Very few real-world measurements of road dust suspension have been performed to date. This study compares two different techniques (referred to as Sniffer and Emma) to measure road dust emissions. ...
Traffic-related pollution is a major concern in urban areas due to its deleterious effects on human health. The characteristics of the traffic emissions on four highway environments in the Helsinki metropolitan area were measured with a mobile laboratory, equipped with state-of-the-art instrumentation. Concentration gradients were observed for all traffic-related pollutants, particle number (CN), particulate mass (PM1), black carbon (BC), organics, and nitrogen oxides (NO and NO2). Flow dynamics in different environments appeared to be an important factor for the dilution of the pollutants. For example, the half-decay distances for the traffic-related CN concentrations varied from 8 to 83 m at different sites. The PM1 emissions from traffic mostly consisted of organics and BC. At the most open site, the ratio of organics to BC increased with distance to the highway, indicating condensation of volatile and semi-volatile organics on BC particles. These condensed organics were shown to be hydrocarbons as the fraction of hydrocarbon fragments in organics increased. Regarding the CN size distributions, particle growth during the dilution was not observed; however the mass size distributions measured with a soot particle aerosol mass spectrometer (SP-AMS), showed a visible shift of the mode, detected at ∼ 100 nm at the roadside, to a larger size when the distance to the roadside increased. The fleet average emission factors appeared to be lower for the CN and higher for the NO2 than ten years ago. The reason is likely to be the increased fraction of light-duty (LD) diesel vehicles in the past ten years. The fraction of heavy-duty (HD) traffic, although constituting less than 10 % of the total traffic flow, was found to have a large impact on the emissions.
18 December 2015 in Environmental Science & Technology
A high concentration of volatile nucleation mode particles (NUP) formed in the atmosphere when the exhaust cools and dilutes has hazardous health effects and it impairs the visibility in urban areas. Nucleation mechanisms in diesel exhaust are only poorly understood. We performed model studies using two sectional aerosol dynamics process models AEROFOR and MAFOR on the formation of particles in the exhaust of a diesel engine, equipped with an oxidative after-treatment system and running with low fuel sulfur content (FSC) fuel, under laboratory sampling conditions where the dilution system mimics real-world conditions. Different nucleation mechanisms were tested. Based on the measured gaseous sulfuric acid (GSA) and non-volatile core and soot particle number concentrations of the raw exhaust, the model simulations showed that the best agreement between model predictions and measurements in terms of particle number size distribution was obtained by barrier-free heteromolecular homogeneous nucleation between the GSA and a semi-volatile organic vapour combined with the homogeneous nucleation of GSA alone. Major growth of the particles was predicted to occur due to the similar organic vapour at concentrations of (1−2) × 1012 cm−3. The pre-existing core and soot mode concentrations had an opposite trend on the NUP formation, and the maximum NUP formation was predicted if a diesel particle filter (DPF) was used. On the other hand, the model predicted that the NUP formation ceased if the GSA concentration in the raw exhaust was less than 1010 cm−3, which was the case when biofuel was used.
Traffic is a major source of ultrafine aerosol particles in urban environments. Recent studies show that a significant fraction of traffic-related particles are only few nanometers in diameter. Here, we study the dispersion of this nanocluster aerosol (NCA) in the size range 1.3–4 nm. We measured particle concentrations near a major highway in the Helsinki region of Finland, varying the distance from the highway. Additionally, modelling studies were performed to gain further information on how different transformation processes affect NCA dispersion. The roadside measurements showed that NCA concentrations fell more rapidly than the total particle concentrations, especially during the morning. However, a significant amount of NCA particles remained as the aerosol population evolved. Modelling studies showed that, while dilution is the main process acting on the total particle concentration, deposition also had a significant impact. Condensation and possibly enhanced deposition of NCA were the main plausible processes explaining why dispersion is faster for NCA than for total particle concentration, while the effect of coagulation on all size ranges was small. Based on our results, we conclude that NCA may play a significant role in urban environments, since, rather than being scavenged by larger particles, NCA particles remain in the particle population and grow by condensation.
Marine traffic in harbors can be responsible for significant atmospheric concentrations of ultrafine particles (UFPs), which have widely recognized negative effects on human health. It is therefore essential to model and measure the time evolution of the number size distributions and chemical composition of UFPs in ship exhaust to assess the resulting exposure in the vicinity of shipping routes. In this study, a sequential modelling chain was developed and applied, in combination with the data measured and collected in major harbor areas in the cities of Helsinki and Turku in Finland, during winter and summer in 2010–2011. The models described ship emissions, atmospheric dispersion, and aerosol dynamics, complemented with a time–microenvironment–activity model to estimate the short-term UFP exposure. We estimated the dilution ratio during the initial fast expansion of the exhaust plume to be approximately equal to eight. This dispersion regime resulted in a fully formed nucleation mode (denoted as Nuc2). Different selected modelling assumptions about the chemical composition of Nuc2 did not have an effect on the formation of nucleation mode particles. Aerosol model simulations of the dispersing ship plume also revealed a partially formed nucleation mode (Nuc1; peaking at 1.5 nm), consisting of freshly nucleated sulfate particles and condensed organics that were produced within the first few seconds. However, subsequent growth of the new particles was limited, due to efficient scavenging by the larger particles originating from the ship exhaust. The transport of UFPs downwind of the ship track increased the hourly mean UFP concentrations in the neighboring residential areas by a factor of two or more up to a distance of 3600 m, compared with the corresponding UFP concentrations in the urban background. The substantially increased UFP concentrations due to ship traffic significantly affected the daily mean exposures in residential areas located in the vicinity of the harbors.