The paper presents an experimental study on the effect of plastic fines content on the undrained behavior and liquefaction susceptibility of sand–fines mixtures under monotonic loading. The results of undrained monotonic triaxial compression tests conducted on mixtures of Hostun sand with varying amount (0–20%) and type (kaolin and calcigel bentonite) of plastic fines are presented. The specimens were prepared with different initial densities using the moist tamping method and consolidated at two different isotropic effective stresses. The results demonstrate that for both types of plastic fines, an increase in the fines content leads to a more contractive response and lower values of mobilized deviatoric stress. Despite similar relative density and fines content, the sand–kaolin mixtures showed a more contractive behavior than the sand–calcigel specimens. The steady-state lines (SSLs) ine–p´ space generally move downwards with increasing clay content. While the slopes of the SSLs for the clean Hostun sand and the mixtures with 10 and 20% kaolin are quite similar, the SSL lines for the specimens containing 10% or 20% calcigel run steeper or flatter, respectively. The inclination of the SSL in theq–p′ plane was found independent of clay type and content. The sand–kaolin mixtures were observed to be more susceptible to instability and flow liquefaction than the sand–calcigel mixtures.
1 September 2017 in Journal of Geotechnical and Geoenvironmental Engineering
There are some attempts to evaluate Hardin’s equation for transition soils, i.e., sand mixed with a systematic increase of fines ( ) content, . The most common finding is that maxmium shear modulus, , decreases with increasing , and there are attempts to capture the effect of on by considering of clean sand as a reference. These are done by (1) developing empirical relations of , , , or with ; (2) using equivalent granular void ratio, , instead of void ratio, in Hardin’s equation; and (3) using a critical state (CS) approach. This paper presents 288 resonant column data for clean Hostun sand and Hostun sand mixed with 5, 10, 20, and 30% nonplastic quartz powder. It is found that when in a pre-established Hardin equation for clean Hostun sand is replaced by , Hardin’s equation can predict for Hostun sand with with good accuracy. Only soil grading properties, e.g., and , are required as inputs to convert to . This is a significant advantage over a recently proposed CS approach which requires critical state lines (CSLs) data for each .
12 July 2022 in Rock Mechanics and Rock Engineering
The paper presents an experimental study on the effect of plastic fines content on the undrained behavior and liquefaction susceptibility of sand-fines mixtures under cyclic loading. The results of undrained cyclic triaxial tests conducted on mixtures of Hostun sand with varying amounts (0–20%) and types (kaolin and calcigel bentonite) of plastic fines are presented. The specimens were prepared with different initial densities using the moist tamping method, consolidated at the same isotropic effective stress of 100 kPa and subjected to different deviatoric stress amplitudes. From the experimental observations, it was found that sand-clay mixtures with 10% or 20% clay content showed a lower cyclic liquefaction resistance than pure sand. Furthermore, the reduction in the cyclic stress ratio resulting in liquefaction after twenty cycles was found larger for sand-kaolin mixtures than for the sand-calcigel ones. Possible explanations are provided.
Discrete randomly distributed fibers are commonly used to improve the engineering characteristics of the soil and thus soil properties such as shear strength, compressibility, density, and hydraulic conductivity. Most studies have so far focused on describing the behavior of soils containing randomly distributed fibers under dried or saturated conditions. However, the water table may seasonally fluctuate, thus generating unsaturated soil conditions. Therefore, a better understanding of the hydro-mechanical properties of unsaturated improved soils is of high necessity. In this research, the shear strength parameters of fine-grained soils were evaluated using the biaxial device available at Ruhr Universität Bochum. The applied device was modified to test unsaturated fine-grained soils with various degrees of saturation using axis translation and vapor equilibrium techniques. The experiments were conducted on fine soils containing 0, 0.5, and 1% fiber contents under a wide range of matric suctions. The ductile behavior was more noticeable in samples with lower suctions and higher straw contents. Furthermore, the shear strength of both unreinforced and reinforced fine-grained soils considerably increased by an increase in the suction. Finally, shear band inclination increased by the suction while decreasing by straw content.