Intertidal sediments are rich in biological resources, which are important for material circulation and energy exchange. Meanwhile, these areas can be treated as sinks as well as sources of coastal heavy metal pollutants. Due to the influence of the tide, the intertidal sediments are in a state of periodic flooding and exposure, and environmental factors such as dissolved oxygen, salinity and overlying water pressure are changeable. Heavy metals in sediments are prone to migration and transformation with the dynamic effects of tidal water and the changes in the environment factors, which increase the bioavailability of heavy metals. In this review, the characteristics of distribution and the bioavailability of heavy metals in intertidal sediments are described; the migration and transformation behavior of heavy metals and its influencing factors under tidal conditions are analyzed; and the mechanisms of heavy metal’s migration and transformation in the intertidal zone are summarized. Moreover, the bioaccumulation of heavy metal by organisms and the remediation techniques are discussed. Therefore, this review systematically summarizes the states of existence, the transport mechanisms, and the fate of heavy metals in the intertidal sediment, fills in the research gap of the cycling of heavy metal in the intertidal zone, and provides a theoretical basis for the control of heavy metal pollution.
In this pilot study, the performance of an “ultrafiltration (UF) + nanofiltration (NF)” advanced treatment process in improving drinking water quality was investigated. The membrane performance and effluent qualities of three commercial NF membranes (Dow Filmtec NF270-400, VONTRON TAPU-LS, and GE Osmonics-HL8040F 400) were evaluated, and the reasons for the difference in effluent quality of these three NF membranes were analyzed. The results showed that UF as a pretreatment process could provide NF with stable and qualified influent. After passing through the UF unit, the turbidity of raw water decreased by 88.6%, and the SDI value was less than 3. Due to the small pore size of NF membranes, organics and polyvalent ions in raw water were further removed. With a water recovery of 90%, the conductivity, chemical oxygen demand (CODMn), and hardness of NF effluent are significantly improved. The three commercial NF membranes showed different performance advantages. Among them, Dow Filmtec NF270-400 had the best desalting performance, VONTRON TAPU-LS had the highest retention rate of organic matter, and GE Osmonics-HL8040F 400 had significantly advanced softening performance. Thanks to the combination of the UF membrane and NF membrane, membrane fouling was effectively inhibited, and drug consumption was within an acceptable range. The operation costs of these three NF membranes were 0.165, 0.179, and 0.171 USD per ton of produced water, respectively. The results showed that the UF + NF process is an ideal technology for advanced treatment in water plants.
The nitrate pollution of groundwater can cause serious harm to human health. Biochar electrodes, combined with adsorption and electroreduction, have great potential in nitrate removal from groundwater. In this study, bamboo chopsticks were used as feedstocks for biochar preparation. The bamboo chopstick biochar (BCBC), prepared by pyrolysis at 600 °C for 2 h, had a specific surface area of 179.2 m2/g and an electrical conductivity of 8869.2 μS/cm, which was an ideal biochar electrode material. The maximum nitrate adsorption capacity of BCBC-600-2 reached 16.39 mg/g. With an applied voltage of 4 V and hydraulic retention time of 4 h, the nitrate removal efficiency (NRE) reached 75.8%. In comparison, the NRE was only 32.9% without voltage and 25.7% with graphite cathode. Meanwhile, the average nitrate removal rate of biochar electrode was also higher than that of graphite cathode under the same conditions. Therefore, biochar electrode can provide full play to the coupling effect of adsorption and electroreduction processes and obtain more powerful nitrate removal ability. Moreover, the biochar electrode could inhibit the accumulation of nitrite and improve the selectivity of electrochemical reduction. This study not only provides a high-quality biochar electrode material, but also provides a new idea for nitrate removal in groundwater.
Preferential solute transport is a common phenomenon in soil, and it is of great significance to accurately describe the mechanism of pollutant transport and water and soil environmental governance. However, the description of preferential solutes still relies on applying solute breakthrough curves for model parameters fitting. At present, most of the solute breakthrough curves are obtained indoors, and with some limitations. Therefore, this study established a method for securing solute breakthrough curves based on the electrical resistivity method. The research results show that the change in soil concentration during the tracer infiltration process can be captured by establishing the fitting relationship between soil resistivity and solute concentration. Then the solute breakthrough curve can be found. Through a time moment analysis, the difference between the breakthrough curve parameters obtained by the traditional method and the resistivity method is slight; the average error is less than 10%. On this basis, the sensitive response of the parameters of the “mobile–immobile” model to concentration was elucidated through different concentration tracer experiments, among which β and D are more sensitive, and w is less sensitive. The suitable tracer concentration range should be 50–120 mg/L. Therefore, the established method could obtain the breakthrough curves and describe the transport of preferential solutes at the field scale.
Submerged plants are common bioindicators of heavy metal contamination in aquatic ecosystems. Traditional research often focused on the overall metal content within plants or their tissues, and overlooked the role of epiphytic biofilms, which may affect the accuracy of bioindicators’ function. This study conducted cadmium (Cd) exposure experiments on Vallisneria natans L. (V. natans) to investigate the Cd accumulation in the plant tissues and their associated epiphytic biofilms. It was observed that phyllosphere and rhizosphere biofilms accounted for 27.3–60.6% and 31.3–41.7% of the total Cd in the leaf and root areas, respectively. The phyllosphere biofilm rapidly accumulated Cd directly from the water column, showing a strong correlation with aqueous Cd levels, whereas Cd in leaf tissue was primarily root-derived. Microbial analysis revealed that Proteobacteria dominated the biofilm communities, and the relative abundance of specific genera (e.g., Nitrospira) correlated with Cd exposure. Our findings underscore a critical refinement for bioindication: distinguishing metal accumulation in epiphytic biofilms from that in plant tissues significantly enhances source attribution: phyllosphere biofilms reflect water pollution, while rhizosphere biofilms indicate sediment–root interface contamination. This refined approach provides a pathway toward more precise environmental monitoring, contributing to sustainable water quality management by enabling earlier detection of pollution and informing targeted remediation efforts to protect aquatic ecosystem health.