Tanzania has a high rural population, of which many rely on off-grid diesel generators to produce electricity. The focus of this paper is to assess if the waste biomass residues in Tanzania have sufficient energy potential to produce renewable electrical energy for small-scale electricity generation using off-grid diesel generators coupled with anaerobic digestion (AD) and/or gasification. The gaseous fuel produced can then be used to substitute diesel fuel used in small-scale dual fuel diesel gen-sets; thus, providing more affordable electricity whilst reducing dependency on fossil fuels. The biomass waste streams estimated are those arising from agriculture, forestry, livestock, and urban human waste. To answer this question, the energy potentials of each of these biomass waste streams are quantified, followed by further calculations to determine the electricity generation capacity per stream based on overall efficiencies of 10 and 25%. The results show that combined these waste streams have an energy potential of 385 PJ (for the base year of 2018) generated from 26,924 kilotonnes (kt). Collectively, these residues can produce at least 1.2 times the electricity generated nationally in 2018 using AD and gasification coupled with a diesel gen-set engine.

The integration of hydrothermal carbonisation (HTC) and anaerobic digestion (AD) can overcome some of the disadvantages of thermal or biological processing alone. This study aims to investigate integrated HTC-AD across a range of integration strategies and HTC processing temperatures (150 °C, 200 °C and 250 °C) to improve the energy conversion efficiency (ECE) of grass, compared to AD alone. The separation of hydrochars (HCs) for combustion and process waters (PWs) for digestion appears to be the most energetically feasible HTC-AD integration strategy, compared to HC or HTC-slurry AD. Hydrochars represent the greater energy carrier with between 81–85% of total energy output. The ECE of grass was improved from 51% to 97% (150 °C), 83% (200 °C) and 68% (250 °C) through integrated HTC-AD. Therefore, lower HTC processing temperatures yield more favourable energetics. However, higher HTC temperatures favour more desirable HC properties as a combustion fuel. The hydrochar produced at 250 °C (HC-250) displayed the highest HHV (25.8 MJ/kg) and fixed carbon: volatile matter ratio (0.47), as well as the greatest reduction in slagging and fouling potential (ash flow temperature > 1550 °C). Overall, integrated HTC-AD is an effective energy valorisation strategy for grass. A compromise exists between the quality of hydrochar and the energetic balance. However, at 250 °C the process remains energetically feasible (EROI = 2.63).

The presence of inorganic salts either as part of the substrate or added to the reaction medium are known to significantly affect the reaction pathways during hydrothermal carbonisation (HTC) of biomass. This work aims to understand the influence of salts on hydrothermal carbonisation by processing cellulose in the presence of one or more inorganic salts with different valency. Batch experiments and Differential Scanning Calorimetry were used to investigate the change in reaction pathways during hydrothermal conversion. The effect of salts on the rate of HTC of cellulose can be correlated with the Lewis acidity of the cation and the basicity of the anion. The effect of the anion was more pH-dependent than the cation because it can protonate during the HTC process as organic acids are produced. The introduction of salts with Lewis acidity increases the concentration of low molecular weight compounds in the process water. The addition of a second salt can influence the catalytic effect of the first salt resulting in greater levulinic acid yields at the expense of hydrochar formation. Salts also play an important role in cellulose dissolution and can be used to modify the yield and composition of the hydrochars.

Hydrothermal carbonisation (HTC) can be integrated with anaerobic digestion (AD) for the treatment of digestate, resulting in a solid hydrochar or bio-coal and a process water, which can be recirculated back into AD to produce biogas. The properties of digestate-derived hydrochars do not lend themselves to producing high quality bio-coal and blending with lignocellulosic feedstocks can improve its properties. This study investigates the co-processing of sewage sludge (SS) digestate with three lignocellulosic biomass (grass, privet hedge, and woodchip). The calorific value of the resulting bio-coal is increased following co-processing, although feedstock interactions result in non-additive behaviour. The largest increase in calorific value was observed for co-processing with woodchip. There is evidence for non-additive partitioning of metals during co-processing resulting in only moderate improvements in ash chemistry during combustion. Co-processing also effects the composition of process waters, influencing the potential for biogas production. Experimental biomethane potential (BMP) tests indicate that grass clippings are the most suitable co-feedstock for maintaining both calorific value and biogas production. However, above 200 °C, BMP yields appear to decrease, suggesting the process water may become more inhibitory. Co-processing with wood waste and privet hedge produce the higher CV bio-coal but significantly reduced BMP.

Characterisation of 27 types of biomass was performed together with an assessment of regional resource availability. Charcoal was produced under two conditions from all samples and their yields were compared. Sugarcane bagasse, sal and pine produced the best charcoal with a low volatile matter and high calorific value. The amount of high-quality charcoal which can be made within Nepal from the biomass types tested is equivalent to 8,073,000 tonnes of firewood a year or 51% of the yearly demand. The areas which would benefit the most from charcoal making facilities are the Mid-hills of the Western, Central and Eastern Development Regions, as well as the Terai in the Central and Eastern Development Regions. The main potential benefit is to convert agricultural residues which are underutilised because, in their original form, produce large quantities of smoke, to cleaner burning charcoal. The conversion of agricultural residues to charcoal is also a viable alternative to anaerobic digestion in the Mid-hills.

This study assesses the bioenergy potential of two types of aquatic biomass found in the Republic of Congo: the green macroalgae Ulva lactuca (UL) and Ledermanniella schlechteri (LS). Their combustion behaviour was assessed using elemental and biochemical analysis, TGA, bomb calorimetry and metal analysis. Their anaerobic digestion behaviour was determined using biochemical methane potential (BMP) tests. The average HHV for LS is 14.1 MJ kg⁻¹, whereas UL is lower (10.5 MJ kg⁻¹). Both biomasses have high ash contents and would be problematic during thermal conversion due to unfavourable ash behaviour. Biochemical analysis indicated high levels of carbohydrate and protein and low levels of lipids and lignin. Although the lipid profile is desirable for biodiesel production, the levels are too low for feasible extraction. High levels of carbohydrates and protein make both biomasses suitable for anaerobic digestion. BMP tests showed that LS and UL have an average of 262 and 161 mL CH₄ gVS⁻¹, respectively. The biodegradability (BI) of LS and UL had an average value of 76.5% and 43.5%, respectively. The analysis indicated that these aquatic biomasses are unsuitable for thermal conversion and lipid extraction; however, conversion through anaerobic digestion is promising.