Hybrid wire arc additive-milling subtractive manufacturing (HWMM) is an effective way to improve the quality of complex metal components, but the difference in the properties of the aluminum alloy and magnesium alloy fabricated by HWMM has been not addressed. In the paper, the differences in deposition accuracy and tensile anisotropy between the Al5Si Al and AZ31B Mg alloys were studied by using the HWMM method. Under the optimal parameters, the minimum surface roughness of the AZ31B sample was 146.1 μm, which was 90% higher than for the Al5Si sample. The differences in the tensile strength and elongation of the AZ31B sample were 32% and 56%, respectively, being 6 and 3.3 times higher than those of the Al5Si samples. According to the fracture behavior of the samples, the tensile anisotropy of both alloys was mainly attributed to defects such as incomplete fusion and porosity in the fusion line. However, there was obvious structural inhomogeneity in AZ31B samples, where the grain size difference between adjacent areas reached 40%. This led to the easier fracture of AZ31B samples. These results contribute to our understanding of the HWMM of light alloys.

Oscillating laser welding is potential to improve the quality of aluminum alloy joints, but has been seldom addressed on lock butt joint. In this paper, the effects of beam oscillation frequencies (f) on the properties of laser-welded 5A06 aluminum alloy lock butt joints were investigated, especially those at the lock step. In the microstructure, the columnar grain zone (CGZ) near the fusion line narrowed, the porosity was reduced, and the angle between lock step and fusion line increased with the increase of f. Correspondingly, the fracture changed from equiaxed grain zone to heat affected zone (HAZ), and the fracture angle between lock step and crack propagation line from 90° to 45°. The maximum ultimate tensile strength and elongation of oscillating weld reached 308 MPa and 18.2%, respectively, 36.3% and 203.3% higher than non-oscillating weld. The fracture behaviors indicated that the crack always initiated at the lock step, and then preferably propagated to the pores, followed closely by the weaker CGZ, and then the stronger HAZ when CGZ was narrowed enough. Notably, when the pore size was small (<0.39 mm) and located below the lock step, the pore was not on the crack propagation path. The crack tended to propagate towards the weaker CGZ. Finally, the fracture mechanism was discussed. The results clarify the fracture mechanism of oscillating laser-welded lock butt joints and contribute to the development of oscillating laser welding.