂), and nitric oxide (NO_x) between 0.11 million kg and 54.6 million kg annually. Each of the systems can provide opportunities at the technical, economic, and environmental levels. The implications of this research facilitate Saudi universities in supporting the integration of RESs, considering the strategic goals of Saudi Arabia.

This paper presents a proposed fuzzy energy management strategy developed for a battery−super capacitor electric vehicle. In addition to providing different driving modes, the proposed strategy delivers the suitable type and amount of power to the vehicle. Furthermore, the proposed strategy takes into account possible failures in vehicle power sources. The speed and torque of the HEV traction machine are simultaneously controlled using a genetic algorithm that provides simultaneous tuning via the use of newly proposed cost functions that give the designer the ability to tradeoff and prioritize between the design variables to be minimized. The simulation results show that the intelligent speed and torque control and the fuzzy power management strategy improved the vehicle’s performance in terms of ripple minimization. The real-time simulation is conducted using the RT LAB simulator, and the results obtained correspond to those obtained in the numerical simulation using MATLAB/Simulink.

In this paper, the dynamic combined economic environmental dispatch problems (DCEED) with variable real transmission losses are tackled using four metaheuristics techniques. Due to the consideration of the valve-point loading effects (VPE), DCEED have become a non-smooth and more complex optimization problem. The seagull optimization algorithm (SOA), crow search algorithm (CSA), tunicate swarm algorithm (TSA), and firefly algorithm (FFA), as both nature and biologic phenomena-based algorithms, are investigated to solve DCEED problems. Our proposed algorithms, SOA, TSA, and FFA, were evaluated and applied on the IEEE five-unit test system, and the effectiveness of the proposed CSA approach was applied on two-unit, five-unit, and ten-unit systems by considering VPE. We defined CSA for different objective functions, such as cost of production, emission, and CEED, by considering VPE. The obtained results reveal the efficiency and robustness of the CSA compared to SOA, TSA, FFA, and to other optimization algorithms reported recently in the literature. In addition, Matlab simulation results show the advantages of the proposed approaches for solving DCEED problems.

This work suggests a type-2 fuzzy lead–lag (T2FLL) controller structure for flexible AC transmission system (FACTS)-based damping controllers and power system stabilizers (PSSs) for power system stability improvement. The values of the suggested controller are optimized by a hybrid adaptive differential evolution and pattern search algorithm (hADE-PS) method. Initially, a single-machine infinite-bus (SMIB) system with lead–lag (LL)-structured FACTS and PSS controllers is considered, and the dominance of the hADE-PS method is established over the original differential evolution (DE), genetic algorithm (GA), and particle swarm optimization (PSO). The supremacy of T2FLL over the lead–lag (LL) controller is established under different large and small disturbance conditions, as well as varied loading conditions and fault positions. Lastly, the effectiveness of T2FLL is evaluated in a multimachine power system (MMPS). It is demonstrated that the suggested T2FLL offers better performance than the LL controller under various large and small disturbance conditions by providing significantly more damping to all modes of oscillations.

With power demands continuously growing, the penetration of renewable energy resources, particularly solar photovoltaic (PV) systems, across the residential sector has been extensive. A voltage source inverter (VSI) is the key element for efficiently processing energy conversion and connecting PV systems to home loads or utility grids. The operation of this inverter relies heavily on power-switching devices, which suffer from larger power losses due to the conventional semiconductors used based on silicon (Si) material. The new materials of wide bandgap (WBG) semiconductors, for example, gallium nitride (GaN) and silicon carbide (SiC), provide remarkably distinct characteristics of semiconductor devices to minimize power loss and boost the inverter’s operational capabilities. This research paper assesses the effects of integrating SiC-MOSFET devices into VSIs in order to improve the switching behavior and efficiency level. An experimental double-pulse testing (DPT) circuit was configured and set up for investigating the switching characterization of SiC-MOSFETs compared to the widely used Si-IGBTs. Under various operating circumstances, the switching behavior of two different types of power transistors was tested while their turning-on and turning-off losses were measured. The VSI based on SiC and Si transistors was simulated to examine the performance of the inverter. The results reveal that incorporating SiC-MOSFETs into the VSI substantially enhances the switching operation and reduces total power losses while increasing the efficiency compared to the inverter based on Si-IGBTs.

Growing demand, interconnection of multiple systems, and difficulty in upgrading existing infrastructures are limiting the capabilities of conventional computational tools employed in power system analysis. Recent studies manifest the importance of efficiently solving well- and ill-conditioned Power-Flow cases in a modern power-system paradigm. While the well-conditioned cases are easily solvable using standard methods, the ill-conditioned ones suppose a challenge for such solvers. In this regard, methods based on the Continuous Newton’s principle have demonstrated their ability to address ill-conditioned cases with acceptable efficiency. This paper demonstrates that the approaches proposed so far do not extract the best numerical properties of such solvers. To fill this gap, an optimization framework is proposed by which the parameters involved in the two-stage Runge–Kutta-based solvers are appropriately set, so that the stability and convergence order of the numerical mapping are maximized. By using the developed optimization technique, three solvers with quadratic, cubic, and 4th order of convergence are developed. The new proposals are tested on a variety of large-scale ill-conditioned cases. Results obtained were promising, outperforming other conventional and robust approaches.