Johan Joubert

Prof. Johan Joubert

orcid

Research Focus & Metrics

Academic Career Length

36Years (1991-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 October 2011 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Open access
JJJohan Joubert
Johan Joubert
JVJ. C. Vardaxoglou
J. C. Vardaxoglou
WWWilliam G. Whittow
William G. Whittow
JOJohann W. Odendaal
Johann W. Odendaal
A low profile coplanar waveguide (CPW) fed printed slot antenna is presented with uni-directional radiation properties. The slot antenna radiates above a closely spaced artificial magnetic conducting (AMC) reflector consisting of an array of rectangular patches, a substrate and an electric ground plane. The electromagnetic bandgap (EBG) performance of the cavity structure between the upper conducting surface in which the slot is etched, and the ground plane at the bottom of the reflector, is investigated using an equivalent waveguide feed in the place of a half-wavelength section of the slot antenna. From the reflection coefficient of the equivalent waveguide feed one can determine the frequency band where minimum energy will be lost due to unwanted radiation from the cavity sides. The dimensions of the cavity were found to be very important for minimum energy loss. Experimental results for the final antenna design (with a size of 1.02λ0×0.82λ0×0.063λ0), mounted on a 1.5λ0×1.5λ0 back plate, exhibit a 5% impedance bandwidth, maximum gain in excess of 10 dBi, low cross-polarization, and a front-to-back ratio of approximately 25 dB. This low-profile antenna with relatively high gain could be a good candidate for a 2.4 GHz WLAN application.

18 July 2012 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
BJBennie Jacobs
Bennie Jacobs
JOJohann W. Odendaal
Johann W. Odendaal
JJJohan Joubert
Johan Joubert
It is a well known fact that the traditional 1-18 GHz double ridge guide horn (DRGH) antenna suffers from pattern deterioration above 12 GHz. At these frequencies, instead of maintaining a single main lobe radiation pattern, the pattern splits up into four lobes. It was shown in the literature that higher order modes are causing the pattern breakup. A benchmark study is performed to establish the performance of typical current and historic 1-18 GHz DRGH antennas. The performance of the antennas are evaluated in terms of gain, VSWR and radiation patterns. An improved 1-18 GHz DRGH antenna is presented. The new design has better gain and VSWR performance without any pattern deterioration. It also consists of significantly fewer parts, reducing the possibility of performance deterioration due to gaps between parts. Two prototypes of the new design were manufactured and tested with excellent agreement between measured and simulated results. The aperture dimensions of the new design are identical to that of the traditional DRGH, making it the only 1-18 GHz DRGH without pattern breakup whose aperture dimensions comply with the requirements specified in MIL-STD-461F - 24.2 by 13.6 cm.

10 July 2009 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
WPWarren Paul du Plessis
Warren Paul du Plessis
JOJ. W. Odendaal
J. W. Odendaal
JJJohan Joubert
Johan Joubert
An extended and rigorous analysis of retrodirective cross-eye jamming in a radar system scenario is presented. This analysis removes the approximations that limit the validity of other analyses of cross-eye jamming. These results imply that under certain conditions, a monopulse radar system can be more easily deceived than suggested by conventional cross-eye analyses. Furthermore, the cross-eye jammer antenna patterns do not affect the induced monopulse error.

9 July 2003 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
GMG. Mayhew-Ridgers
G. Mayhew-Ridgers
JOJ.W. Odendaal
J.W. Odendaal
JJJohan Joubert
Johan Joubert
In this paper, it is shown how a single-layer capacitive feeding mechanism, consisting of a small rectangular probe-fed patch, which is capacitively coupled to the radiating element, can be used to obtain wideband operation for probe-fed microstrip antennas on thick substrates. The main advantages of this feeding mechanism are that all the elements reside on a single layer and that it is very easy to fine-tune the input impedance. Calculated as well as measured results for rectangular, circular and annular-ring geometries are included.

26 May 2016 in IEEE Antennas and Wireless Propagation Letters
Verified
Journal Article
Closed access
MRMarno van Rooyen
Marno van Rooyen
JOJohann W. Odendaal
Johann W. Odendaal
JJJohan Joubert
Johan Joubert
This letter presents a dual-band slot antenna with high gain for wireless local area network (WLAN) and Worldwide Interoperability for Microwave Access (WiMAX) communication covering the IEEE802.11a/b and IEEE802.16d/e standards. The antenna consists of a microstrip-fed slot with a complimentary stub on a single dielectric medium. A reflecting ground plane is employed to achieve a unidirectional radiation pattern with an average gain of 9.1 dBi. The feed of the antenna is optimized to achieve radiation efficiency above 95% in the WLAN and WiMAX frequency bands. The radiation properties of a prototype antenna were measured in a compact antenna range. Simulated and measured results (impedance bandwidth, gain, and radiation patterns) are presented for the proposed antenna.

8 October 2007 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
CDChristof Dohmen
Christof Dohmen
JOJohann W. Odendaal
Johann W. Odendaal
JJJohan Joubert
Johan Joubert
Adaptive array theory is applied to a conformal antenna array to synthesize a main beam with optimized polarization employing dual polarized patch antennas as radiators. The required polarization in the main beam region of the array is realized by combining the weighted individual feeding ports of the patch antennas before the beam forming optimization is performed. This significantly reduces the number of unknowns in the beam forming optimization problem compared to previous optimization schemes for conformal arrays with optimized polarization properties. A numerical example for an array of dual fed linear patch antennas conformal to a spherical surface is presented. Measured pattern data for the patches are used to synthesize a main beam with specific linear polarization.